key LOTUS ELISE 2005 Owner's Manual

WheelsEnsure that only original equipment, or Lotus approved wheel
and tire combinations are fitted. After the car has been used
on track, or in competition conditions, the wheels should be removed and thoroughly inspected for damage.
WARNING: After striking a pothole or kerb, the wheels should be
removed and the wheel and tire thoroughly inspected for
damage. Renew the wheel and /or tire if necessary. Safety
considerations should always be paramount and new parts
fitted in any cases of doubt.
Wheel Bolts The wheel bolts used on the Elise are of a special design to
suit the small diameter fixing tunnels in the wheel centres. The bolts have a 10 spline socket head, for which a special extension
tool is supplied with the car. A 17mm a/f deep socket and 1/2
inch square drive wrench should be applied to the extension tool,
with a tightening torque of 77 lbf.ft (105 Nm) required. To protect against wheel theft, one of the four bolts securing
each wheel is key coded, and requires a corresponding coded
socket wrench and 1/2 inch square drive extension. Rotate the coded socket until full engagement with the bolt head is ensured and take care to maintain the extension tool perpendicular to
the wheel face before applying release torque.
NOTICE: It is not recommended to use hammer action air tools on the coded bolts - use only manual tools.
Both the standard extension and coded socket tools are
stowed in the car tool kit, and should remain with the car at all
times to ensure that servicing may be performed. The key code
included in the tool kit should be recorded and kept safely with
the car documents, in case a replacement socket tool needs
to be ordered.
Wheel Alignment and Tire Balance The wheels on your car were aligned and balanced carefully
during the manufacture of your car to give you the longest tire
life and best overall performance.
Tires & Wheels
126

oh_croft_InD.indd 12620/05/2004 07:59:12ProCarManuals.com

Footwell Sited Fuses Four fuses are secured to the main wiring harness just
ahead of the scuttle beam and accessible from the passenger
footwell.
Fuse Rating CircuitC1 20A Interior fan
C2 15A Wiper motor
C3 7.5A Audio key-in
C4 7.5A A.C. compressor
m248a
Front
Viewed
from
beneath Fusebox ‘C’Electrical
138

oh_croft_InD.indd 13820/05/2004 07:59:15ProCarManuals.com

3. If adjustment is required, the clear cover and mask must be removed from the body. From within the wheelarch, remove
the access panel from the wheelarch liner to expose the
headlamp cover retaining screws. Use the hexagonal key provided in the toolkit (in the rear pocket on the batter y
cover) to release the three socket head retaining screws and washers, and withdraw the cover assembly complete
with rubber edge seal from the body. When refitting, do not overtighten the fixings.
4. To adjust the low beam laterally, adjust the dome headed screw at the upper inboard side of the low beam (uppermost)
lamp, accessed from the front of the lamp. Turn clockwise to
adjust the beam to the right. Optimum setting is 0%. To adjust
the vertical aim of the low beam, adjust the dome headed screw at the lower outboard side of the lamp, accessed
from the front of the lamp. Turn clockwise to raise the beam.
Optimum setting is -1.5%.
5. Repeat for the RH lamp. 6. Centralise the machine on the LH high beam (lowermost) lamp, and switch on the high beams. Check the high beam
alignment which should be centralised with the marker dot on
the machine screen or slightly below the horizontal. Optimum
setting is 0%.
ohs105a
HEADLAMP COVER UNIT SOCKET BOLTS
Electrical
140

oh_croft_InD.indd 14020/05/2004 07:59:16ProCarManuals.com

BULB REPLACEMENT
Headlamp BulbMounted in the front body are the two headlamp units, each
of which houses a halogen projector type low beam lamp
(upper), and a halogen high beam lamp (lower) including the sidelamp bulb. For access to the headlamp bulbs, first remove the clear cover
and mask from the body (see previous pages).
WARNING:
• Allow bulbs to cool before attempting removal, or your fingers could be burnt.
• Halogen bulbs have pressurised gas inside and can burst if you drop or scratch the bulb. You or others could be
injured.
• Be sure to read and follow instructions on the bulb

packaging.
NOTICE: Do not touch a halogen bulb glass envelope with the
fingers, as the greasy deposit left behind will greatly reduce bulb life. Use a paper tissue to handle the bulb.
Low beam bulb: Disconnect the single cable, release the spring wire clip, and withdraw the 55W H1 bulb. On refitting, note that the bulb is keyed to allow only one orientation.
ohs107
Low beam lamp
High beam lamp
Parking lamp bulb
Electrical
142

oh_croft_InD.indd 14220/05/2004 07:59:16ProCarManuals.com

High beam bulb: Disconnect the two cables from the bulb, re-
lease the spring wire clip, and withdraw the 55W H7 bulb. On re
-
fitting, note that the bulb is keyed to allow only one orientation.
Parking lamp: Twist the bulb holder counterclockwise to release
from the main beam lamp, and withdraw the bayonet fitting T4
W bulb.
Front Turn Indicator Lamp Bulbs For access to the front turn indicator bulb, the lamp unit must
be released from the body. Using a suitable stiff rod or screw
-
driver blade inserted through the access hole in the outer top
corner of the air intake aperture, press back the lamp retaining
clip at the front end of the lamp, and withdraw the lamp from the body. Twist the bulb holder counterclockwise to release from the
lamp, and replace the bayonet fitting amber bulb. After replacing the bulb and holder, ensure the rubber seal
is correctly positioned around the lamp. Engage the tongue at
the rear end of the lamp unit with the body flange, and press the
front end of the lamp firmly down until a distinct ‘click’ is heard, indicating engagement of the retaining clip. Pull up on the front
end of the lamp to check security.
Side Repeater Lamp Bulbs The side mar ker lamps mounted on the front and rear
wheelarch lips, each use four longlife LEDs which are not serv
-
iceable. In case of failure, the lamp unit should be replaced by
your dealer.
ohs149
RELEASING FRONT TURN LAMP
Electrical
143

oh_croft_InD.indd 14320/05/2004 07:59:16ProCarManuals.com

LIFTING AND TOWING
Towing Eye A towing eye is stowed in the car tool kit, located in the battery
cover rear pocket. When required, remove the protective bung (if
fitted), and fit the towing eye to its anchorage point in the radiator air intake aperture, screwing fully into the tapped boss.
The eye is provided to aid car recovery, such as winching
onto a flatbed car transporter, but only when the car is able to roll freely. Only in an emergency should the car be towed, and
for the shortest distance necessary, during which time the fol
-
lowing precautions must be taken:
WARNING:
• Use only towing equipment designed specifically for this purpose, or damage to the car may be caused, or you
could be killed or seriously injured.
• Ensure that the key is used to unlock the steering column, and is then left in the lock. Never withdraw the key until
the car is stationary. The steering column will lock when
the key is withdrawn.
• Release the parking brake and ensure that the trans
-
mission is in neutral.
• Comply with all local legislation applicable to cars being
towed.
• Under no circumstances is the car to be secured using
the towing eye.
ohs95
TOWING EYE FITMENT
Lifting & Towing
146

oh_croft_InD.indd 14620/05/2004 07:59:17ProCarManuals.com

INDEX
Access Panels, front service ................................................. 78
Accessories & Modifications, warnings .............................. 150
Air Cleaner Element ............................................................. 113
Air Conditioning ...................................................................... 61
Airbag Safety System ............................................................. 21
Alarm, car security ................................................................ 30
Alternator Belt ...................................................................... 114
Anti-freeze/Corrosion Inhibitor ............................................. 107
Anti-Lock Brake System (ABS) .............................................. 67
Audio Equipment ................................................................... 60
Auxiliary Power Socket .......................................................... 57
Battery ................................................................................. 129
Bodycare ............................................................................... 93
Brake Fluid Reservoir .......................................................... 110
Brake Pads ........................................................................... 111
Break-In, running-in .............................................................. 73
Bulb Replacement ............................................................... 142
Central Door Locking ............................................................. 37
Child Restraints ..................................................................... 26
Cleaning, bodycare ............................................................... 93
Coolant Temperature Display ................................................ 53
Cooling System ................................................................... 106
Dipswitch ............................................................................... 58
Doors, keys ............................................................................ 37
Engine Cover/Trunk Lid ........................................................ 79
Environment, care of ............................................................. 14
Fuel Level Display ................................................................. 52
Fuel Filling ............................................................................. 76
Fuel Requirement .................................................................. 75
Fuses ................................................................................... 135
Gear Lever ............................................................................. 71
Hazard Warning Lamps Switch ............................................ 55
Headlamp Alignment ........................................................... 139
Index
188

oh_croft_InD.indd 18820/05/2004 07:59:26ProCarManuals.com

Headlamp Flasher .................................................................58
Heating & Ventilation .............................................................. 61
Horn ...................................................................................... 60
Idle Speed ............................................................................. 73
Ignition Switch ....................................................................... 44
Immobiliser, engine ................................................................ 31
Inertia Switch ...................................................................... 135
Instrument Illumination .......................................................... 56
Interior Lamp .......................................................................... 41
Jacking Points, lifting you car .............................................. 148
‘Jump’ Starting ..................................................................... 133
Keys ...................................................................................... 29
Lighting Switches .................................................................. 54
Lights On Buzzer .............................................................. 40,55
Lubrication - Dipstick, engine oil level check ....................................... 99
- Engine Oil Change ........................................................ 100
- Oil Filter ......................................................................... 102
- Recommended Lubricants ............................................ 153
- Tran smission Oil ............................................................ 103
Mirrors ................................................................................... 40
Odometer .............................................................................. 53
Parking Brake ........................................................................ 70
Pedals ................................................................................... 66
Queen’s Award ..................................................................... 191
Roof, Hard Top ...................................................................... 85
Roof, Soft Top ....................................................................... 82
Safety Information ....................................................................
7
Seat Be lts .............................................................................. 18
Seats ...................................................................................... 17
Servicing ............... see separate Maintenance Record booklet
Sparking Plugs ..................................................................... 114
Speedometer .......................................................................... 51
Start Button, engine .............................................................. 45
Starting Procedure ................................................................ 72
Index
189

oh_croft_InD.indd 18920/05/2004 07:59:26ProCarManuals.com