Do not put objects under the front seats that
interfere with the flow of air to the back seat
area. Remove any snow, ice, or leaves from the air
intake area of your EATC System which
could block the air intake. The intake area is
located at the bottom of the windshield, under
the hood at the passenger side rear corner.
Service
If your EATC is not operating as described here,
take it to your dealer to have it checked. System
diagnostics are built in which will allow your
dealer to readily identify problems that might
occur.
80Rear Window Defroster and
Heated Sideview Mirrors
The rear window and heated outside mirrors
defroster switch activates the defroster for the
rear window to clear frost, fog, or thin ice from
both the inside and outside of the rear window
and activates the heated outside rearview
mirrors.
The button for the rear window and heated
outside mirrors defroster is on the instrument
panel to the right of the steering column.
2. Rotate the thumbwheel from "0" to " 1 " (the
lowest heat level). Allow five minutes for the
heat level to stabilize.
3. If the heat level is not high enough for comfort,
select increased heat levels "2' through "5" (the
maximum level). Allow at least two minutes
for the heat level to stabilize at any new level
selected.
4. If the heated seat switch is not turned off ("0"
on the thumbwheel), the seat will heat up to the
selected temperature level each time the car is
started.
NOTE: Cooling the seat down takes considerably
longer than increasing its heat level.
118Cleaning the Seats
Leather
For routine cleaning, wipe the surface with a
soft, damp cloth. For more thorough cleaning,
wipe the surface with a leather and vinyl cleaner
or a mild soap.
Wipe the surface with a damp, soft cloth, then
dry and buff with a dry, soft cloth.
Fabric
Remove dust and loose dirt with a whisk broom
or a vacuum cleaner. Remove fresh spots
immediately. Follow the directions that come
with the cleaner.
NOTE: Before using any cleaner, test it on a
small, hidden area of fabric. If the fabric's color
or texture is adversely affected by a particular
cleaner, do not use it.
