fuel LEXUS LS600H 2017 Service Manual

4876-3. Do-it-yourself maintenance
6
Maintenance and care
LS600h/LS600hL_EE(OM50G20E)
Tire inflation pressure (P. 525)• Tire pressure gauge
• Compressed air source
Washer fluid ( P. 501)
• Water or washer fluid containing anti-
freeze (for winter use)
• Funnel (used only for adding water or
washer fluid)
CAUTION
The engine compartment contains many mechanisms and fluids that may move sud-
denly, become hot, or become electrically energized. To avoid death or serious
injury, observe the following precautions.
■When working on the engine compartment
●Make sure that the indicator on the power switch and the “READY” indicator are
both off.
●Keep hands, clothing and tools away from the moving fan and engine drive belt.
●Be careful not to touch the engine, power control unit, radiator, exhaust manifold,
etc. right after driving as they may be hot. Oil and other fluids may also be hot.
●Do not leave anything that may burn easily, such as paper and rags, in the engine
compartment.
●Do not smoke, cause sparks or expose an open flame to fuel. Fuel fumes are flam-
mable.
●Take care because brake fluid can harm your hands or eyes and damage painted
surfaces. If fluid gets on your hands or in your eyes, flush the affected area with
clean water immediately.
If you still experience disc omfort, consult a doctor.
■When working near the electric cooling fans or radiator grille
Be sure the power switch is off.
With the power switch in ON mode, the electric cooling fans may automatically
start to run if the air conditioning is on and/or the coolant temperature is high.
( P. 500)
■Safety glasses
Wear safety glasses to prevent flying or falling material, fluid spray, etc. from get-
ting in your eyes.
ItemsParts and tools

5256-3. Do-it-yourself maintenance
6
Maintenance and care
LS600h/LS600hL_EE(OM50G20E)
■Effects of incorrect tire inflation pressure
Driving with incorrect tire inflation pressure may result in the following:
●Reduced fuel economy
●Reduced driving comfort and poor handling
●Reduced tire life due to wear
●Reduced safety
●Damage to the drive train
If a tire needs frequent inflating, have it checked by any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
■Instructions for checking tire inflation pressure
When checking tire inflation pressure, observe the following:
●Check only when the tires are cold.
If your vehicle has been parked for at least 3 hours or has not been driven for more
than 1.5 km or 1 mile, you will get an accurate cold tire inflation pressure reading.
●Always use a tire pressure gauge.
It is difficult to judge if a tire is properly inflated based only on its appearance.
●It is normal for the tire inflation pressure to be higher after driving as heat is gener-
ated in the tire. Do not reduce tire inflation pressure after driving.
●Passengers and luggage weight should be placed so that the vehicle is balanced.
Tire inflation pressure
Make sure to maintain proper tire in flation pressure. Tire inflation pres-
sure should be checked at least once per month. However, Lexus rec-
ommends that tire inflation pr essure be checked once every two
weeks. ( P. 630)

5587-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
After taking the specified steps to correct the suspected problem, check
that the warning light goes off.
Follow the correction procedures.
Warning lightWarning light/DetailsCorrection procedure
Open door warning light
(warning buzzer)*1
Indicates that a door or the
trunk is not fully closed
Check that all the doors and
the trunk are closed.
In the fuel
gauge
Low fuel level warning light
Indicates remaining fuel is
approximately 13 L (3.4 gal.,
2.8 Imp. gal.) or less
Refuel the vehicle.
Seat belt reminder light (warn-
ing buzzer)*2
Warns the driver and/or front
passenger to fasten their seat
belts
Fasten the seat belt.
If the front passenger’s seat is
occupied, the front passen-
ger’s seat belt also needs to
be fastened to make the
warning light (warning
buzzer) turn off.
Master warning light
A buzzer sounds and the
warning light comes on and
flashes to indicate that the
master warning system has
detected a malfunction.
 P. 563

5607-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
■Front passenger detection sensor, seat belt reminder and warning buzzer
●If luggage is placed on the front passenger seat, the front passenger detection sen-
sor may cause the warning light to flash and the warning buzzer to sound even if a
passenger is not sitting in the seat.
●If a cushion is placed on the seat, the sensor may not detect a passenger, and the
warning light may not operate properly.
■Electric power steering system warning light (warning buzzer)
When the 12-volt battery charge becomes insufficient of the voltage temporarily
drops, the electric power steering system warning light may come on and the warn-
ing buzzer may sound.
■If the malfunction indicator lamp comes on while driving
The malfunction indicator lamp will come on if the fuel tank becomes completely
empty. If the fuel tank is empty, refuel the vehicle immediately. The malfunction indi-
cator lamp will go off after several trips.
If the malfunction indicator lamp does not go off, contact any authorized Lexus
dealer or repairer, or another duly qualified and equipped professional as soon as
possible.
■When the tire pressure warning light comes on
Carry out the following procedure after the tire temperature has lowered sufficiently.
●Check the tire inflation pressure and adjust it to the appropriate level.
●If the warning light does not go out after several minutes, check that the tire infla-
tion pressure is at the specified level and carry out initialization.
The warning light may come on again if the above operations are conducted without
first allowing the tire temperature to lower sufficiently.
■The tire pressure warning light may come on due to natural causes
The tire pressure warning light may come on due to natural causes such as natural
air leaks and tire inflation pressure changes caused by temperature. In this case,
adjusting the tire inflation pressure will turn off the warning light (after a few minutes).

5977-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
One of the following may be the cause of the problem:
●The electronic key may not be functioning properly. (P. 605)
●There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
●There may be a malfunction in the immobilizer system. ( P. 96)
●There may be a malfunction in the steering lock system.
●The hybrid system may be malfunctioning due to an electrical problem
such as electronic key battery depletion or a blown fuse. However,
depending on the type of malfunction, an interim measure is available
to start the hybrid system. ( P. 598)
One of the following may be the cause of the problem:
●The 12-volt battery may be discharged. ( P. 607)
●The 12-volt battery terminal connections may be loose or corroded.
If the hybrid system will not start
Reasons for the hybrid system not starting vary depending on the situa-
tion. Check the following and perf orm the appropriate procedure:
The hybrid system will not start even though the correct starting
procedure is being followed. ( P. 247)
The interior lights and headlights are dim, or the horn does not
sound or sounds at a low volume.

619
8Vehicle specifications
LS600h/LS600hL_EE(OM50G20E)
8-1. Specifications
Maintenance data
(fuel, oil level, etc.) .................. 620
Fuel information.......................... 632
8-2. Customization
Customizable features ............ 634

620
LS600h/LS600hL_EE(OM50G20E)
8-1. Specifications
Dimensions
*1: Unladen vehicles
*2: Vehicles without paddle shift switches
*3: Vehicles with paddle shift switches
Weights
*1: With relaxation seat
*2: Without relaxation seat
*3: 5-seat models with relaxation seat
*4: Except 5-seat models with relaxation seat
Maintenance data (fuel, oil level, etc.)
Dimensions and weights
Overall lengthLS600hL 5210 mm (205.1 in.)
LS600h 5090 mm (200.4 in.)
Overall width 1875 mm (73.8 in.)
Overall height*11480 mm (58.3 in.)*2
1470 mm (57.9 in.)*3
WheelbaseLS600hL 3090 mm (121.7 in.)
LS600h 2970 mm (116.9 in.)
TreadFront 1610 mm (63.4 in.)
Rear 1610 mm (63.4 in.)
Gross vehicle mass
LS600hL
(5-seat models)
2815 kg (6206 lb.)*1
2785 kg (6140 lb.)*2
LS600hL
(4-seat models) 2750 kg (6062 lb.)
LS600h 2765 kg (6095 lb.)
Maximum permis-
sible axle capacity
Front 1395 kg (3075 lb.)
Rear 1465 kg (3230 lb.)*3
1460 kg (3219 lb.)*4

6228-1. Specifications
LS600h/LS600hL_EE(OM50G20E)
Engine
Model2UR-FSE
Type8-cylinder V type, 4-cycle, gasoline
Bore and stroke94.0  89.5 mm (3.70  3.52 in.)
Displacement4969 cm3 (303.2 cu. in.)
Valve clearance
(engine cold)Automatic adjustment
Drive belt tensionAutomatic adjustment
Fuel
Fuel type
EU area:
Premium unleaded gasoline conforming to European
standard EN228 only
Except EU area:
Premium unleaded gasoline only
Research Octane Num-
ber95 or higher
Fuel tank capacity
(Reference)84 L (22.2 gal., 18.4 Imp. gal.)

625
8
8-1. Specifications
Vehicle specifications
LS600h/LS600hL_EE(OM50G20E)
Recommended viscosity (SAE):
SAE 0W-20 is filled into your
Lexus vehicle at manufacturing,
and the best choice for good fuel
economy and good starting in
cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used.
However, it should be replaced
with SAE 0W-20 at the next oil
change.
If you use SAE 10W-30 or a
higher viscosity engine oil in
extremely low temperatures, the
engine may become difficult to
start, so SAE 0W-20 or 5W-30
engine oil is recommended.
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows
cold startability. Oils with a lower value before the W allow for easier
starting of the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil
when the oil is at high temperature. An oil with a higher viscosity (one
with a higher value) may be better suited if the vehicle is operated at
high speeds, or under extreme load conditions.
Temperature range anticipated
before next oil change.
Preferred

6268-1. Specifications
LS600h/LS600hL_EE(OM50G20E)
How to read oil container labels:
Either or both API registered marks are added to some oil containers
to help you select the oil you should use.
API Service Symbol
Top portion: “API SERVICE SN”
means the oil quality designation by
American Petroleum Institute
(API).
Center portion: “SAE 0W-20”
means the SAE viscosity grade.
Lower portion: “Resource-
Conserving” means that the oil has
fuel-saving and environmental pro-
tection capabilities.
ILSAC Certification Mark
The International Lubricant Specifi-
cation Advisory Committee
(ILSAC) Certification Mark is dis-
played on the front of the container.
1
2