mirror LEXUS LS500 2022 User Guide

82
LS500_QG_U
■Programming a rolling code system
Two or more people may be necessary to complete rolling code programming.
1Locate the “Learn” or “Smart” button
on the garage door opener motor in
the garage.
This button can usually be found where
the hanging antenna wire is attached to
the unit. The name and color of the but-
ton may vary by ma nufacturer. Refer to
the owner’s manual supplied with the
garage door opener motor for details.
2Press and release the “Learn” or
“Smart” button.
Perform 3 within 30 seconds after
performing 2.
3Press and hold the desired HomeLink® button (inside the vehicle) for 2 seconds and
release it. Repeat this sequence (press/hold/release) up to 3 times to complete pro-
gramming.
If the garage door opener motor operates when the HomeLink® button is pressed, the
garage door opener moto r recognizes the HomeLink® signal.
 Vehicles with auto anti-glare inside rear view mirror

83
LS500_QG_U
Vehicles with Digital Rearview Mirror
■Enabling 2-way communication with a garage door (only available for compat-
ible devices)
When enabled, 2-way communication allows yo u to check the status of the opening and
closing of a garage door throug h indicators in your vehicle.
2-way communication is only av ailable if the garage door opener motor used is a compati-
ble device. (To check device compat ibility, refer to www.homelink.com.)
1Within 5 seconds after programming the garage door opener has been completed, if
the garage door opener motor is trained to HomeLink®, both garage door operation
indicators will flash rapidly (green) and the light on the garage door opener motor will
blink twice, indicating that 2- way communication is enabled.
If the indicators do not flash, perform 2 and 3 within the first 10 presses of the HomeLink®
button after programming has been completed.
2Press a programmed HomeLink® button to operate a garage door.
3Within 1 minute of pressing the HomeLink® button, after the garage door operation
has stopped, press th e “Learn” or “Smart” button on the garage door opener motor.
Within 5 seconds of the establishment of 2-way communication with the garage door
opener, both garage door oper ation indicators in the vehicle will flash rapidly (green)
and the light on the garage door opener motor will blink twice, indicating that 2-way
communication is enabled.
■Reprogramming a single HomeLink® button
When the following procedure is performed, buttons which already have devices registered
to them can be overwritten:
1Press and hold the desired HomeLink® button.
2When the HomeLink® indicator starts flashing orange, release the HomeLink® button
and perform “Programming HomeLink®” 1 (it takes 20 seconds for the HomeLink®
indicator to start flashing).
Press the appropriate HomeLink® button. The HomeLink® indicator light should turn on.
Operating HomeLink®

What to do if...
97
LS500_QG_U
See the “OWNER’S MANUAL”
Turn signal indicatorRCTA OFF indicator (if
equipped)
Headlight indicator (U.S.A.)RCD OFF indicator (if
equipped)
Tail light indicator (Canada)PKSB OFF indicator (if
equipped)
Headlight high beam indicator
(flashes)
Slip indicator
AHB indicatorVSC OFF indicator
PCS warning lightHigh mode indicator (if
equipped)
Cruise control indicatorSmart access system with
push-button start indicator
Dynamic radar cruise control
indicator(U.S.A.)Parking brake
indicator
Cruise control “SET” indicator(Canada)
*2LTA indicatorBrake hold standby indicator
BSM outside rear view mirror
indicators (if equipped)Brake hold operated indicator
BSM OFF indicator (if
equipped)Eco Driving Indicator Light
Intuitive parking assist OFF
indicator (if equipped)
Low outside temperature indi-
cator
For further information, refe r to the “OWNER’S MANUAL”.