remove seats MAZDA MIATA 1991 Factory Service Manual

Inspection
Check for damage, oil leakage and abnormal noise. Check rubber parts for deterioration or damage. Inspect coil
spring for signs of fatigue or damage. Replace parts as needed.
Reassembly
Clamp shock absorber in vise. Install coil spring and components in reverse order of disassembly. Ensure coil
spring is well seated in upper and lower spring seats.
Installation
To install, reverse removal procedure. Final tighten all bolts with vehicle resting on ground and suspension
unloaded. See appropriate See SPECIFICATIONS & PROCEDURES article in the WHEEL ALIGNMENT
section for checks and adjustments.
STRUT ASSEMBLY
Removal
1. Raise and support vehicle. Remove wheel assembly. Disconnect brake line from strut assembly. Remove
bolts attaching steering knuckle arm to strut assembly.
2. Disconnect harness connector from actuator (if equipped). Remove bolts, actuator and actuator mounting
bracket from upper mounting block. Remove nuts attaching upper strut assembly to body panel. Remove
strut assembly.
Disassembly
Clamp strut in vise. Compress coil spring using coil spring compressor. Remove piston lock nut. Slowly release
compressor tension. Remove components. Remove coil spring. Remove strut from vise.
Inspection
Check strut tube for cracks, damage, oil leakage and abnormal noise. Check rubber parts for deterioration or
damage. Inspect coil spring for signs of fatigue or damage. Check actuator control rod of strut assembly for
smooth rotation (if equipped). Replace parts as needed.
Reassembly
Clamp strut in vise. Install coil spring and components in reverse order of disassembly. Ensure that coil spring
is well seated in upper and lower spring seats. On MX-6 and 626, ensure upper spring seat positioning hole
faces inside of vehicle. NOTE: Prior to removing strut-to-steering knuckle bolts, make an alignment mark for
reassembly reference. Note position of mounting mark on top of strut assembly
before removing strut.

1991 Mazda MX-5 Miata
SUSPENSION - FRONT 1990-91 SUSPENSION Front
Microsoft
Sunday, July 05, 2009 2:08:54 PMPage 10 © 2005 Mitchell Repair Information Company, LLC.

drive axle lock nut. Check axial play. See WHEEL BEARING under ADJUSTMENTS & INSPECTION.
STRUT ASSEMBLY
Removal & Disassembly
1. Raise vehicle and remove fuel tank filler pipe protector. Remove rear wheel assembly. Remove stabilizer
bar nut and bolt. Remove 2 upper strut mount-to-body nuts. Remove lower strut bolt. Loosen upper and
lower arm bolts. Lower arms and remove strut assembly.
2. Clamp strut securely in soft-jawed vise. Compress coil spring. Remove lock nut and washer. Remove
remaining components and note order for reassembly.
Inspection
Check strut for leaks or abnormal noise. Inspect parts for wear or damage. Check for loose installation of bolts
and nuts. Replace parts as necessary.
Reassembly & Installation
To reassemble, reverse disassembly procedure. To install, reverse removal procedure. Ensure coil spring is well
seated in upper and lower seats. Check rear wheel toe-in. See SPECIFICATIONS & PROCEDURES article in
the WHEEL ALIGNMENT section.
LOWER ARM
Removal
Raise and support vehicle. Remove wheel assembly. Remove stabilizer bar control link nut and bolt. See Fig.
1 . Remove lower strut bolt. Remove lower arm-to-crossmember bolts. Remove lower arm-to-knuckle bolts.
Remove lower arm. Inspect arm for dama
ge, cracks and deformation. Check for damaged or worn bushings.

1991 Mazda MX-5 Miata
SUSPENSION - REAR 1991 SUSPENSION Rear
Microsoft
Sunday, July 05, 2009 2:09:35 PMPage 2 © 2005 Mitchell Repair Information Company, LLC.