ECO mode LEXUS LX570 2016 Owners Manual
[x] Cancel search | Manufacturer: LEXUS, Model Year: 2016, Model line: LX570, Model: LEXUS LX570 2016Pages: 632, PDF Size: 10.34 MB
Page 21 of 632
21Pictorial index
LX570_OM_OM60N01U_(U) Crawl Control switches/Multi-terrain Select mode
selector dial . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 309, 31 4
VSC OFF switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .P. 380
Center differential lock/unlock switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 306
Second start mode switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 211
Four-wheel drive control switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 305
Height select/height control OFF switches . . . . . . . . . . . . . . . . . . . . . . . . P. 297
Driving mode select switch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 286
Front seat heater/ventilator switches
* 2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .P. 415
Heated steering wheel switch
* 2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 416
Remote Touch
* 1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 394
* 1
: Refer to “NAVIGATION SYSTEM OWNER’S MANUAL”.
* 2
: If equipped1
2
3
4
5
6
7
8
9
10
Page 27 of 632
271-1. For safe use
LX570_OM_OM60N01U_(U) 1
For safety and security WA R N I N G
Observe the following precautions.
Failure to do so may cause the driver’s floor mat to slip, possibly interfering with the ped-
als while driving. An unexpect edly high speed may result or it may become difficult to
stop the vehicle. This could lead to an ac cident, resulting in death or serious injury.■
When installing the driver’s floor mat ●
Do not use floor mats designed for other models or different model year vehicles,
even if they are Lexus Genuine floor mats. ●
Only use floor mats designed for the driver’s seat. ●
Always install the floor mat securely using the retaining hooks (clips) provided. ●
Do not use two or more floor mats on top of each other. ●
Do not place the floor mat bottom-side up or upside-down. ■
Before driving ●
Check that the floor mat is securely fixed in
the correct place with all the provided retain-
ing hooks (clips). Be especially careful to per-
form this check after cleaning the floor. ●
With the engine stopped and the shift lever in
P, fully depress each pedal to the floor to
make sure it does not interfere with the floor
mat.
Page 50 of 632
50 1-1. For safe use
LX570_OM_OM60N01U_(U) ON/OFF (hold for a few seconds) The “RSCA OFF” indicator turns on
(only when the engine switch is in IGNI-
TION ON mode.)
The roll sensing function for the curtain
shield airbags and seat belt pretension-
ers will turn back on automatically each
time the engine switch is turned to
IGNITION ON mode. ■
This switch only should be used
In a situation where the inflation is not desired (such as during extreme off road driving). ■
Operating conditions when the “RSCA OFF” indicator is on ●
The curtain shield airbags and seat belt pret ensioners will not activate in a vehicle roll-
over. ●
The curtain shield airbags will activate in a severe side impact. ●
The seat belt pretensioners will activate in a severe frontal collision.Deactivating the curtain shield airbags in a vehicle rollover
WA R N I N G ■
For normal driving
Make sure the “RSCA OFF” indicator is not turn ed on. If it is left on, the curtain shield
airbag will not activate in the event of an accident, which may result in death or serious
injury.
Page 67 of 632
671-1. For safe use
LX570_OM_OM60N01U_(U) 1
For safety and security Fully extend the shoulder belt and
then allow it to retract slightly in
order to activate the ALR lock
mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system down into the second
seat, allow the shoulder belt to
retract until the child restraint sys-
tem is securely in place. After the shoulder belt has retracted
to a point where there is no slack in
the belt, pull the belt to check that it
cannot be extended. 4
5
Page 69 of 632
691-1. For safe use
LX570_OM_OM60N01U_(U) 1
For safety and security Fully extend the shoulder strap
and then allow it to retract slightly
into the ALR lock mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system into the second seat, allow
the shoulder belt to retract until
the child restraint system is
securely in place. After the shoulder belt has retracted
to a point where there is no slack in
the belt, pull the belt to check that it
cannot be extended.
If the child restraint system has a top tether strap, the top tether strap
should be latched onto the top tether strap anchor. ( P. 7 1 )4
5
6
Page 73 of 632
731-1. For safe use
LX570_OM_OM60N01U_(U) 1
For safety and security WA R N I N G ■
When installing a booster seat
To prevent the belt from going into ALR lock mode, do not fully extend the shoulder
belt. ALR mode causes the belt to tighten on ly. This could cause injury or discomfort to
the child. ( P. 3 4 )■
When installing a child restraint system
Follow the directions given in the child restra int system installation manual and fix the
child restraint system securely in place.
If the child restraint system is not correctl y fixed in place, the child or other passengers
may be seriously injured or even killed in th e event of sudden braking, sudden swerving
or an accident.
●
When installing a child restraint system on the second center se at, adjust both seat
cushions to the same position and align bo th seatbacks at the sa me angle. The seat-
backs must be adjusted to the same angle. Otherwise, the child restraint system can-
not be securely restrained and this may caus e death or serious injuries in the event of
sudden braking, sudden swerving or an accident. ●
When using the LATCH anchors for a child restraint system, move the seat as far
back as possible, with the seatback close to the child restraint system. ●
If the driver’s seat interferes with the child
restraint system and prevents it from being
attached correctly, attach the child restraint
system to the right-hand rear seat. ●
Adjust the front passenger seat so that it does
not interfere with the child restraint system. ●
Child restraint system installed on the third
seat should not contact the second seatbacks. ●
Only put a forward-facing child restraint sys-
tem on the front seat when unavoidable.
When installing a forward-facing child
restraint system on the front passenger seat,
move the seat as far back as possible even if
the “AIR BAG OFF” indicator light is illumi-
nated. Failure to do so may result in death or
serious injury if the airbags deploy (inflate).
Page 78 of 632
78 1-2. Theft deterrent system
LX570_OM_OM60N01U_(U)Alarm The alarm uses light and sound to give an alert when an intrusion is detected.
The alarm is triggered in the following situations when the alarm is set: ●
A locked door is unlocked or opened in any way other than using the entry
function or wireless remote control. (The doors will lock again automatically.)●
The hood is opened. ●
The battery is reconnected.
Close the doors and hood, and lock all
the doors using the entry function or
wireless remote control. The system will
be set automatically after 30 seconds. The indicator light changes from being
on to flashing when the system is set.
Do one of the following to de activate or stop the alarms:●
Unlock the doors using the entry function or wireless remote control. ●
Turn the engine switch to ACCESSORY or IGNITION ON mode, or start
the engine. (The alarm will be deactivat ed or stopped after a few seconds.)The alarm
Setting the alarm system
Deactivating or stopping the alarm
Page 84 of 632
84
LX570_OM_OM60N01U_(U) 2. Instrument cluster
* 1
: These lights turn on when the engine switch is turned to IGNITION ON mode to
indicate that a system check is being perfor med. They will turn off after the engine is
on, or after a few seconds. There may be a malfunction in a system if the lights do not
turn on, or turn off. Have the vehicle inspected by your Lexus dealer.
* 2
: The light flashes to indicate a malfunction.
* 3
: This light illuminates on the center panel. * 2
(Canada)
Parking brake indicator
( P. 5 2 6 )
* 1
Power steering system
warning light ( P. 5 2 6 )
* 1
Brake system warning light
( P. 5 2 7 )
Page 85 of 632
LX570_OM_OM60N01U_(U) 852. Instrument cluster
2
Instrument cluster The indicators inform the driver of the op erating state of the vehicle’s various sys-
tems.
Indicators Turn signal indicator
( P. 2 1 6 ) (if equipped)
“LDA” (Lane Departure
Alert) indicator ( P. 2 6 3 )(U.S.A.)
Headlight indicator
( P. 220)
* 1, 2
Slip indicator ( P. 3 8 0 )
(Canada)
Tail light indicator
( P. 220)
* 1
VSC OFF indicator
( P. 3 8 0 )
Headlight high beam
indicator ( P. 221) (if equipped)
Multi-terrain Select
indicator ( P. 3 1 4 )
(if equipped)
Automatic High Beam
indicator ( P. 2 2 4 ) * 1
(if equipped)
Crawl Control indicator
( P. 3 0 9 )
(if equipped)
Fog light indicator
( P. 2 2 9 )
* 1, 3
“RSCA OFF” indicator
( P. 5 0 )
* 1
Eco Driving Indicator
Light ( P. 8 7 ) Automatic transmission
second start indicator
( P. 2 1 0 )
Cruise control indicator
( P. 2 8 3 , 2 7 1 ) Low speed four-wheel
drive indicator light
( P. 3 0 5 )
Cruise control “SET”
indicator ( P. 2 8 3 , 2 7 1 ) Center differential lock
indicator ( P. 3 0 6 )
(if equipped) Dynamic radar cruise
control indicator
( P. 2 7 1 ) * 1
Easy access mode
indicator ( P. 2 9 7 )
Page 86 of 632
86
LX570_OM_OM60N01U_(U) 2. Instrument cluster
* 1
: These lights turn on when the engine switch is turned to IGNITION ON mode to
indicate that a system check is being perfor med. They will turn off after the engine is
on, or after a few seconds. There may be a malfunction in a system if the lights do not
turn on, or turn off. Have the vehicle inspected by your Lexus dealer.
* 2
: The light flashes to indicate that the system is operating.
* 3
: The light turns on when the system is turned off.
* 4
: In order to confirm operation, the BSM outs ide rear view mirror indicators illumi-
nate in the following situations:
• When the engine switch is turned to IGNITION ON mode while the system is set
to on.
• When the system is set to on while the engine switch is in IGNITION ON mode.
If the system is functioning correctly, th e BSM outside rear view mirror indicators
will turn off after a few seconds.
If the BSM outside rear view mirror indicat ors do not illuminate or do not turn off,
there may be a malfunction with the system.
If this occurs, have the vehicle inspected by your Lexus dealer.
* 5
: This light illuminates on the outside rear view mirrors.
* 6
: This light illuminates on the center panel.
* 7
: When the outside temperature is approximately 37 F (3 C) or lower, the indicator
will flash for approximately 10 seconds, then stay on. (if equipped)
Intuitive parking assist
indicator ( P. 2 8 9 ) Turn Assist function
indicator ( P. 3 0 9 )
* 1, 3
(if equipped)
PCS warning light
( P. 2 5 0 ) (U.S.A.)
Parking brake indicator
( P. 2 1 7 )(if equipped)
BSM (Blind Spot Monitor)
indicator ( P. 3 6 5 ) (Canada)
Parking brake indicator
( P. 2 1 7 )
* 4, 5
(if equipped)
BSM (Blind Spot Monitor)
outside rear view mirror
indicators ( P. 3 6 5 ) TRAC OFF indicator
( P. 3 8 0 )
(if equipped)
RCTA (Rear Cross Traffic
Alert) indicator ( P. 3 7 3 )
* 7
Low outside temperature
indicator ( P. 88)
* 6
“A I R B A G O N /
OFF” indicator
( P. 5 1 )