belt lexus LS400 1995 Air Conditioning and Audio / 1995 LS400: COMFORT ADJUSTMENT
[x] Cancel search | Manufacturer: LEXUS, Model Year: 1995, Model line: LS400, Model: Lexus LS400 1995Pages: 34, PDF Size: 3.93 MB
Page 1 of 34
SECTION 1 – 6
53
INSTRUMENTS AND CONTROLS
Comfort adjustment
Front seats54 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Head restraints57 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Tilt and telescopic steering wheel59 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Outside rear view mirrors60 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inside rear view mirror62 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Seat belts62 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SRS airbags 69. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Child restraint76 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Driving position memory system85 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Page 3 of 34
COMFORT ADJUSTMENT
55
Adjusting seat position
Move the control switch in the desired direction.
Releasing the switch will stop the seat in that position. Do not
place anything under the seat. It might interfere with the seat
movement.
Adjusting seatback angle
Move the control switch in the desired direction.
Releasing the switch will stop the seatback in that position.
CAUTION
To reduce the risk of sliding under the lap belt during a
collision, avoid reclining the seatback any more than
needed. The seat belts provide maximum protection
when the driver and the passenger are sitting up
straight and well back in the seats. If you are reclined,
the lap belt may slide past your hips and apply restraint
forces directly to the abdomen. Therefore, in the event
of a frontal collision, the risk of personal injury may
increase with increasing recline of the seatback.
Page 10 of 34
COMFORT ADJUSTMENT
62
INSIDE REAR VIEW MIRROR
Pushing the switch changes the mode between “AUTO”
and “DAY”.
The indicator comes on when the “AUTO” mode is selected.
“DAY” mode: The mirror surface is normal.
“AUTO” mode: If the mirror detects light from the
headlights of the vehicle behind you, the mirror surface
darkens slightly to reduce the reflected light.
When the inside rear view mirror surface changes, the outside
rear view mirror surfaces will also become darker.
When the ignition key is inserted and turned on, the inside rear
view mirror always turns on in the “AUTO” mode.
Adjust it before driving so that the rear view is the best.
When the outside air temperature is low, it may take a little
longer for the mirror to darken in response to the detection of
headlights.
SEAT BELTS
Seat belt precautions
Lexus recommends that the driver and passengers in the
vehicle be properly restrained at all times with the seat belts
provided. Failure to do so could increase the chance of injury
and / or the severity of injury in accidents.
Baby or small child. Use a child restraint system which fits
your vehicle. See “Child restraint” for details.
Child. If a child is too large for a child restraint system, the child
should sit in the rear seat and must be restrained using the
vehicle’s seat belts. According to accident statistics, the child
is safer when properly restrained in the rear seat than in the
front seat. Do not allow the child to stand up or kneel both on
rear and front seats. If the shoulder belt falls across the child’s
neck or face, have the child sit slightly closer to the buckle so
that the belt lays across the shoulder.
Pregnant woman. Lexus recommends the use of a seat belt.
Ask your doctor for specific recommendations. The lap belt
should be worn securely and as low as possible over the hips
and not on the waist.
Injured person. Lexus recommends the use of a seat belt.
Depending on the injury, however, first check with your doctor.
Page 11 of 34
COMFORT ADJUSTMENT
63
CAUTION
Persons should ride in their seats properly wearing
their seat belts whenever the vehicle is moving.
Otherwise, they are much more likely to suffer serious
bodily injury in the event of sudden braking or a
collision.
When using the seat belts, observe the following:
Use the belt for only one person at a time. Do not use
a single belt for two or more people − even children.
Avoid reclining the seatbacks too much. The seat
belts provide maximum protection when the
seatbacks are in the upright position. (See
“Adjusting seatback angle”.)
Be careful not to damage the belt webbing or
hardware. Take care that they do not get caught or
pinched in the seat or doors.
Inspect the belt system periodically. Check for cuts,
fraying, and loose parts. Damaged parts should be
replaced. Do not disassemble or modify the system.
Keep the belts clean and dry. If they need cleaning,
use a mild soap solution or lukewarm water. Never
use bleach, dye, or abrasive cleaners − they may
severely weaken the belts.
Replace the belt assembly (including bolts) if it has
been used in a severe impact. The entire assembly
should be replaced even if damage is not obvious.
Front seat belt buckle illumination
Opening the driver’s door lights up the driver’s seat belt
buckle for easy use. The same applies for the front
passenger’s door and seat belt buckle.
The light remains on for 15 seconds after the door is closed,
but goes off immediately when all doors are locked.
Page 12 of 34
COMFORT ADJUSTMENT
64
Fastening front and reat seat belts
Adjust the seat as needed and sit up straight and well back
in the seat. To fasten your belt, pull it out of the retractor
and insert the tab into the buckle.
You will hear a click when the tab locks into the buckle.
The seat belt length automatically adjusts to your size and the
seat position.
The retractor will lock the belt during a sudden stop or on
impact. It also may lock if you lean forward too quickly. A slow,
easy motion will allow the belt to extend, and you can move
around freely.When a passenger’s shoulder belt is completely extended and
is then retracted even slightly, the belt is locked in that position
and cannot be extended. This feature is used to hold the child
restraint system securely. (For details, see “Child restraint” on
page 76.) To free the belt again, fully retract the belt and then
pull the belt out once more.
If the seat belt cannot be pulled out of the retractor, firmly pull
the belt and release it. You will then be able to smoothly pull the
belt out of the retractor.
CAUTION
After inserting the tab, make sure the tab and buckle are
locked and that the belt is not twisted.
Page 13 of 34
COMFORT ADJUSTMENT
65
Adjust the position of the lap and shoulder belts.
1
Position the lap belt as low as possible on your hips − not
on your waist.
2
Adjust it to a snug fit by pulling the shoulder portion
upward through the latch plate.
CAUTION
High−positioned lap belts and loose−fitting belts
both could increase the chance of injury due to
sliding under the lap belt during an accident.
For your safety, do not place the shoulder belt under
your arm.
Front seat belts only
Adjust the shoulder anchor position to your size.
Manual type: To raise the anchor position, push the anchor up
To lower the anchor position, support the anchor while you
push the lock release button then slide the anchor down. After
adjustment, make sure the anchor is locked in position.
CAUTION
Always be sure that the belt is positioned across your
shoulder, as close to your neck as possible; not on your
upper arm or on your neck. Failure to do so could
reduce the amount of protection in an accident and
increase the chance of injury.
Page 14 of 34
COMFORT ADJUSTMENT
66
Front seat belts only
Power type: To adjust the shoulder anchor position, press the
upper or lower part of the control switch located on the door.
When the switch is released, the shoulder anchor will stop at
that position.
CAUTION
Always be sure that the belt is positioned across your
shoulder, as close to your neck as possible; not on your
upper arm or on your neck. Failure to do so could
reduce the amount of protection in an accident and
increase the chance of injury.
To release the belt, press the buckle release button and
allow the belt to retract.
If the belt does not retract smoothly, pull it out and check for
kinks or twists. Then make sure it remains untwisted as it
retracts.
Page 15 of 34
COMFORT ADJUSTMENT
67
Seat belt extender
If the front or rear outside seat belts cannot be fastened
securely because it is not long enough, a personalized seat
belt extender is available from your Lexus dealer free of
charge.
Please contact your local Lexus dealer so that the dealer can
order the proper required length for the extender. Bring the
heaviest coat you expect to wear for proper measurement and
selection of length. Additional ordering information is available
at your Lexus dealer.
CAUTION
When using the seat belt extender, observe the
following. Failure to follow these instructions could
result in less effectiveness of the seat belt restraint
system in case of vehicle accident, increasing the
chance of personal injury.
Never use the seat belt extender if you can fasten the
seat belt without it.
Remember that the extender provided for you may
not be safe when used on a different vehicle, or for
another person or at a different seating position than
the one originally intended for.
To connect the extender to the seat belt, insert the tab into
the seat belt buckle so that the “PRESS” signs on the
buckle release buttons of the extender and the seat belt
are both facing outward as shown.
You will hear a click when the tab locks into the buckle.
When releasing the seat belt, press on the buckle release
button on the extender, not on the seat belt. This helps prevent
damage to the vehicle interior and extender itself.
When not in use, remove the extender and stoic in the vehicle
for future use.
CAUTION
After inserting the tab, make sure the tab and buckle are
locked and that the belt is not twisted.
Page 16 of 34
COMFORT ADJUSTMENT
68
Front seat belt pretensioners
The driver and front passenger’s seat belts are equipped
with a pretensioner which is designed to be activated in
response to a severe frontal impact.
The airbag system and each pretensioner operates
independently because each has its own separate sensor.
A pretensioner sensor is located in each front seat belt
retractor assembly. When the pretensioner sensor detects the
shock of a severe frontal impact, the front seat belt is quickly
drawn back in by the retractor so that the belt snugly restrains
the front seat occupant.
When a seat belt pretensioner is activated, an operating noise
may be heard and a small amount of smoke−like gas may be
released. This gas is harmless and does not indicate that a fire
is occurring.
Once the seat belt pretensioner has been activated, the seat
belt retractor remains locked.CAUTION
Do not modify, remove or strike the front seat belt
retractor assemblies or surrounding area. Doing any of
these may cause sudden operation of the front seat belt
pretensioners or disable the system, which could result
in personal injury.
Failure to follow these instructions can result in severe
injuries.
Page 17 of 34
COMFORT ADJUSTMENT
69
NOTICE
Do not perform any of the following changes without
consulting your Lexus dealer. Such changes can
interfere with proper operation of the seat belt
pretensioners in some cases.
Repairs on or near the front seat belt retractor
assemblies.
Modification of the suspension system.
Modification of the front end structure.
Attachment of a grille guard (bull bar, kangaroo bar,
etc.), snowplow, winches or any other equipment to
the front end.
In the following case, contact your Lexus dealer as soon as
possible:
If either front seat belt does not retract or cannot be pulled
out due to a malfunction or activation of the pretensioner.
The front seat belt retractor assembly or surrounding area
has been damaged.
SRS AIRBAGS
The SRS (Supplemental Restraint System) airbags are
designed to provide further protection to the driver and
front passenger when added to the primary protection
provided by the seat belts.
In response to a severe frontal impact, the SRS airbags
work together with the seat belts to prevent or reduce
injury by inflating, in order to decrease the likelihood of
the driver’s or front passenger’s head or face directly
hitting the steering wheel or dashboard.
The passenger airbag is activated even with no passenger in
the front seat.