ECO lexus LS400 1994 Electrical Components / 1994 LS400: BODY

BODY
238Check the condition of your vehicle’s paint and trim. If you
find any chips or scratches in the paint, touch them up
immediately to prevent corrosion from starting. If the chips or
scratches have gone through the bare metal, have a qualified
body shop make the repair.
Check the interior of your vehicle. Water and dirt can
accumulate under the floor mats and could cause corrosion.
Occasionally check under the mats to make sure the area is
dry. Be particularly careful when transporting chemicals,
cleansers, fertilizers, salt, etc. These should be transported in
proper containers. If a spill or leak should occur, immediately
clean and dry the area.
Do not park your vehicle in a damp, poorly ventilated
garage. If you wash your vehicle in the garage, or if you drive
it in covered with water or snow, your garage may be so damp
it will cause corrosion. Even if your garage is heated, a wet
vehicle can corrode if the ventilation is poor.
WASHING AND WAXING
Wash your vehicle in the shade when the body is not hot
to the touch. Use a mild car-wash soap and rinse it well.
Dirt can cause small scratches in the paint and the chemicals
in some dirt and air pollutants can cause deterioration of the
paint and trim. Therefore, frequent washing is recommended.
If you park or drive your Lexus near the ocean or on salted
roads, it is especially important to prevent corrosion.
Automatic car washes use a wide variety of equipment for both
cleaning your car and applying waxes and sealants. Certain
types of brushes used, as well as the overall washing
procedure itself, can scratch the paint’s surface. Damage will
be more apparent on darker colors. Before using an automatic
car wash, be sure to review with the car wash management the
type of equipment and washing process used to ensure that
they will not adversely affect your vehicle’s paint finish.
The following is the proper procedure for car washing by hand.
1. Begin by rinsing all loose dirt off the vehicle with a hose. If
the underside has picked up mud or road salt, use a hard,
direct stream from a hose to remove it.
2. Wash with a commercial car-wash product available at your
Lexus dealer or auto parts store. Follow the manufacturer’s
mixing instructions carefully. Dip your sponge or cloth into the
wash bucket frequently and do not rub too hard − let the soap
and water remove the dirt.
To clean aluminum wheels, use only a mild soap or neutral
detergent.

BODY
239 On urethane bumpers and side moldings, remove dirt carefully
and do not scrub with abrasive cleaners. The bumper and
molding faces are soft.
Road tar may be removed with turpentine. Use warm water
and car-wash soap for insects and tree sap. Commercial
products are also available.
NOTICE:
Do not use gasoline or strong solvents, which may be
toxic or cause damage.
3. Rinse the vehicle thoroughly. If any soap dries on the
vehicle, it may cause streaking. In hot weather, you may have
to rinse each section of the vehicle right after you wash it.
4. Dry the vehicle with a moist chamois or soft towel. The main
purpose of drying is to remove excess water so that the vehicle
will air dry without water spots. So do not rub or press hard,
which might scratch the paint.
If you detect any stone chips or scratches in the paint, touch
them up immediately to protect the bare metal from corrosion.
After washing your vehicle, make sure the brakes are fully dry
before driving.
Polishing and waxing is recommended to maintain the
original beauty of your Lexus’ finish.
1. Always wash and dry the vehicle before you begin waxing,
even if you are using a combined cleaner and wax.2. Use a good quality polish and wax. If the finish has become
extremely weathered, use a car-cleaning polish, followed by a
separate wax. Carefully follow the manufacturer’s instructions
and precautions. Be sure to polish and wax the chrome trim as
well as the paint.
3. Wax the vehicle again when water does not bead but
remains on the surface in large patches.CLEANING THE INTERIOR
Leather Interior
Remove dirt using a soft cloth dampened with 5 % solution of
neutral detergent for wool. Then thoroughly wipe off all traces
of detergent with a clean damp cloth.
After cleaning or whenever any part of the leather gets wet, dry
with a soft clean cloth. Allow the leather to dry in a ventilated
shaded area.
NOTICE:

Never use organic substances such as benzine,
alcohol or gasoline, or alkaline or acid solutions for
cleaning the leather as these could cause discoloring.

Use of a nylon brush or synthetic fiber cloth, etc. may
scratch the fine grained surface of the leather.

Mildew may develop on soiled leather upholstery. Be
especially careful to avoid oil spots. Try to keep your
upholstery always clean.