turn signal lexus LS400 1996 Engine / 1996 LS400: SWITCHES
[x] Cancel search | Manufacturer: LEXUS, Model Year: 1996, Model line: LS400, Model: Lexus LS400 1996Pages: 10, PDF Size: 0.11 MB
Page 1 of 10

15
SECTION 1 ± 2
INSTRUMENTS AND CONTROLS
Switches
Headlight switch 16
Headlight dimmer and turn signal switch 17
Fog light switch 18
Windshield wiper and washer switch 19
Headlight cleaner switch 20
Rear window and outside rear view mirror
defogger switch 20
Power window switches 21
Emergency flasher switch 24
Seat heater switches 24
Page 3 of 10

SWITCHES
17 Daytime Running Light System (Canada only)
The headlights turn on when the parking brake is released
with the engine started, even with the light switch in the
ªOFFº position. They will not go off until the ignition switch
is turned off.
To turn on the other exterior lights and instrument panel
lights, twist the knob to the first clickstop.
Under the daytime running light system, the headlights turn
on at reduced intensity. Twist the knob to the second
clickstop to turn to full intensity for driving at night.
When setting the knob to the third clickstop (ªAUTOº), the
headlights will automatically adjust to full intensity and/or
turn on the other lights depending on the darkness of the
surroundings. Likewise, as the surroundings become
brighter, the headlights will turn to reduced intensity,
ultimately turning off the other lights.
NOTICE
To prevent the battery from being discharged, do not
leave the lights on longer than necessary when the
engine is not running.
HEADLIGHT DIMMER AND TURN
SIGNAL SWITCH
For high beam, push the lever forward. Pull it back for
low beam. For the headlight flasher, pull it further back.
A blue light in the instrument cluster indicates high beam or
headlight flasher is on.
The headlight flasher works even when the headlight switch
is off.
Page 4 of 10

SWITCHES
18
For signaling turns, move the lever up or down in the
conventional manner.
The ignition key must be in the ªONº position.
The turn signal is self±cancelling after a turn, but after a lane
change, you may have to cancel it by hand. You can also
signal a lane change by moving the turn signal lever partway
and holding it there. If the green light in the instrument cluster
flashes faster than normal, it indicates that the front or rear
turn signal bulb has burned out. If this indicator light does not
come on, the fuse or the indicator light itself has probably
failed.
FOG LIGHT SWITCH
To turn on the fog lights, turn the switch to the ªONº
position. The fog lights come on only when the
headlights are on low beam.
Page 10 of 10

SWITCHES
24
EMERGENCY FLASHER SWITCH
To turn on the emergency flashers, push the switch.
All the turn signal lights will flash. The emergency flashers
will work with the engine running or off and with or without the
ignition key.
Turn on the emergency flashers to warn other drivers if you
must stop your vehicle where it might be a traffic hazard.
Always pull your vehicle as far off the road as possible.
The turn signal light switch will not work when the emergency
flashers are in operation.
NOTICE
To prevent the battery from being discharged, do not
leave the switch on longer than necessary when the
engine is not running.
SEAT HEATER SWITCHES
The seat heater has two switches one marked ªLº (for
the left seat) and the other marked ªRº (for the right
seat). Push these switches to turn the respective seat
heater on, and push the switches again to turn them off.
The ignition key must be in the ªONº position.
NOTICE
To prevent the battery from being discharged, turn
the switches on only when the engine is running.