reset LEXUS LX570 2015 Owners Manual

14
LX570_OM_OM60L96U_(U)Pictorial index Instrument panelHeadlight switch
Turn signal lever
Fog light switch P. 208
P. 189
P. 220
Windshield wipers and washer switch
Rear window wiper and washer switch P. 222
P. 228
Hood lock release lever P. 750Gauges and meters
Multi-information display P. 192
P. 200
Glove box P. 691
SRS knee airbags P. 126
Fuel filler door opener P. 116
Bottle holder P. 696Tire pressure warning reset switch P. 768

8311-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
LX570_OM_OM60L96U_(U) Driving position memory system Your preferred driving position (the po sition of the driver’s seat, steering
wheel and outside rear view mirrors) can be entered into the computer’s
memory and recalled with the touch of a button. It is also possible to set this
function to activate automatica lly when the doors are unlocked.
Three different driving positions can be entered into memory.
■ Entering a position to memory
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Adjust the driver’s seat, steering wheel, and outside rear view
mirrors to the desired positions.
While pressing the “SET” but-
ton, or within 3 seconds after
the “SET” button is pressed,
press and hold button “1”, “2” or
“3” until the signal beeps. If the selected button has
already been preset, the previ-
ously recorded position will be
overwritten.
■ Recalling the memorized position
Check that the shift lever is set in “P”.
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Press button “1”, “2” or “3” to
recall the desired position.STEP 1
STEP 2
STEP 3
STEP 1
STEP 2

861-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) ■
Retained accessory power ●
Each memorized position (except for the steering wheel position) can be acti-
vated within 3 minutes after the driver’s door is opened, even if the “ENGINE
START STOP” switch is turned off. ●
Each memorized position (except for the steering wheel position) can be acti-
vated within 60 seconds after the driver’s door is closed, even if the “ENGINE
START STOP” switch is turned off.■
To cancel seat position recall
Perform any one of the following operations. ●
Press the “SET” button ●
Press button “1”, “2” or “3”. ●
Adjust the seat using the switches (only cancels seat position recall)●
Adjust the steering wheel using the tilt and telescopic steering control switch
(only cancels steering wheel position recall) ■
If the battery is disconnected
The memorized positions must be reset because the computer’s memory is erased
when the battery is disconnected.
CAUTION■
Seat adjustment caution
Take care during seat adjustment that the seat does not strike the rear passenger or
squeeze your body against the steering wheel.

1932-2. Instrument cluster
2
When driving
LX570_OM_OM60L96U_(U) Switching the display
Pressing this button switches between odometer and trip meter.
Odometer
Trip meter A
*Trip meter B
*
* : Pushing and holding the button will
reset the trip meter.Odometer and trip meter Odometer: Displays the total dist ance the vehicle has been driven
Trip meter: Displays the distance the vehicle has been driven since the
meter was last reset. Trip meters A and B can be used to record and dis-
play different distances independently
Odometer/trip meter disp lay change buttonSwitches between odometer and trip meter displays
Instrument panel light control dial The brightness of the instrument panel light can be adjusted

2022-2. Instrument cluster
LX570_OM_OM60L96U_(U) Display items
■ Outside temperature display
■ Average fuel consumption and Eco Driving Indicator Zone Display
(  P. 168)
■ Average fuel consumption after refueling Displays the outside temperature • The temperature range that can be displayed
is from -40  F (-40  C) to 122  F (50  C).
• When Crawl Control and Multi-terrain
Select is operating, the temperature is dis-
played on the top of the multi-information
display. Otherwise, it is displayed in the mid-
dle of the multi-information display.
Displays the average fuel consumption since
the function was reset • The function can be reset by pressing the
“DISP” switch for longer than 1 second when
the average fuel consumption is displayed.
• Use the displayed average fuel consumption
as a reference.
Displays the average fuel consumption since
the vehicle was last refueled Use the displayed average fuel consumption as
a reference.

2042-2. Instrument cluster
LX570_OM_OM60L96U_(U) ■ Average vehicle speed
■ Front tire angle
■ Turn-by-turn navigation setting screen Displays the average vehicle speed since the
engine was started or the function was reset The function can be reset by pressing the “DISP”
switch for longer than 1 second when the aver-
age vehicle speed is displayed.
Displays the direction of the front tires The tire direction is displayed in 3 stages for
both left and right, in accordance with the angle
of the tire.
The turn-by-turn navigati on can be set to on or
off. The function can be activated or deactivated by
pressing the “DISP” switch for longer than 1 sec-
ond when turn-by-turn navigation setting
screen is displayed.

2072-2. Instrument cluster
2
When driving
LX570_OM_OM60L96U_(U) ■
Outside temperature display
In the following situations, the correct ou tside temperature may not be displayed, or
the display may take longer than normal to change: ●
When stopped, or driving at low speeds (less than 12 mph [20 km/h]) ●
When the outside temperature has change d suddenly (at the entrance/exit of a
garage, tunnel, etc.)■
When “--” or “E” is displayed
The outside temperature display may be ma lfunctioning. Take your vehicle to your
Lexus dealer. ■
When disconnecting and reconnecting battery terminals
The following information data will be reset: ●
Average fuel consumption after refueling ●
Average fuel consumption ●
Average vehicle speed
CAUTION■
The information displa y at low temperatures
Allow the interior of the vehicle to warm up before using the information display. At
extremely low temperatures, the information display monitor may respond slowly,
and display changes may be delayed.
For example, there is a lag between the driver’s shifting and the new gear number
appearing on the display. This lag could ca use the driver to downshift again, causing
rapid and excessive engine br aking and possibly an accident resulting in death or
serious injury.

2342-4. Using other driving systems
LX570_OM_OM60L96U_(U) ■
Cruise control can be set when ●
The shift lever is in the “D” or range “4” or higher of “S” has been selected. ●
Range “4” or higher has been selected by using the paddle shift. (vehicles with
paddle shift switches) ●
Vehicle speed is above approximately 25 mph (40 km/h).■
Accelerating after s etting the vehicle speed●
The vehicle can be accelerated normally. After acceleration, the set speed
resumes. ●
Even without canceling the cruise control, the set speed can be increased by
first accelerating the vehicle to the de sired speed and then pushing the lever
down to set the new speed. ■
Automatic cruise control cancelation
Cruise control will stop maintaining the ve hicle speed in any of the following situa-
tions. ●
Actual vehicle speed falls more than approximately 10 mph (16 km/h) below
the preset vehicle speed.
At this time, the memorized set speed is not retained.●
VSC is activated. ●
Actual vehicle speed is below approximately 25 mph (40 km/h). ●
The switching operation continues for 5 seconds or more after the center dif-
ferential lock switch has been operated.■
If the warning message for the cruise control is shown on the multi-information
display
Press the “ON-OFF” button once to deactiv ate the system, and then press the but-
ton again to reactivate the system.
If the cruise control speed cannot be set or if the cruise control cancels immediately
after being activated, there may be a malfunction in the cruise control system. Have
the vehicle inspected by your Lexus dealer.

4303-1. Using the touch screen
LX570_OM_OM60L96U_(U) Fuel consumption
Resetting the past record data
Best recorded fuel economy
Current fuel economy
Previous fuel economy record The image is an example only, and
may vary slightly from actual condi-
tions.■
Resetting the data
The data can be deleted by touching “Clear”. ■
Updating the past record data
When the average fuel consumption is being displayed on the multi-information
display, update the average fuel consum ption by pressing and hold the “DISP”
switch on the steering wheel to measure the current fuel consumption again.

4873-3. Using the audio system
3
Interior features
LX570_OM_OM60L96U_(U) Using the radio Press the “AUDIO” button to disp lay the radio control screen.
Touch the “AM”, “FM”, “SAT” or “Apps” tab or press the “AUDIO” button
repeatedly to select the desired tab.
Audio control
screen display
button
Power Volume
Preset tuning (press)/seeking
the frequency (press and hold) Adjusting the frequency AM/FM/SAT/Apps mode
Preset stations Scanning for
receivable
stations
Mute Setting the
sound
(  P. 572)