lock LEXUS SC300 1999 Repair Manual

SECTION 3 ± 1
207
STARTING AND DRIVING
Starting and driving
Three±way catalytic converter. . . . . . . . . . . . . . . . . . . . . . . .
208
Engine exhaust caution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
211
Before starting the engine . . . . . . . . . . . . . . . . . . . . . . . . . . . .
212
Ignition switch with steering lock . . . . . . . . . . . . . . . . . . . . . .
212
Parking brake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
.
215
How to start the engine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
216
Automatic transmission (SC400) . . . . . . . . . . . . . . . . . . . . . .
217
Automatic transmission (SC300) . . . . . . . . . . . . . . . . . . . . . .
229
Electronic throttle control system 241
. . . . . . . . . . . . . . . . . .
Cruise control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
.
242
Traction control system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
246
Brake system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. .

STARTING AND DRIVING
212
To allow proper operation of your vehicle's
ventilation system, keep the inlet grilles in front of
the windshield clear of snow, leaves, or other
obstructions.
 If you smell exhaust fumes in the vehicle, drive with
the windows open and the trunk lid closed. Have the
cause immediately located and corrected.
BEFORE STARTING THE
ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat position, seatback angle, head restraint height
and steering wheel angle.
3. Adjust inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators
function when turning the key to ºONº, and check the fuel
gauge to see that you have sufficient fuel.
IGNITION SWITCH WITH
STEERING LOCK

STARTING AND DRIVING
213
ºSTARTº ± Starter motor on. The key will return to the
ºONº position when released.
For starting tips, see page 216.
ºONº ± Engine on and all accessories on.
This is the normal driving position.
NOTICE
Do not leave the key in the ºONº position if the engine is
not running. The battery will discharge and the
electronic ignition system could be damaged.
ºACCº ± Accessories such as the radio operate, but the
engine is off.
If you leave the key in the ºACCº or ºLOCKº position and
open the driver's door, a buzzer will remind you to remove the
key.

STARTING AND DRIVING
214
ºLOCKº ± Engine is off and the steering wheel is locked.
The ignition key can be removed only at this position.
To turn the key from ºACCº to the ºLOCKº position, you
must put the transmission selector lever in the ºPº position.
Once you remove the key, the engine immobiliser system is
automatically set. See ºEngine immobiliser systemº on page
16.
When starting the engine, the key may seem stuck at the
ºLOCKº position. To free it, first be sure the key is pushed
all the way in, and then rock the steering wheel slightly while
turning the key gently.If, in an emergency, you must turn the engine off while the
vehicle is moving, turn the key only to ºACCº.

STARTING AND DRIVING
217
AUTOMATIC TRANSMISSION(SC400)
Your automatic transmission has a shift lock system to
minimize the possibility of incorrect operation. This
means you can only shift out of ºPº position when the
brake pedal is depressed with the ignition switch in ºONº
position. ()

STARTING AND DRIVING
228
NOTICE
If you rock your vehicle, observe the following
precautions to prevent damage to the transmission and
other parts.
Do not depress the accelerator pedal while shifting the
selector lever or before the transmission is completely
shifted to forward or reverse gear.
 Do not race the engine and avoid spinning the wheels.
 If your vehicle remains stuck after rocking the vehicle
several times, consider other ways such as towing.
(h) If you cannot shift the selector lever
If you cannot shift the selector lever even though the brake
pedal is depressed, use the shift lock override button. For
instructions, see ºIf you cannot shift automatic transmission
selector leverº on page 306.

STARTING AND DRIVING
229
AUTOMATIC TRANSMISSION(SC300)
Your automatic transmission has a shift lock system to
minimize the possibility of incorrect operation. This
means you can only shift out of ºPº position when the
brake pedal is depressed with the ignition switch in ºONº
position. ()

STARTING AND DRIVING
240
NOTICE
If you rock your vehicle, observe the following
precautions to prevent damage to the transmission and
other parts.
Do not depress the accelerator pedal while shifting the
selector lever or before the transmission is completely
shifted to forward or reverse gear.
 Do not race the engine and avoid spinning the wheels.
 If your vehicle remains stuck after rocking the vehicle
several times, consider other ways such as towing.
(h) If you cannot shift the selector lever
If you cannot shift the selector lever even though the brake
pedal is depressed, use the shift lock override button. For
instructions, see ºIf you cannot shift automatic transmission
selector leverº on page 306.

STARTING AND DRIVING
250
Anti±lock brake system
The anti±lock brake system is designed to automatically
help prevent lock±up of the wheels during a sudden brake
or braking on slippery road surfaces. This assists in
providing directional stability and steering performance
of the vehicle under these circumstances.
The anti±lock brake system becomes operative after the
vehicle has accelerated to a speed in excess of approximately
10 km/h (6 mph). It stops operating when the vehicle
decelerates to a speed below approximately 5 km/h (3 mph).
You may hear a sound in the engine compartment for a few
seconds when the engine is started or just after the vehicle is
started. This means that the anti±lock brake system is in the
self±check mode, and does not indicate a malfunction.
Effective way to press the ABS brake pedal: When the anti±
lock brake system function is in action, you may feel the brake
pedal pulsating and hear a noise. In this situation, to let the anti±
lock brake system work for you, just hold the brake pedal down
more firmly. Do not pump the brake in a panic stop. Pumping the
brake pedal makes the stopping distance longer.

STARTING AND DRIVING
251
The brake pedal pulsation caused by the anti±lock brake
system may indicate hazardous road surface conditions.
Although the anti±lock brake system assists in providing
vehicle control, it is still important to drive with all due care,
because
the anti±lock brake system cannot overcome the laws
of physics that act on your vehicle:
 Braking capability is dependent on tire friction with the
road surface. 
Even though the anti±lock brake system is operating, a
driver cannot maintain full control on certain slippery road
surfaces, when cornering at high speeds, or in violent
maneuvers.
 Avoid high speeds on wet roads. The anti±lock brake
system cannot eliminate the risk of hydroplaning and loss
of tire friction.
Always maintain a safe distance from the vehicle in front of
you. Compared with vehicles not fitted with an anti±lock
brake system, your vehicle may require a longer stopping
distance in the following cases:
 Driving on rough, gravel or snow±covered roads.
 Driving with tire chains installed.
 Driving on roads where the road surface is pitted or has
other differences in surface height.