light LUCID AIR 2022 Owners Manual

Horn 68Drive Selector 69Using the Drive Selector 69
Vehicle Creep 69
Drive Modes 70
Using Neutral 70
Drive Modes 70
Limited Power Mode 70
Mirrors 72
Adjusting the Exterior Side Mirror Position 72
Interior Rear View Mirror 72
Exterior Lights 73
Exterior Lights Control 73
High Beam Headlights 73
Rear Fog Light 74 Turn Signals 74Hazard Warning Lights 75
Interior Lights 76
Interior Lights 76
Ambient Lighting 76
Wipers and Washers 77
Wipers 77
Washers 77
Brakes 78Braking Systems 78
Anti-Lock Braking System (ABS) 78
Regenerative Braking 79
Vehicle Hold 80
Parking Brake 80
Brake Pad Wear 81
Lucid Stability Control 82
Lucid Stability Control 82
Getting Maximum Range 83
Driving Tips to Maximize Range 83
Heating, Ventilation Air Conditioning 84
Temperature Control 84
Defrost 85
Interior Equipment 86
Sun Visors 86
Glove Box 86

Exterior
Exterior Overview
1. Hood, see Hood Opening and Closing on page 24
2. Exterior side mirror, see Adjusting the Exterior Side Mirror Position on page 72
3. Front multifunction camera
4. Pillar camera
5. Rear view camera, see Rear View Monitoring on page 115
6. Tires and wheels, see Inspecting and Maintaining Tires on page 176
7. Exterior door handle, see Opening Doors from the Outside on page 20
8. Surround View Monitoring cameras, see Blind Spot Display on page 109
9. Trunk, see Trunk Opening and Closing on page 26
10. Charge port door, see Charge Port Door on page 148
11. Recovery eye attachment point, see Pulling the Vehicle onto a Trailer or Transporter on page
198
12. Headlights
Note: For detailed camera locations, see ADAS Component Locations on page 94.
Vehicle Overview7

Hood
Hood Opening and Closing
In the case of an unlatched hood,
the red Door Open warning indicator appears on the Cockpit Panel. If this
occurs, Lucid recommends you stop
the vehicle in a safe location and place the
vehicle in P (Park). Then check if the hood is correctly closed.
If the vehicle is in D (Drive) or R (Reverse) and
the hood is unlatched, it will be highlighted
red.
Opening the hood
Note: All electrical unlatching of the hood is
disabled when the vehicle is in motion.
To electronically open and close the hood: -Use the Lucid mobile app.
- On the Pilot Panel, select
and press
the
hood opening icon.
- On the Pilot Panel, select
>
DOORS and press the hood
opening icon.
- On the Left Pilot Panel, press the
hood opening icon.
- Press and hold the key fob within
6.5 feet (2 m) of the front trunk.
Once you have successfully unlatched the
hood, you may raise it. The hood has two gas
struts to aid in opening and to hold it in the
open position.
Note: In frigid temperatures, you may find that
the gas struts do not hold the hood open as
firmly as they do in warmer temperatures.
Closing the hood automatically
To close the hood using the power-assist
system:
-Use the Lucid mobile app.
- Select
and press the hood
close icon on the Pilot Panel.
- Select
> DOORS and press the
hood close icon on the Pilot Panel.
- Press and release the close button on
the front edge of the frunk.
Automatic movement stop
If anything obstructs the hood to prevent it
from opening or closing, it will stop moving.
Note: The Cockpit Panel alerts you if the hood
stops automatically.
If the hood stops due to an obstruction,
remove it and try to open or close again. If it cannot be opened or closed a second time,
try to operate the hood manually.
Closing the hood manually
Note: Some models may come equipped with
Power Opening and Closing Hood systems.
Opening and Closing24

To reduce the risk of injuries in an accident,
follow these instructions:
-The driver and front passenger position
their seats so that they can correctly
wear the seat belt while being as far
away from the front airbags as possible.
- Sit upright, place both feet on the
floor, and make sure that the seat back
reclines no more than 30 degrees.
- Easily reach the pedals with your feet
and slightly bend your arms while
holding the steering wheel. The distance
between the driver

Curtain airbagsWARNING: Make sure that passengers
do not lean their heads against the
doors. In the event of a collision,
the curtain airbag deploys from the
headliner and may cause injury.WARNING: Never hang or attach
heavy objects from the grab handles
on the headliner. The hooks are for
lightweight garments (not for hard
objects).
The curtain airbags are designed to protect
the head in severe frontal crashes with a lateral component, severe side impacts, orrollovers. They do not inflate in all frontal
impacts and do not inflate alone in a rear
impact.
Note: Curtain airbags can help prevent
occupants from being thrown from the vehicle
in the event of a vehicle rollover.
Obstruction of Airbags
WARNING: Do not allow passengers to
obstruct the operation of the airbags
by placing feet, knees, any other part
of the body, or any other objects in
contact with, or in close proximity to,
an airbag module.WARNING: Do not attach or position
items on an airbag cover that could
interfere with the inflation of the
airbag or be propelled inside your
vehicle and injure occupants.WARNING: Never place your arm over
an airbag cover. A deploying airbag
can cause serious fractures or other
injuries.
For the airbags to correctly deploy,
obstructions cannot intervene between an
airbag and the occupant.
The following are examples of the type
of obstructions that could impede the
correct operation of the airbags or jeopardize
personal safety in the event of an airbag
deployment:
-Accessories attached to or obscuring an
airbag cover (for example, attached to
the roof lining, door pillar trim, or the
front seat backrests)
- Items of hand luggage, or other objects
placed on an airbag cover
- Feet, knees, or any other part of the
anatomy in contact with, or in close
proximity to, an airbag cover
- Head, arms, or any part of the anatomy
in contact with, or in close proximity to,
a seat-mounted side airbag
- Objects (such as items of clothing)
hanging from the handles attached to the headliner
- Objects (such as items of clothing or
cushions) draped over the part of the
front seat containing the airbag
- Seat covers/accessory seat covers over
a front seat; in particular, seat covers
that have not been designed for use
with seat-mounted side airbags. If
in doubt, consult your Lucid Service
Center .Seating & Safety Restraints49

If you think the passenger airbag status is incorrect, check for the following:-Objects lodged underneath the seat
- Objects wedged between the seat cushion and the center console
- Objects hanging off the back off the seat
- Cargo interference with the seat
- Rear-seat passengers pushing or pulling on the front passenger seat
Any of the conditions listed above may cause the occupancy sensor to incorrectly interpret the
weight of the occupant or object as either heavier or lighter than the real weight.
Depending on the input received from the occupancy sensor, the passenger airbag status indicator
operates as follows:Front Passenger Seat OccupancyPassenger Airbag StatusPassenger Airbag Status
IndicatorAirbag SRS Warning
IndicatorCompletely empty/ low-weight
object *1DeactivatedOFF-Child restraint seat with infantDeactivated *2OFF-ChildDeactivated*3OFF-AdultActivated*4ON-System malfunctionDeactivatedOFFON
*1
A low-weight object or occupant is classified as weighing less than 52 lb (23.5 kg). The movement
of a low-weight occupant or object while your vehicle is in motion may cause the status indicator to
switch states occasionally.
*2 Never install a rear-facing child restraint system on the front passenger seat. A forward-facing
child restraint system should only be installed on the front passenger seat when it is unavoidable.
*3 For some children (a child in a seat, booster seat, or convertible seat), the system may not
recognize them as a child. Factors that may affect this can be the physique or posture.
*4 The system judges a person of adult size as an adult. When a smaller adult sits in the front
passenger seat, the system may not recognize them as adults, depending on their physique and
posture.
Note: It is possible to receive an intermittent indicator status with an empty seat. This is part of
the system

High beam headlights activeLow high-voltage battery State of Charge (SoC)12V battery charging system fault detectedHigh temperature detected for high-voltage batteryLow temperature detected for high-voltage battery
Brake System Warning. Call Lucid Service Center.Brake System Warning. Call Lucid Service Center.Excessive brake wear detected
Left turn signal active
Driving & Operating59

Exterior Lights
Exterior Lights Control
The exterior vehicle lights are controlled using
the left lever on the steering column and the
left cockpit panel.
Touch the corresponding icon to operate the exterior lights as follows:
AUTO lightsPosition lightsLow beam headlights
AUTO lights
The low beam headlights will automatically switch On when the ambient light falls below
a pre-defined level. The front and rear position
lights, as well as the license plate lights, are
always on.
The headlights will switch Off when the
ambient light rises above that level.
Note: The lights will switch On whenever the
windshield wipers are operating.
Position lights The position (side marker) lights
indicator is displayed on the Cockpit
Panel whenever the position lights
are On.
Low beams
The low beam indicator is displayed
on the Cockpit Panel whenever the
low beams are On.
Daytime running lights
Note: The functionality and operation of
daytime running lights will vary according to
market requirements.
In regions that require the vehicle

To turn on the high beam headlights, push the
left steering column lever away from you. To
cancel, pull the lever towards you.
The high beam indicator displays
on the Instrument Cluster whenever
high beams are On.
Headlight High Beam Flash
You can flash the headlight high beams even
if the low beams are OFF by pulling the lever
towards you and releasing it.
See High Beam Assist on page 103 for more
information on High Beam assistance.
Rear Fog Light
Note: Regulations concerning the use of fog
lights vary by country.
The rear fog light is considerably brighter than
ordinary tail lights and should only be used to help other road users see your vehicle in
low-visibility conditions such as fog or heavy
snowfall.
Use the left Cockpit Panel to turn the rear fog
lamp On or Off.
The rear fog light indicator is
displayed on the Cockpit Panel
whenever the rear fog light is On.
Note: The rear fog light is automatically turned
Off each time the vehicle is powered On, and
will need to manually turned On if required.
Note: The rear fog lights can be turned on only
when the headlights are manually turned on
or in AUTO mode at night.
Turn Signals
The turn signals are activated by moving the
left steering column lever down to operate the
left turn signals, or up to operate the right
turn signals. If you lightly push the stalk up
or down, it will activate the turn signal only
temporarily, for three flashes.
The turn signals will continue to operate until
automatically canceled by the steering wheel,
or by lightly pushing the steering column lever
in the opposite direction.
Note: Pushing the steering column lever all
the way in the opposite direction switches the
turn signals to the opposite direction instead
of being canceled.
When a turn signal is activated, thecorresponding turn signal indicator
is displayed on the Cockpit Panel.
You will also hear a clicking sound
when the turn signal is operating.
Lane changes
To signal a lane change, momentarily hold the
lever up or down against the spring pressure
and then release; the turn signals will flash
three times to indicate a lane change.
Driving & Operating74

Hazard Warning Lights
Note: The hazard warning lights can be
operated even when a key fob is not in the
vehicle.
To turn on the hazard warning lights, press the switch located on the overhead console.
All turn signals will flash along with the turn
signal indicators on the Center Cockpit Panel.
Press the switch again to switch off the
hazard warning lights.
Note: You should only use hazard warning
lights in an emergency to warn other road
users of a breakdown or other potential
danger. Remember to switch off when the
hazardous situation has been resolved.
After a collision
If you are involved in a collision that causes
the airbags to be deployed, the hazard
warning lights will automatically switch on.
Driving & Operating75