start stop button LINCOLN MKZ 2013 Quick Reference Guide

3 SeRviCe engine
Soon Light
illuminates briefly when the ignition
is turned on. if it remains on or is blinking
after the engine is started, the on-board
diagnostics system ( obD-ii) has detected
a malfunction. Drive in a moderate
fashion and contact your authorized
dealer as soon as possible.
4 PoweR tiLt/
teLeSC oPing
SteeRing CoL umn*
Your power tilt steering column has a
four-way rocker control that allows you
to adjust the steering wheel to your
desired position.
5 SteeRing wheeL
Audio ContRoLS*
Press VOL + or VOL - to increase or
decrease volume levels.
Press
to access the next/
previous radio station preset, CD
track or preset satellite radio channel*.
Press
to access voice recognition.
Press
to access SYnC®
phone features.
6 Right vehiCLe
inF oRmA tion diSPLA y
Displays information about
entertainment, Phone, navigation*
and Climate. Use the right, 5-way
control located on your steering wheel
to scroll through, highlight and make
minor adjustments within a selected
menu. Refer to the MyLincoln Touch™
chapter in your Owner’s Manual for
more information.

7 PuSh Button St ARt
You can start your vehicle while your
keys remain in your pocket, purse
or back pack. With your vehicle in P
(Park), fully press the brake pedal and
press the ENGINE START STOP button.
Press the button again to turn the
engine off.
Note: Your intelligent access key must
be inside the vehicle for the ignition
to start.
8 PuSh Button
ShiFt tRAnSmiSSion
Your vehicle is equipped with an
electronic transmission. The shift buttons
are located on the center stack next the
MyLincoln Touch™ system.
Putting your vehicle in gear:
1. Fully press down the brake pedal.
2. Press and release one of the PRNDS
buttons to select your gear.
3. The gear shift button you select will
illuminate and the instrument cluster
will show a telltale of the selected gear.
4. Release the brake pedal and your
transmission will remain in the
selected gear.
Note: When entering an automatic car
wash, always put your vehicle into Stay
in Neutral mode. To put your vehicle in
Stay in Neutral mode, make sure your
vehicle is stationary first, and then:
1. Press the N (neutral) button on the
shifter assembly once. The information
display screen will read “Press N to
enter Stay in Neutral mode”.
2. Press N on the shifter assembly
again. The message “Stay in Neutral
mode engaged” will appear in the
instrument cluster and the n button
will flash continuously to confirm
your selection.
3. To exit Stay in Neutral, select another gear.
1 LeFt vehiCLe
inF oRmA tion diSPLA y
Provides information about various
systems on your vehicle. Use the left,
5-way control located on the steering
wheel to choose and confirm settings
and messages. Refer to the Information
Displays chapter in your Owner’s Manual
for more information.
2 AdAPtive
CRuiSe ContRoL *
Automatically adjusts your speed to
maintain a set distance between you
and the vehicle in front of you in the
same lane. You can set the gap distance
between yourself and the vehicle in front
by pressing the
and buttons on the
steering wheel.
Note: Driving aids do not replace the
need to watch where the vehicle is
moving and brake where necessary.
Refer to your the Cruise Control chapter
of your Owner’s Manual for safety
information, more detail and limitations.
5
1
1
4
3
2
8
5
7
6
inSTRUMenT
P AneL
4 * if equipped
* if equipped
Preproduction model shown.
1090211_13_MKZ_QRG_LE_081412.indd 4-58/14/12 1:49 PM