hood open lexus LS400 2000 Engine / LEXUS 2000 LS400 OWNER'S MANUAL (OM50533U)

EXTERIOR EQUIPMENT
109
HOOD
15L001
1. To open the hood, pull the hood lock release lever
under the instrument panel. The hood will spring up
slightly.

EXTERIOR EQUIPMENT
11 0
15L002-4
2. Insert your fingers under the hood, push up the
auxiliary catch lever and lift the hood.
Before closing the hood, check to see that you have not
forgotten any tools, rags, etc. Then lower the hood and
make sure it locks.
CAUTION
Before driving, be sure that the hood is securely locked.
Otherwise, the hood may open unexpectedly while
driving and an accident may occur.

THEFT DETERRENT
217
Setting the system
1. Turn the ignition key to the ºLOCKº position and
remove it.
The indicator light flashes by means of the engine
immobiliser system.
2. Close and lock all the doors, trunk and hood
using an ignition key or wireless remote control.If you lock them with wireless remote control, the turn
signals flash once.*NOTE: *The turn signals can be set not to flash. Ask
your Lexus dealer for details.
The flashing indicator light will change to stay on when
all the doors, trunk and hood are closed and locked.
3. After 30 seconds, the indicator flashes and the
system is set.
Cancelling the system
When you unlock any door or trunk using an ignition
key or wireless remote control, the system is
cancelled.
If you unlock any door or trunk with wireless remote
control, the turn signals flash twice.*
NOTE: *The turn signals can be set not to flash. Ask your Lexus dealer for details.
Activating the system
The alarm sounds for 60 seconds if any of the following
are operated:

Unlocking any door or trunk without using an ignition
key or wireless remote control.

Opening the hood forcibly.

Reconnecting the battery.

THEFT DETERRENT
218If any door is unlocked and the ignition key is not in the
ignition switch during the alarm sounding, its door is
automatically locked.
To stop the alarm:
Use either of the following methods.

Unlock the door or trunk using an ignition key or
wireless remote control.

Turn the ignition switch on.
Testing the system
1. Open all the windows.
2. Set the system as described above.
The front doors should be locked with the ignition key or
wireless remote control. Be sure to wait until the
indicator light starts flashing.
3. Unlock one of the doors from the inside.
The system should activate the alarm.
4. Unlock any of the doors with a key or the wireless
remote control to cancel the system.
5. Repeat this operation for the other doors and
hood.
When testing the hood, also check that the system is
activated when the battery terminal is disconnected and
then reconnected.
If the system does not work properly, have it checked by your Lexus dealer.
NOTICE
Disconnecting the battery may result in the
erasure of information you have set in thecomputer memory. After reconnecting thebattery, check that the memorized data has beenretained. If it has been erased, input it into thecomputer once more.