Replace lift gate bulb LINCOLN NAVIGATOR 2008 Owners Manual
[x] Cancel search | Manufacturer: LINCOLN, Model Year: 2008, Model line: NAVIGATOR, Model: LINCOLN NAVIGATOR 2008Pages: 352, PDF Size: 3.01 MB
Page 80 of 352
Replacing tail/stop/turn/backup lamp bulbs
The tail/stop/turn/backup lamp bulbs are located in the same portion of
the tail lamp assembly, one just below the other. Follow the same steps
to replace either bulb:
1. Make sure the headlamp switch is
in the OFF position.
2. Open the liftgate to expose the
lamp assembly screws.
3. Remove the two screws from the
lamp assembly.
4. Carefully pry the lamp assembly
away from the vehicle, by pulling
the assembly directly straight out, to
expose the bulb socket. DO NOT
TIP THE LAMP ASSEMBLY SIDEWAYS.
5. Rotate the bulb socket counterclockwise and remove from lamp
assembly.
6. Pull bulb straight out of socket and push in the new bulb.
7. Install the bulb socket into the lamp assembly and rotate clockwise.
8. Install the lamp assembly on the vehicle and secure with two screws.
Replacing supplemental tail lamp bulbs
1. Make sure the headlamp switch is in the OFF position.
2. Open the liftgate and remove interior trim panel.
3. Remove four nuts from the lamp
assembly.
4. Carefully pry the lamp assembly
away from the vehicle, by pulling
the assembly directly straight out, to
expose the bulb socket. DO NOT
TIP THE LAMP ASSEMBLY
SIDEWAYS.
5. Rotate the bulb socket
counterclockwise and remove from
lamp assembly.
6. Pull bulb straight out of socket and push in the new bulb.
7. Install the bulb socket into the lamp assembly and rotate clockwise.
2008 Navigator(nav)
Owners Guide (post-2002-fmt)
USA(fus)
Lights
80
Page 81 of 352
8. Install the lamp assembly on the vehicle and secure with four nuts.
9. Install the interior trim panel.
High-mount brakelamp
To change the high-mount
brakelamp bulbs:
1. Remove the two screws holding
the lamp assembly in place.
2. Pull the lamp assembly straight
out.
3. Disconnect the wire harness.
4. Depress the four tabs that hold
the light assembly on, one at a time,
and pull the black bulb carrier away
from the lamp.
5. Pull the old bulb out and replace
with the new bulb.
6. Snap the black bulb carrier into
the lamp assembly.
7. Connect the wire harness.
8. Install the lamp assembly with
two screws.
Replacing license plate lamp bulb
The license plate bulbs are located in the license plate housing assembly
on the liftgate. To change the license plate bulbs:
1. Make sure the headlamp switch is
in the OFF position.
2. Remove the license lamp screw
from the assembly.
3. Pull the lamp down and twist the
bulb socket counterclockwise.
Remove the bulb socket from the
lamp.
4. Pull out the old bulb and push in
the new bulb.
5. Install the bulb socket in the lamp assembly by turning it clockwise.
2008 Navigator(nav)
Owners Guide (post-2002-fmt)
USA(fus)
Lights
81
Page 350 of 352
L
Lamps
autolamp system .......................72
bulb replacement
specifications chart ..................77
daytime running light ...............73
fog lamps ...................................72
headlamps .................................72
headlamps, flash to pass ..........73
interior lamps .....................76, 78
replacing bulbs .........................81
Lane change indicator
(see Turn signal) ........................75
Liftgate ..............119, 122, 130–131
Lights, warning and indicator ....12
anti-lock brakes (ABS) ..........238
Load limits .................................217
Loading instructions .................223
Locks
autolock ...................................124
childproof ................................128
doors ........................................124
Lubricant specifications ...........339
Lug nuts ....................................283
Luggage rack .............................123
Lumbar support, seats .............142
M
Message center .........................106
english/metric button .............113
system check button ..............114
warning messages ...................114
Mirrors ...................................91–92
automatic dimming rearview
mirror ........................................92
fold away ...................................93heated ........................................93
programmable memory ..........132
signal .........................................94
Moon roof ..................................101
Motorcraft parts ........306, 323, 338
N
Navigation system .......................64
O
Octane rating ............................327
Oil (see Engine oil) ..................312
P
Panic alarm feature, remote
entry system ..............................131
Parking brake ............................239
Parts (see Motorcraft parts) ....338
Pedals (see Power adjustable
foot pedals) .................................94
Power adjustable foot pedals .....94
Power deployable running
boards ..........................................94
Power distribution box
(see Fuses) .......................269, 271
Power door locks ......................124
Power liftgate ............................119
Power mirrors .............................92
Power point .................................88
Power steering ..................244–245
fluid, checking and adding ....334
fluid, refill capacity ................339
fluid, specifications .................339
Power Windows ...........................89
2008 Navigator(nav)
Owners Guide (post-2002-fmt)
USA(fus)
Index
350