Led MAZDA CX90 2024 Owners Manual

Changing the set vehicle speed using
the accelerator pedal
Depress the accelerator pedal until the
vehicle speed reaches the desired
speed, then press the RES switch up
(SET+) or down (SET-).
The cruise control is temporarily
canceled
The cruise control is temporarily
canceled when one of the following
conditions is met.
The brake pedal is depressed.The CANCEL switch is pressed one
time.
The DSC has operated.The Smart Brake Support (SBS) has
operated.
The frequency of the braking
operation by the cruise control is
high.
If the cruise cont rol is temporarily
canceled, it operates at the previously
set speed by pressing the RES switch.
Tu r n i n g off the cruise control
Press the cruise control switch.
The cruise control standby indication
(white)
/cruise control set
indication (green)
turns off and the
cruise control stops.
Driving
Cruise Control
5-228
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Warnings and Cautions for Using the Rear ViewMonitor
WARNING
Always confirm the safety of the area around the vehicle visually when driving.
The rear view monitor is only designed to assist the driver while reversing. Images
displayed on the display may differ from the actual conditions. Do not rely
completely on the rear view monitor while reversing. Otherwise, the vehicle may
contact an obstruction and cause an accident.
CAUTION
Do not use the rear view monitor in the following locations/situations.
 There is a bump on a road.
 The vehicle is on a road incline.
 Icy or snow-covered slippery roads.
 Tire chains or a temporary spare tire is installed.
 The liftgate is not fully closed.
 When the center display is cold, images may leave trails or the display might be
darker than usual, making it
difficult to check the vehicle surroundings. Always
confirm the safety around the vehicle visually when driving.
Driving
Rear View Monitor
5-230
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Defroster and Floor Vents
Defroster Vents
Fully Automatic ClimateControl
The following functions are
automatically controlled according to
the set temperature.
Airflow temperature controlAirflow amount controlAirflow mode switchingRecirculate/fresh air mode switchingAir conditioning (cooling/
dehumidifying functions) on/off
Seat warmer level selection*
Heated steering wheel operation*
Seat ventilation level selection*
NOTE
To prevent cold airflow immediately
after heating starts when the hybrid
system is cold, the airflow amount is
decreased.
Fully automatic air-conditioning uses
the sunlight and interior temperature
sensors to control the temperature in
the cabin by measuring interior and
exterior temperatures, humidity, and
sunlight. Do not cover the sunlight/
interior temperature sensor.
Sunlight sensor
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-4*Some models.
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

How to Use the FullyAutomatic Climate Control
1. Start the hybrid system.
2.
The AUTO switch indicator light
turns on.
3. Press the temperature setting switch to set the desired temperature.
Each function is automatically
controlled according to the set
temperature.
4. To stop the operation, press the climate control system power
switch.
NOTE
The recommended set temperature
is 22 °C (72 °F).
If any mode selector switch, fan
control switch, or windshield
defroster switch is operated during
auto operation, the AUTO switch
indicator light turns off. The
functions for switches other than
those operated will continue to
operate in auto control.
The power consumption of the air
conditioner changes depending on
the set temperature and the ambient
temperature. If the set temperature is
too low or high, the remaining
distance-to-full discharge shortens.
The climate control system can be
used while charging when the
vehicle power is switched ON.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-7
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Operating Each Switch
AUTO switch
Automatically controlled according to
the set temperature.
Temperature setting switch
How to increase the set temperature
How to decrease the set temperature
NOTE
The set temperature changes in
increments of 0.5 ℃ within a range
of 15 ℃ (60 °F) and 29 ℃ (84 °F).
The set temperature can be quickly
adjusted by pressing and holding the
temperature setting switch.
When the temperature is set to the
lower or upper limit, “Lo” or “Hi” is
displayed.
SYNC (synchronized temperature)
switch
The mode switches between
independent mode and
interconnection mode each time the
switch is pressed.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-8
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Independent mode (indicator light
turned off)
The set temperature can be controlled
independently for the driver's side and
front passenger's side.
Press the driver’s side temperature
setting switch or the front passenger’s
side temperature setting switch to
control the temperature.
Interconnection mode (indicator light
turned on)
The set temperature for the driver's
side and front passenger's side is
controlled simultaneously.
Press the driver's side temperature
setting switch to control the
temperature.
NOTE
The set temperature for the front
passenger's side and the rear (while
the rear climate control system is
ON) changes to that of the driver
when independent mode is switched
to interconnection mode.
When the front passenger’s side
temperature setting switch or the
rear temperature setting switch is
pressed while in interconnection
mode (SYNC switch indicator light
turned on), the mode switches to
independent mode (SYNC switch
indicator light turned off).
A/C switch
The cooling/dehumidifying function
switches between on and off each time
the switch is pressed. The indicator
light turns on while the function is
operating.
NOTE
The air conditioner may not operate
when the ambient temperature falls to
nearly 0 ℃ to protect the system.
Rear window defogger switch
Use to defog the rear window.
Refer to How to Use the Rear Window
Defogger Switch on page 5-79.
Air intake selector switch
The mode is switched between
recirculate mode and fresh air mode
each time the switch is pressed.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-9
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

During the cabin preconditioning
operation, the cooling fan, the
compressor, and the cabin fans
operate, but this does not indicate a
problem.
 The climate control system functions
you can use
differ depending on the
vehicle power position.
Function Vehicle power position
OFF ACC ON
(Hy- brid sys-
tem off) ON
(Hy- brid sys-
tem on)
Air circulation — — X X
Cooling/heating — — X
*1X
Climate Control
Timer X———
Remote climate
control X———
X: Available
—: Not available
*1 The cooling/heating function can
be used only while charging.
NOTE
The recommended set temperature
is 22 °C (72 °F). If you set an
extremely high or low temperature,
power consumption will increase
and the charging time will take
longer.
If you operate the cabin
preconditioning while the charge
connector is connected, you can
reduce the electric power
consumption of the high voltage
battery.
While the cabin preconditioning is
operating , the indicator light for the
climate control power switch turns
on.
The cabin preconditioning operates
for 20 minutes. If you set the
departure time using the climate
control timer, set it 20 minutes or
later from the current time and if you
want to make several settings, space
them out at intervals of 30 minutes
or longer.
How to set the Climate Control Timer
1. Select “Settings” from the Mazda Connect home screen.
2. Select “EV Settings”.
3. Select “Climate Control Timer”.
4. Select the item setting you would like to change from the displayed
content.
5. Switch the vehicle power OFF.
Climate Control Timer
Allows climate control to adjust cabin
temperature before driving.
Function Available setting changes
1 ---
Enable,
Disable
*1Edit,
Delete*2
2 ---
3 ---
4 ---
5 ---
6 ---
7 ---
*1 If an item selected using the cursor has been set, the item can be
enabled or disabled.
*2 Settings can be “Edit”/“Delete” bysliding an item selected using the
cursor to the right.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-13
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Airflow selection
Dashboard Vents
Dashboard and Floor Vents
Floor Vents
Fully Automatic ClimateControl System
The following functions are
automatically controlled according to
the set temperature.
Airflow temperature controlAirflow amount controlAirflow mode switching
NOTE
To p r e v e n t c o l d airflow immediately
after heating starts when the hybrid
system is cold, the airflow amount is
decreased.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Rear)
6-16
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

How to Use the FullyAutomatic Climate Control System
(Operation from front seats)
1. Start the hybrid system.
2. Turn the front climate control system on.
3.
The indicator light turns on.
NOTE
When the rear climate control
system is turned on using the Rear
climate control system power
switch, each setting is the setting
before the rear climate control
system was turned off.
4.
The indicator light turns on and the
screen changes to the rear climate
control system operation screen.
5. Press the temperature setting switch to set the desired temperature.
Each function is automatically
controlled according to the set
temperature.
NOTE
The following switches cannot be
operated while the rear climate
control system operation screen is
displayed.
Air intake selector switchFront passenger’s side
temperature setting switch
A/C switchIf none of the following switches
are operated, the screen returns
to the front climate control
system operation screen after 10
seconds.
AUTO switchDriver’s side temperature
setting switch
SYNC (synchronized
temperature) switch
Mode selector switchFan control switch
6. To stop the operation, press the climate control system power
switch.

Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Rear)
6-19
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

(Operation from rear seats)
1. Start the hybrid system.
2.
3.
4. Press the temperature setting switchto set the desired temperature.
Each function is automatically
controlled according to the set
temperature.
NOTE
The recommended set
temperature is 22 ℃(72 °F).
If mode selector switch or fan
control switch is operated during
auto operation, the AUTO switch
indicator light turns off.
If the AUTO switch is pressed
while the front A/C switch is off,
the rear air conditioner operates
only to circulate air.
5. To stop the operation, press the climate control system power
switch.
Operating Each Switch
AUTO switch
Automatically controlled according to
the set temperature.
Temperature setting switch
How to increase the set temperature
How to decrease the set temperature
NOTE
The set temperature changes in
increments of 0.5 ℃ within a range
of 15 ℃ (60 °F) and 29 ℃ (84 °F).
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Rear)
6-20
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04