park assist LEXUS RX270 2014 User Guide

249
2-4. Using other driving systems
2
When driving
RX350/270_EE
Display
When the sensors detect an obstacle, a graphic is shown on the multi-
information display depending on the position and distance to the obsta-
cle.
Front corner sensor operation
Front center sensor operation
Rear corner sensor operation
Rear center sensor operation
Press the “ENTER” switch to
change to “ON”.
The Lexus parking assist-sensor
indicator will be displayed.
Each pressing of the switch
turns the Lexus parking assist-
sensor on and off.
When on, the buzzer sounds to
inform the driver that the system
is operational.
Press the menu switch to
change to the normal display.
STEP2
RX350_270_EE_48D77E.book 249 ページ ２０１４年１月２４日　金曜日　午前１０時４分

253
2-4. Using other driving systems
2
When driving
RX350/270_EE
Detection range of the sensors
Approximately 100 cm (3.3 ft.)
Approximately 150 cm (4.9 ft.)
Approximately 50 cm (1.6 ft.)
The diagram shows the detection
range of the sensors. Note that the
sensors cannot detect obstacles
that are extremely close to the
vehicle.
The range of the sensors may
change depending on the shape of
the object etc.
■The Lexus parking assist-sensor can be operated when
●Front corner sensors:
• The “ENGINE START STOP” switch is in IGNITION ON mode.
• The shift lever is in a position other than P.
• The vehicle speed is less than about 10 km/h (6 mph).
●Front center sensors:
• The “ENGINE START STOP” switch is in IGNITION ON mode.
• The shift lever is in a position other than P or R.
• The vehicle speed is less than about 10 km/h (6 mph).
●Rear corner and center sensors:
• The “ENGINE START STOP” switch is in IGNITION ON mode.
• The shift lever is in R.
RX350_270_EE_48D77E.book 253 ページ ２０１４年１月２４日　金曜日　午前１０時４分

254
2-4. Using other driving systems
RX350/270_EE
■Sensor detection information
●Certain vehicle conditions and the surrounding environment may affect the
ability of a sensor to correctly detect an obstacle. Particular instances where this
may occur are listed below.
• There is dirt, snow or ice on a sensor.
• A sensor is frozen.
• A sensor is covered in any way.
• The vehicle is leaning considerably to one side.
• On an extremely bumpy road, on an incline, on gravel, or on grass
• The vicinity of the vehicle is noisy due to vehicle horns, motorcycle engines,
air brakes of large vehicles, or other loud noises producing ultrasonic waves.
• There is another vehicle equipped with parking assist sensors in the vicinity.
• A sensor is coated with a sheet of spray or heavy rain.
• The vehicle is equipped with a fender pole or radio antenna.
• Towing eyelets are installed.
• A bumper or sensor receives a strong impact.
• The vehicle is approaching a tall or right-angled curb.
• In harsh sunlight or intense cold weather.
• A non-genuine Lexus suspension (lowered suspension, etc.) is installed.
In addition to the examples above, there are instances in which, because of their
shapes, signs and other objects may be judged by a sensor to be closer than they
are.
●The shape of the obstacle may prevent a sensor from detecting it. Pay particular
attention to the following obstacles:
• Wires, fences, ropes, etc.
• Cotton, snow and other materials that absorb sound waves
• Sharply-angled objects
• Low obstacles
• Tall obstacles with upper sections projecting outwards in the direction of your
vehicle
■If a message is displayed
→P. 5 5 2
■Customization
Settings (e.g. buzzer volume) can be changed.
(Customizable features →P. 6 2 2 )
RX350_270_EE_48D77E.book 254 ページ ２０１４年１月２４日　金曜日　午前１０時４分

255
2-4. Using other driving systems
2
When driving
RX350/270_EE
CAUTION
■Caution when using the Lexus parking assist-sensor
Observe the following precautions.
Failing to do so may result in the vehicle being unable to be driven safely and possi-
bly cause an accident.
●Do not use the sensor at speeds in excess of 10 km/h (6 mph).
●Do not attach any accessories within the sensor range.
NOTICE
■Notes when washing the vehicle
Do not apply intensive bursts of water or steam to the sensor area.
Doing so may result in the sensor malfunctioning.
■Conditions possibly indicating system malfunctions
If any of the following occurs, the system may be malfunctioning due to a sensor fail-
ure etc. Have the vehicle inspected by any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional.
●The buzzer does not sound when the Lexus parking assist-sensor mode is set.
●The sensor operation display flashes and the buzzer sounds even when no obsta-
cle is detected.
●An area of the sensors is hit or subjected to a strong impact.
●Either bumper is hit.
●The sensor operation display remains on even though no buzzer sounds.
RX350_270_EE_48D77E.book 255 ページ ２０１４年１月２４日　金曜日　午前１０時４分

278
2-4. Using other driving systems
RX350/270_EE
Hill-start assist control
■Hill-start assist control can be operated when
●The shift lever is in a position other than P.
●The parking brake is not applied.
●The accelerator pedal is not depressed.
■Hill-start assist control
●While hill-start assist control is operating, the brakes remain automatically
applied after the driver releases the brake pedal. The stop lights and the high
mounted stoplight turn on.
●Hill-start assist control operates for about 2 seconds after the brake pedal is
released.
●If the slip indicator does not flash and the buzzer does not sound when the brake
pedal is further depressed, slightly reduce the pressure on the brake pedal (do
not allow the vehicle to roll backward) and then firmly depress it again. If the sys-
tem still does not operate, check if the operating conditions explained above
have been met.
Hill-start assist control helps to prevent the vehicle from rolling backwards
when starting on an incline or slippery slope.
To engage hill-start assist con-
trol, further depress the brake
pedal when the vehicle is
stopped completely.
A buzzer will sound once to
indicate the system is activated.
The slip indicator will also start
flashing.
RX350_270_EE_48D77E.book 278 ページ ２０１４年１月２４日　金曜日　午前１０時４分

279
2-4. Using other driving systems
2
When driving
RX350/270_EE
■Hill-start assist control buzzer
●When hill-start assist control is activated, the buzzer will sound once.
●In the following situations, hill-start assist control will be canceled and the
buzzer will sound twice.
• No attempt is made to drive the vehicle within approximately 2 seconds of
releasing the brake pedal.
• The shift lever is moved to P.
• The parking brake is applied.
• The brake pedal is depressed again.
• The brake pedal has been depressed for more than approximately 3 minutes.
●If a buzzer other than the hill-start assist control buzzer is sounding, the hill-start
assist control buzzer may not sound when the system is activated or canceled.
■If the slip indicator comes on
It may indicate a malfunction in the system. Contact any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
CAUTION
■Hill-start assist control
●Do not overly rely on hill-start assist control. Hill-start assist control may not oper-
ate effectively on extremely steep inclines or roads covered in ice.
●Unlike the parking brake, hill-start assist control is not intended to hold the vehi-
cle stationary for an extended period of time. Do not attempt to use hill-start
assist control to hold the vehicle on an incline for an extended period of time, as
doing so may lead to an accident.
RX350_270_EE_48D77E.book 279 ページ ２０１４年１月２４日　金曜日　午前１０時４分

513
4-3. Do-it-yourself maintenance
4
Maintenance and care
RX350/270_EE
7ECU-IG1 NO. 110 A
Multiplex communication system,
steering sensor, shift lock control sys-
tem, tilt and telescopic steering, auto-
matic transmission system, power
back door, pre-crash safety system,
vehicle stability control system, tire
pressure warning system
8S/ROOF30 AMoon roof
9FUEL OPN7. 5 AFuel filler door opener
10PSB30 APre-crash seat belt
11TI & TE30 ATilt and telescopic steering system
12DR LOCK10 ADR LOCK
13FR FOG7. 5 AFront fog lights
14P- S E AT L H30 APower seat (left-side)
154WD7. 5 AAW D s y s t e m
16INVERTER20 A
17RR FOG7. 5 ARear fog lights
18D/L ALT B25 A
Multiplex communication system,
power door lock system, power back
door
19EPS10 AElectric power steering system
20ECU-IG1 NO. 210 ALexus parking assist-sensor, AWD
system, pre-crash seat belt
FuseAmpereCircuit
RX350_270_EE_48D77E.book 513 ページ ２０１４年１月２４日　金曜日　午前１０時４分

538
5-1. Essential information
RX350/270_EESecurely attach a cable or chain to the towing eyelet.
Take care not to damage the vehicle body.
Enter the vehicle being towed and start the engine.
If the engine does not start, turn the “ENGINE START STOP” switch to
IGNITION ON mode.
For models with electronically modulated air suspension: Change
the vehicle height to “N” mode and end the vehicle height opera-
tion. (
→P. 2 5 6 )
Shift the shift lever to N and release the parking brake.
When the shift lever cannot be shifted: →P. 589
■While towing
If the engine is not running, the power assist for the brakes and steering will not
function, making steering and braking more difficult.
■Wheel nut wrench
Wheel nut wrench is installed in the luggage compartment. (→P. 5 7 2 )
STEP5
STEP6
STEP7
STEP8
RX350_270_EE_48D77E.book 538 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
555
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
(Flashes)
(If equipped)
Indicates a malfunction in the adaptive front lighting
system
Indicates a malfunction in the brake lights system
(Flashes)
(If equipped)Indicates a malfunction in the pre-crash safety system
(If equipped)
Indicates a malfunction in the Lexus parking assist-
sensor
The malfunctioning assist-sensor is flashing.
Warning messageDetails
RX350_270_EE_48D77E.book 555 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
559
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
(RX350)
Indicates that engine oil
level is low
A buzzer also sounds.Check the level of engine
oil, and add if necessary.
(Flashes)
(AWD models)
Indicates that the AWD
system is not currently
functional
A buzzer also sounds.
Reduce vehicle speed or
stop the vehicle in a safe
place until the warnings
clear.
In this case, do not stop
the engine.
(If equipped)
Indicates that the pre-
crash safety system is not
currently functional
because the grille or the
sensor is dirty.
This message also
appears when the pre-
crash safety system is not
functional due to over-
heating.
• Check the grille and the
sensor and clean them if
they are dirty.
• In case of overheating,
the system will become
functional once the sys-
tem cools down.
(If equipped)
Indicates that Lexus
parking assist-sensor is
dirty or covered with ice
A buzzer also sounds.
The site of the malfunc-
tion and the vehicle
image are flashing.
Clean the sensor.
Wa r n i n g m e s s a g eDetailsCorrection procedure
RX350_270_EE_48D77E.book 559 ページ ２０１４年１月２４日　金曜日　午前１０時４分