change time MAZDA 323 1992 Workshop Manual Suplement
[x] Cancel search | Manufacturer: MAZDA, Model Year: 1992, Model line: 323, Model: MAZDA 323 1992Pages: 279, PDF Size: 24.15 MB
Page 22 of 279

SCHEDULED MAINTENANCE SERVICES A
SCHEDULED MAINTENANCE SERVICES
MAINTENANCE TABLE
Chafi symbols:
1 : Inspect: Visual examination and/or functional measurement of system’s operation or
performance , A: Adjust: Examination resulting in adjustment or replacement
n
R: Replace or change
T: Tighten
REMARKS
After 80,000 km or 48 months, continue to follow the described maintenance at the recommended intervals.
As for * marked items in this maintenance chart, note the following points.
+ 1 Major service interval at 12 months/20,000 km (12,000 miles).
Lubrication service based on distance only 10,000 km (6,000 miles) not time.
l 2 Adjust or inspect alternator and water pump drive belt, and power steering and air conditioner drive belt
if equipped.
‘3 Replacement of the timing belt is required at every 100,000 km (60,000 mile). Failure to replace the tim-
ing bett may result in damage to the engine.
‘4 tf the vehicle is operated under any of the following conditions, it is suggested that the engine oil and
oil filter be changed more often than the recommended intervals.
a) Driving in dusty conditions. I
:
b) Extended periods of idling or low speed operation. i
i!
c) Driving for a prolonged periods in cold temperatures or regularly driving onty short distances.
*5 If the vehicle is operated in very dusty or sandy areas, inspect and, if necessary, replace more often
than at usual recommended intervals.
l 6 This IS a full function check of all electrical systems, i.e, atl
ltghts. washers (including condition of blades)
electric windows, sunroof, horn etc.
‘7 Replace every two years. $1
‘I
If there has been continuous hard driving, mountain
drivtng, or if the brakes are used extensively or the
vehicle is operated in extremely humid climates, the brake fluid should be changed annually.
Emission Control and Related Systems
The ignition and fuel systems are vitally important to the proper operation of the-emission control and relat-
ed system, as well as for efficient engine operation. It is strongly recommended that all servicing related
to these systems be done by your Authorised Mazda Dealer.
13EOAX-302 -4
I!
A-3
Page 53 of 279

F3 TRUUBtESHOOTlNG GUIDE
IDIAGNOSTiC tNDEX
No. TFtOUBLESHOOTtNG ITEM DESCRIPTtON PAGE
1.
WI/I not crank or cranks slowly Refer to Engine Electrrcal System ‘1
2 Cranks normally but No combustion Engine cranks at normal speed but shows no sign of F3-22
will not start flrlng
3 Partial corn bustlon- Engine cranks at normal speed but shows only par- ‘1
When engine cold tial combustion and will not continue to run
4 Partial combustron- Engine cranks at normal speed and shows partial F3-25
After warm-up combustion but ~111 not continue runnrng after being
hot soaked
Cranks normally but Always Engine cranks at normal speed but rqurres exces- ‘1
hard to start sive cranktng time before starting
When engine cold Same condition as No. 5 when engine IS cold ‘1
Restarts normally after warm-up
After warm-up Same condition as No. 5 after running and betng hot F3-27
soaked
Starts normaNy when cold
1 8 1 Rough idle/
tsl Engine stalls at idle 1 Always [ Engine stalls or vibrates excessively at idle
r - 1 F3-29
r
Before warm-up 1 Engine stalls or vibrates excessively at idle during
I ‘1
10
11
12 After warm-up
When A/C, P/S,
or IX ON
Rough rdle/Englne stalts lus: after starting warm-up
Engine runs normally at idle during warm-up but
stalls or vibrates excessively atter warm-up
Engrne stalls or vtbrates excessrvely at idle when
NC, P/S, or E/L ON
Engine stalts or vibrates excessively lust after starting
tacceleratton from Idle1 F3-3 f
‘1
‘1
I I ’ I
I 13 High Idle speed after warm-up tdle speed excessively hrgh after warm-up ‘1
14 Idle moves up and down/idle hunts Engine speeds up and down periodically at Idle
F3-33
15 Engme stalls on deceleratron Engine unexpectedly stops running durrng or after
F3-35
deceleration
16 Engine statts suddenly (intermrttent) Engine intermittently stops runnrng
F3-36
17 Hesitates/Stumbles on acceleratton Flat spot occurs just after accelerator is depressed,
‘1
or m/Id ierkina occurs dunna acceleration
L I I
t 18 1 Surges while crulsng
1 Unexpected change In engine speed that is usually 1 ‘1
1 repetrtive
19 tack of power
20 Poor acceleration
21 Runs rough durrng deceleration/Backfire
22 Knocktng
23 Fuel odor Performance poor under load when throttle valve IS
wide open
Maximum speed reduced
Performance poor during acceleration
Engtne runs rough during deceleratron, and abnor-
mal combustion occurs in exhaust system
Abnormal combust!on accompanied by audible
“pinging” noise
( Gasoline odor in cabln ‘2
‘2
‘1
‘2
+1
24 Exhaust sulfur smell Exhaust gas has an unusual odor
25 High oil consumption Oil consumption excessive
b
26 Poor fuel economy Fuel economy unsatisfactory
27 A/C does not work
Blower fan operates, but magnetic clutch does not
l 1.. .Refet to 323 Workshop Manual (t 203-l O-89F). l 2...Re#er to 323 4-Wheet Drive Workshop Manual (1229-IO-89L). ‘1
‘2
‘1
l 1
13EOFS327
F3-20 -..
REAR I
--
--
Page 180 of 279

Mazda
323
4WD
Wiring Diagram
Europe (LHD)
FOREWORD
This wiring diagram incorporates the wiring schematics
of the basic vehicle and available optional equipment.
Actual vehicle wiring may vary slightly depending on
optional equipment or local specifications, or both.
All information in this booklet is based on information
available at the time of printing. Mazda Motor Corpora-
tion reserves the right to make changes without pre-
vious notice.
CONTENTS
Mazda Motor Corporation
HIROSHIMA, JAPAN APPLICATION:
This manual is applicable to vehicles beginning with
the Vehicle Identification Numbers(VlN) shown on
the following page.
8 1992 Mazda Motor Corporation
PRINTED IN JAPAN, JAN. ‘92 R
5232-lo-92A