lexus LS400 1996 Gauges, Meters and Service Reminders / 1996 LS400: DRIVING POSITION MEMORY SYSTEM

COMFORT ADJUSTMENT
87
DRIVING POSITION MEMORY
SYSTEM
The micro computer can memorize the position of the
driver's seat, the height of the shoulder belt anchor of the
driver's seat belt, and the positions of the tilt and telescopic
steering, and outside rear view mirrors. Two different driving
position profiles can be entered into the computer's memory.
Recording a driving position in the computer's memory can
only be done when the ignition key is in the ªONº position and
the shift lever is in the ªPº position.
Setting a driving position
1. Adjust the driver's seat, driver's shoulder belt
anchor, tilt and telescopic steering and outside rear
view mirrors to the desired position.
2. While pushing the ªSETº button, push button ª1º or
ª2º until the signal beeps.
The beep sound means that the positions are recorded in the
computer 's memory.
By repeating these two steps and pressing the remaining
button, the driving position for another driver can be
recorded.
To set a new memorized position, select the desired position
and perform step 2. The previous memory will be erased and
the new position will be set.
To make only slight changes to an already memorized
position, the easiest way is to first activate the memorized
position, then make the desired changes and perform step
2 above.

COMFORT ADJUSTMENT
88
Activating a memorized position
When you push button ª1º or ª2º, the driving position
will be automatically adjusted to the position recorded
for that button.
Conditions for memorized position activation

Ignition key ªONº and shift lever in ªPº position
All parts of the memorized positions can be activated.
However, if the brake pedal is being depressed, the seat
position will not change.

Key not in ignition switch and within 30 seconds of opening
driver's door.
The memorized position can be activated, except for the
tilt and telescopic steering. This will be activated when the
key is inserted into the ignition switch.
If any driving position memory switch is pushed while one of
the memorized driving profiles is being activated, the
operation will stop.To activate the system, push the desired button (ª1º or ª2º)
again.
The driving position memory control system cannot be
operated while the vehicle is moving.
If the vehicle's battery is disconnected, the computer's
memory will be erased and the memorized positions will
have to be set again.
CAUTION!


Do not start the vehicle while the adjustments are
being made.

Take care not to select the wrong button, or the seat
could strike the rear passenger or hit your body
against the steering wheel. If this happens, you can
stop the movement by pressing another driving
position memory switch, or depressing the brake
pedal.