heater LINCOLN CONTINENTAL 1997 Owners Manual
[x] Cancel search | Manufacturer: LINCOLN, Model Year: 1997, Model line: CONTINENTAL, Model: LINCOLN CONTINENTAL 1997Pages: 321, PDF Size: 2.37 MB
Page 105 of 321
101
Compass-Calibration1. For optimum calibration, switch off all
non-essential electrical accessories (rear window
defrost, heater/air conditioning, map lamps,
wipers, etc.) and ensure all doors are shut.
2. Drive to an open, level area away from large
metallic objects or structures.
3. Insert an appropriate diameter rod (paper clip)
into the left switch access hole underneath the
compass module and press gently for 1-2
seconds until ªCALº and a direction appear on
the display.
4. Release the button and drive in a circle until
ªCALº disappears from the display (approx. 2-3
circles).
Compass-Zone Adjustment1. The zone setting is factory pre-set to Zone 8.
Refer to the Zone Map in this manual to verify
the correct compass zone setting for your
geographical location.
File:05fncfc.ex
Update:Fri Sep 6 14:53:57 1996
Page 214 of 321
213
Preparing Your Vehicle1. Your vehicle has a 12-volt starting system, so
you need to use a 12-volt jumper system. You
will damage your starting motor, ignition
system, and other electrical parts if you connect
them to a 24-volt power supply (either two
12-volt batteries in series or a 24-volt generator
set).
2. Do not disconnect the battery of the disabled
vehicle. You could damage the vehicle's
electrical system.3. Park the booster vehicle close to the hood of
the disabled vehicle.Make sure the vehicles
do not touch each other.Set the parking
brake on both vehicles and stay clear of the
engine cooling fan and other moving parts.
4. Check all battery terminals and remove any
excessive corrosion before you attach the
jumper cables.
5. Turn on the heater fan in both vehicles. Press
the DEFROST button. Turning on the fan helps
protect the electrical system from voltage
surges. Turn off all other switches and gauges.
File:10fnerc.ex
Update:Fri Sep 6 08:49:57 1996
Page 237 of 321
236q
Select maximum heater temperature and fan
speed settings. Position control to discharge air
at A/C vents in instrument panel.
q
Start engine and allow to idle. While engine is
idling, feel for hot air at A/C vents.
NOTE:IF AIR DISCHARGE REMAINS COOL AND
ENGINE TEMPERATURE GAUGE DOES NOT
MOVE,SHUT ENGINE OFF IMMEDIATELY.
This is an indication of low coolant level and/or air
pockets in coolant system. Allow engine to cool and
repeat the previous steps.
q
Allow to idle until normal operating temperature
is reached. Hot air should discharge from A/C
vents. The engine temperature gauge should
maintain a stabilized reading in the middle of
the ªNORMALº range and the lower radiator
hose should feel hot to the touch.
q
Shut off the engine and allow to cool down.
q
After the engine cools down, recheck the
engine coolant level. Fill reservoir to the
COLD-FULL level as required.
q
Check for leaks at the draincock, block plug
and vent plug.
q
Recheck the engine coolant level, using the
recommended procedure, after one or two
occasions of vehicle use. Fill to COLD-FULL
level as required.
File:11fnmcc.ex
Update:Fri Sep 6 08:51:16 1996
Page 309 of 321
311
Electronic sound system (continued)
warranty and service information.... 44
Electronic stereo cassette radio
(see Electronic sound system)..... 27
Electronic stereo radio (see Electronic
sound system)............ 27
Emergencies, roadside
fuel................ 255
jump-starting............ 211
towing............... 217
Emergency brake (parking brake)..... 172
Emission control system......... 258
catalytic converter.......... 258
emissions warranty.........4,258
Engine
does not start.........167, 191
fuel injected engine, starting . . . 165, 166
fuel pump shut-off switch....... 191
preparing to start.......... 165
refill capacities............ 272
service points............ 224
starting............... 166starting after a collision........ 191
storing your vehicle......274, 275
Engine block heater........... 168
Engine coolant............. 231
checking and adding......... 231
disposal............220, 240
preparing for storage......... 275
proper solution........220, 240
recovery reservoir.......224, 231
refill capacities............ 272
specifications............ 273
temperature gauge.......... 17
Engine coolant temperature gauge..... 17
description............. 17
mechanical............. 17
Engine coolant temperature
guage:electronic........... 17
Engine fan............... 221
Engine knocking............ 253
Engine oil............... 226
ªbreak-inº oils............. 5
changing oil and oil filter....227, 228
File:fnixc.ex
Update:Tue Sep 17 08:28:54 1996