low LEXUS LX470 2006 Repair Manual

OCCUPANT RESTRAINT SYSTEMS
103
If your steering wheel is adjustable, tilt it downward.
This points the airbag toward your chest instead of
your head and neck.
The seat should be adjusted as recommended by
NHTSA above, while still maintaining control of the foot
pedals, steering wheel, and your view of the instrument
panel controls.
Front passenger seat
CAUTION
 The SRS front passenger airbag also deploys with
considerable force, and can cause death or serious
injury especially if the front passenger is very close
to the airbag. The front passenger seat should be as
far from the airbag as possible with the seatback
adjusted, so the front passenger sits upright.
 Do not use seat accessory, such as a cushion or seat
cover, that covers the front seat, or do not modify or
replace the upholstery of the front seat. Such
accessories or changes may prevent the front
passenger airbag system from activating correctly,
disable the system or cause the front passenger
airbag to inflate accidentally, resulting in death or
serious injury.
Front seats
CAUTION
The SRS side airbags are installed in the driver and front
passenger seats. Observe the following precautions.
 Do not lean against the front door when the vehicle
is in use, since the side airbag inflates with
considerable speed and force. Otherwise, you may
be killed or severely injured.
 Do not use seat accessories which cover the area
where the side airbags inflate. Such accessories may
prevent the side airbags from activating correctly,
causing death or serious injury.
 Do not modify or replace the seats or upholstery of
the seats with side airbags. Such change may
prevent the side airbag system from activating
correctly, disable the system, or cause the side
airbags to inflate accidentally, resulting in death or
serious injury.

OCCUPANT RESTRAINT SYSTEMS
107
REAR SEATS
Rear seat precautions
CAUTION
Adjustment should not be made while the vehicle is
moving.
 When folding the seat, secure the seat by adjusting
the length of the anchorage strap to prevent the seat
from falling down.
 When returning the seat to its original position,
observe the following precautions in order to prevent
personal injury in a collision or sudden stop.
There is no person or luggage around the seat and
operate slowly by supporting the seat with your
hands.
The seat is securely locked by pushing forward and
rearward on the top of the seatback and by trying to
pull up the edge of the bottom cushion. Failure to do
so will prevent seat belt from operating properly.
The seat belts are not twisted or caught under the
seat and are arranged in their proper position and are
ready to use.
 When using the seat, make sure the seat is securely
locked.
NOTICE
Avoid putting heavy loads on the removed seat. The
metallic tips of the seat legs may be damaged and the
seat cannot be reinstalled.
Tumbling or removing the seats will enlarge the luggage
compartment. See “Cargo an d luggage” on page 329 for
precautions to observe for loading luggage.
Adjusting rear seats
16X644
 Second seat

OCCUPANT RESTRAINT SYSTEMS
108
16X185b
Third seat
Lean forward and pull the lock release lever. Then lean
back to the desired angle and release the lever.
CAUTION
Avoid reclining the seatback any more than needed.
The seat belts provide maximum protection when the
passengers are sitting up straight and well back in the
seats. If you are reclined, the lap belt may slide past
your hips and apply restraint forces directly to the
abdomen or your neck may contact the shoulder belt.
In the event of a frontal collision, the more the seat is
reclined, the g reater the risk of death or personal injury.
Tumbling second seat for third seat entry
16X186b
For easy access to the third seat, tumble the second seat
in accordance with the following procedure.
Before tumbling the second seat, stow the second seat
buckles as shown in the illustration.
This prevents the buckles from falling out when you tumble the
second seat.
NOTICE
The seat belt buckles must be stowed before you tumble
the second seat.

OCCUPANT RESTRAINT SYSTEMS
109
16X646
1. Lower the head restraints to the lowest position, unlock
the seatback by pulling the lever on the side of the
seatback and fold it down.
16X188c
2. Pull the lever under the seat cushion or pull the strap on
the rear end of the seat cushion and swing the whole seat
forward. 3. To return it to the original position, reverse the steps
above.
16x248a
If you cannot raise the seatback because of the locked seat
belt, do
not try it hard. Release the lock of the seat belt in the
following way.
1 Push in the lower front edge of the seatback cushion to
slacken the seat belt.
2Let the seat belt retract a little.
CAUTION
Do not sit on or place anything on the tumbled
seatback while driving.
 Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback and
by trying to pull up the edge of the bottom cushion.
Failure to do so will prevent seat belt from operating
properly.

OCCUPANT RESTRAINT SYSTEMS
11 0
Tumbling second seat
16X186b
Before tumbling the second seat, stow the second seat
buckles as shown in the illustration.
This prevents the buckles from falling out when you tumble the
second seat.
NOTICE
The seat belt buckles must be stowed before you tumble
the second seat.
16X646
1. Lower the head restraints to the lowest position, unlock
the seatback by pulling the lever on the side of the
seatback and fold it down.
16X188c
2. Pull the lever under the seat cushion or pull the strap on
the rear end of the seat cushion and swing the whole seat
forward.

OCCUPANT RESTRAINT SYSTEMS
11 2
16x248a
If you cannot raise the seatback because of the locked seat
belt, do not try it hard. Release the lock of the seat belt in the
following way.
1 Push in the lower front edge of the seatback cushion to
slacken the seat belt.
2Let the seat belt retract a little.
CAUTION
Do not sit on or place anything on the tumbled
seatback while driving.
 Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback and
by trying to pull up the edge of the bottom cushion.
Failure to do so will prevent seat belt from operating
properly.
Tumbling third seat
16X190b
Before tumbling the third seats, stow the third seat belt
and buckles as shown in the illustration.
This prevents the belt and buckles from falling out when you
tumble the third seat.

OCCUPANT RESTRAINT SYSTEMS
11 4
16X192c
1. Lower the head restraint to the lowest position. Pull the
reclining lever up and fold down the seatback.
16X193g
2. While turning the lever, lift and slide the whole seat
backward.
16X194d
3. Hook the holding strap to the assist grip and secure the
seat by pulling its free end.

OCCUPANT RESTRAINT SYSTEMS
11 7
16X623
Make sure to stow the third center seat belt in order
not to cause damage on the seat belt by pinching it
between the third seat inner leg and seat striker.
16X192c
1. Lower the head restraint to the lowest position. Pull the
reclining lever up and fold down the seatback.
16X193g
2. While turning the lever, lift and slide the whole seat
backward.

OCCUPANT RESTRAINT SYSTEMS
11 8
16X196c
3. Remove the lever cover and pull the lock release lever.
Lift up the rear side of the seat and pull the whole seat
backward.
16X238d
4. Remove the seat hook covers from the back of the seat
cushion and install them onto the seat anchor brackets.
CAUTION
Be sure to install the seat hook covers on the seat
hooks, or you may get burned when they become hot.
5. To reinstall it, reverse the steps above.
CAUTION
When removing or reinstalling the seat, observe the
following precautions to prevent personal injury:
 Be careful not to get your hands or feet pinched in the
seat.
 Be careful not to hit the removed seat against a
person or drop it on yourself.

OCCUPANT RESTRAINT SYSTEMS
11 9
CAUTION
To prevent personal injury in a collision or sudden stop;
You must install the removed seat back in its original
position.
 Do not sit on or place anything on the tumbled
seatback while driving.
 Do not leave the removed seat loose in the vehicle.
 Do not try to sit on or place anything on the removed
seat.
Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback and by
trying to pull up the edge of the bottom cushion. Failure
to do so will prevent seat belt from operating properly.
NOTICE
Avoid putting heavy loads on the removed seat. The
metallic tips of the seat legs may be damaged and the
seat cannot be reinstalled.
HEAD RESTRAINTS
Front seat
16X011b
For your safety and comfort, adjust the head restraint
before driving.
To raise the head restraint, pull it up. To lower it, press the
lock release button and push the head restraint down. To
move the head restraint forward or rearward, pull or push
on the top.
The head restraint is most effective when it is close to your
head. Therefore, using a cush ion on the seatback is not
recommended.