driver seat adjustment MAZDA MODEL 3 4-DOOR 2008 Owners Manual
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2008, Model line: MODEL 3 4-DOOR, Model: MAZDA MODEL 3 4-DOOR 2008Pages: 412, PDF Size: 5.26 MB
Page 18 of 412
Black plate (18,1)
CAUTION
When returning a rear-reclined
seatback to its upright position,
make sure you hold onto the
seatback with your other hand while
operating the lever. If the seatback is
not supported, it will flip forward
suddenly and could cause injury.
qHeight Adjustment (Driver's Seat)í
By moving the seat lever up or down, the
seat bottom height can be adjusted.
DownUp
q
Lumbar Support Adjustment
(Driver's Seat)í
Move the lever forwards to adjust the
lumbar support as required.
qSeat Warmerí
The front seats are electrically heated. The
ignition must be in the ON position.
Press the switch to turn the seat warmer
on or off. When the switch is in the ON
position, the indicator light will come on.
2-4
Essential Safety Equipment
íSome models.
Seats
Mazda3_8Y64-EA-08A_Edition1 Page18
Tuesday, November 27 2007 9:0 AM
Form No.8Y64-EA-08A
Page 20 of 412
Black plate (20,1)
Front Seats (Electrically
Operated Seats)
WARNING
Do not modify or replace the front
seats:Modifying or replacing the front seats
such as replacing the upholstery or
loosening any bolts is dangerous. The
front seats contain air bag
components essential to the
supplemental restraint system. Such
modifications could damage the
supplemental restraint system and
result in serious injury. Consult an
Authorized Mazda Dealer if there is
any need to remove or reinstall the
front seats.
Do not drive with damaged front seats: Driving with damaged front seats is
dangerous. A collision, even one not
strong enough to inflate the air bags,
could damage the front seats which
contain essential air bag
components. If there was a
subsequent collision, an air bag may
not deploy which could lead to
injuries. Always have an Authorized
Mazda Dealer inspect the front seats,
front seat belt pretensioners and air
bags after a collision.
CAUTION
ØThe seat-bottom power
adjustment is operated by motors.
Avoid extended operation because
excessive use can damage the
motors.
Ø To prevent the battery from
running down, avoid using the
power adjustment when the
engine is stopped. The adjuster
uses a large amount of electrical
power.
Ø Don't use the switch to make more
than one adjustment at a time.
qSeat Slide (Driver's Seat)
To slide the seat, move the slide lifter
switch on the outside of the seat to the
front or back and hold it. Release the
switch at the desired position.
2-6
Essential Safety Equipment
Seats
Mazda3_8Y64-EA-08A_Edition1 Page20
Tuesday, November 27 2007 9:0 AM
Form No.8Y64-EA-08A
Page 21 of 412
Black plate (21,1)
qSeat Recline (Driver's Seat)
WARNING
Do not drive with the seats reclined:
Sitting in a reclined position while the
vehicle is moving is dangerous
because you don't get the full
protection from seat belts. During
sudden braking or a collision, you
can slide under the lap belt and
suffer serious internal injuries. For
maximum protection, sit well back
and upright.
Always sit in a front passenger seat
properly with the seatback upright and
feet on the floor: If your vehicle is equipped with front
passenger seat weight sensors,
sitting in the front passenger seat
improperly out of position or with the
seatback reclined too far while the
vehicle is moving is dangerous as it
can take off weight from the seat
bottom and affect the weight
determination of the front passenger
sensing system. As a result the front
passenger will not have the
supplementary protection of the air
bag and seat belt pretensioner, which
could cause result in serious injury.
Always sit upright against your
seatback, with your feet on the floor. Change the seatback angle by pressing the
front or rear side of the reclining switch.
Release the switch at the desired position.
qHeight Adjustment (Driver's Seat)
The seat height can be adjusted by
moving the switch up or down.
Essential Safety Equipment
Seats
2-7
Mazda3_8Y64-EA-08A_Edition1 Page21
Tuesday, November 27 2007 9:0 AM
Form No.8Y64-EA-08A
Page 22 of 412
Black plate (22,1)
qLumbar Support Adjustment
(Driver's Seat)
Move the lever forwards to adjust the
lumbar support as required.
qSeat Warmerí
The front seats are electrically heated. The
ignition must be in the ON position.
Press the switch to turn the seat warmer
on or off. When the switch is in the ON
position, the indicator light will come on.
2-8
Essential Safety Equipment
íSome models.
Seats
Mazda3_8Y64-EA-08A_Edition1 Page22
Tuesday, November 27 2007 9:0 AM
Form No.8Y64-EA-08A