lock lexus LS400 1996 Engine / 1996 LS400: IN CASE OF AN EMERGENCY

159
SECTION 4
IN CASE OF AN EMERGENCY
If your engine stalls while driving 160
If your vehicle will not start 160
If your vehicle overheats 163
If you have a flat tire 164
If your vehicle needs to be towed 170
If you cannot shift automatic transmission
selector lever 175
If you lose your keys or lock yourself out 176

IN CASE OF AN EMERGENCY
166
To remove the spare tire:

Remove the spare tire cover.
Loosen the bolt and remove it.
When storing the spare tire, place it with the inner side of the
wheel facing up. Then bolt the tire in place and install the
spare tire cover to prevent the tire from flying forward during
a collision or sudden braking.2. Block the wheel diagonally opposite the flat tire to
keep the vehicle from rolling when it is jacked up.
When blocking a wheel, place a wheel block in front of the
front wheels or behind the rear wheels.
Paper for protecting surface
3. Remove the wheel ornament.

IN CASE OF AN EMERGENCY
167 Pry off the wheel ornament, using the screwdriver as shown.
CAUTION!
Do not try to pull off the ornament by hand. Take due
care in handling the ornament to avoid unexpected
personal injury.
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before raising the vehicle.
Turn the nuts counterclockwise to loosen them. To get
maximum leverage, fit the wrench to the nut so that the
handle is on the right side, as shown above. Grab the wrench
near the end of the handle and pull up on the handle. Be
careful that the wrench does not slip off the nut.
Do not remove the nuts yet ± just unscrew them about
one±half turn.
5. Position the jack at the jack points as shown.
Make sure the jack is positioned on a level and solid surface.
6. After making sure no one is in the vehicle, raise it
high enough so that the spare tire can be installed.
Allow for the fact that you need more ground clearance when
putting on the spare tire than when removing the flat tire.

IN CASE OF AN EMERGENCY
168To raise the vehicle, insert the jack handle into the jack (it is
a loose fit) and turn it clockwise. As the jack touches the
vehicle and begins to lift, double±check that it is properly
positioned.
CAUTION!
Never get under the vehicle when it is supported by
the jack alone.
7. Remove the wheel nuts and remove the flat tire.
Lift the flat tire straight off and put it aside.
Before putting on the wheel, remove any corrosion on the
mounting surfaces with a wire brush or such. Installation of
wheels without good metal±to±metal contact at the
mounting surface can cause wheel nuts to loosen and
eventually cause a wheel to come off while driving.
8. Reinstall all the wheel nuts finger tight.

IN CASE OF AN EMERGENCY
169 Align the holes in the wheel with the bolts. Then lift up the
wheel and get at least the top bolt started through its hole.
Wiggle the tire and press it back over the other bolts.
Reinstall the wheel nuts and tighten them as much as you
can by hand. Press the tire back and see if you can tighten
them more.
9. Lower the vehicle completely and tighten the wheel
nuts.
Turn the jack handle counterclockwise to lower the vehicle.
Use only the wheel nut wrench to tighten the nuts. Do not use
other tools or any additional leverage other than your hands,
such as a hammer, pipe or your foot. Make sure the wrench
is securely engaged over the nut.
Tighten each nut a little at a time in the order shown. Repeat
the process until all the nuts are tight.
CAUTION!
As soon as possible after changing wheels, have the
wheel nuts tightened by torque wrench at 103 N´m
(10.5 kgf´m, 76 ft´lbf.).
10. Reinstall the wheel ornament.
Put the wheel ornament into position and then tap it firmly
with the side or heel of your hand to snap it into place.
CAUTION!
Take due care in handling the ornament to avoid
unexpected personal injury.
11. After changing the wheel, check the air pressure of
the replaced tire. Stow all the tools, jack and flat tire
securely.

IN CASE OF AN EMERGENCY
173 2. Towing with wheel lift type truck
From front
Use a towing dolly under the rear wheels.
NOTICE
Never tow a vehicle with an automatic transmission
from the front with rear wheels on the ground, as this
may cause serious damage to the transmission.
From rear
Place the ignition key in the ªACCº position.
NOTICE
Do not tow with the key removed or in the ªLOCKº
position, as the steering lock mechanism is not
strong enough to hold the front wheels straight.

IN CASE OF AN EMERGENCY
175
IF YOU CANNOT SHIFT
AUTOMATIC TRANSMISSION
SELECTOR LEVER
If you cannot shift the selector lever, use the shift lock
override button as follows:

Turn the ignition key to ªLOCKº or ªACCº. Make sure the
parking brake is applied. Pry up the cover with a
flat±bladed screwdriver or equivalent.
Insert your finger, the screwdriver or equivalent into the
hole to push down the shift lock override button. You can
shift the selector lever while pushing the button.
For your safety, keep the brake pedal depressed.
Be sure to have the system checked by your Lexus dealer
as soon as possible.

IN CASE OF AN EMERGENCY
176
IF YOU LOSE YOUR KEYS OR LOCK
YOURSELF OUT
If you need a replacement key, contact your Lexus
dealer.
See the suggestion given in ªKeysº on page 8.
If your keys are locked in the vehicle and you cannot get a
duplicate, many Lexus dealers can assist you. If you must
break a window to get in, we suggest breaking the smallest
side window because it is the least expensive to replace. Be
extremely cautious to avoid cuts from the glass.