key MAZDA MODEL 6 2009 (in English) Repair Manual

Black plate (312,1)
Interior Lights
qIlluminated Entry System
When the illuminated entry system
operates, the overhead light (switch is in
the DOOR position), the courtesy lights
and the ground illumination light turn on
for:
lAbout 30 seconds after the driver's
door is unlocked and the ignition key is
removed (without advanced key) or the
ignition is switched off (with advanced
key).
lAbout 15 seconds after all doors are
closed.
(With Advanced key)
About 5 seconds after all doors when
the advanced key is outside of the
vehicle.
lAbout 15 seconds after the ignition is
switched off (LOCK) and the ignition
key removed (without advanced key)
with all doors closed.
The light also turns off when:
lThe ignition is switched on and all
doors are closed.
lThe driver's door is locked.
NOTE
lBattery saver
If any door is left opened, the light turns off
after about 30 minutes to save the battery.
The light turns on again when the ignition
is switched on, or when any door is opened
after all doors have been closed.
lThe operation of the illuminated entry
system can be changed.
Refer to Personalization Features on page
10-8.
q Overhead Lights
Front
Rear
Switch
Position Overhead Lights
Light off
lLight is on when any door is openlLight is on or off when the
illuminated entry system is on
Light on
6-94
Interior Comfort
Interior Equipment
Mazda6_8Z64-EA-08H_Edition1 Page312
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (320,1)
Storage Compartments
WARNING
Keep storage boxes closed when
driving:Driving with the storage boxes open
is dangerous. To reduce the
possibility of injury in an accident or
a sudden stop, keep the storage
boxes closed when driving.
CAUTION
Do not leave lighters or eyeglasses in
the storage boxes while parked under
the sun. A lighter could explode or
the plastic material in eyeglasses
could deform and crack from high
temperature.
qOverhead Console
This console box is designed to store a
garage door opener or other accessories.
Push and release to open.
qStorage Pocket
To open, push the release catch down and
pull the lid downward.
qGlove Box
To open the glove box, pull the latch
toward you.
Insert the key (auxiliary key
*) and turn it
clockwise to lock, counterclockwise to
unlock.
* Advanced key equipped vehicle
Unlock
Lock
6-102
Interior Comfort
Interior Equipment
Mazda6_8Z64-EA-08H_Edition1 Page320
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (323,1)
Accessory Sockets
Only use genuine Mazda accessories or
the equivalent requiring no greater than
120 W (DC 12 V, 10 A).
Front
The ignition switch must be in the ACC
or ON position.
With Advanced Key
To use, press the cover and open it.
Without Advanced Key
Center Console
The accessory sockets can be used
regardless of the position of the ignition
switch.
CAUTION
To prevent accessory socket damage
or electrical failure, pay attention to
the following:
ØDo not use accessories that require
more than 120 W (DC 12 V, 10 A).
Ø Do not use accessories that are not
genuine Mazda accessories or the
equivalent.
Ø Close the cover when the accessory
socket is not in use to prevent
foreign objects and liquids from
getting into the accessory socket.
Ø Correctly insert the plug into the
accessory socket.
Ø Do not insert the cigarette lighter
into the accessory socket.
Noise may occur on the audio
playback depending on the device
connected to the accessory socket.
NOTE
To prevent discharging of the battery, do not
use the socket for long periods with the engine
off or idling.
Interior Comfort
Interior Equipment
6-105
Mazda6_8Z64-EA-08H_Edition1 Page323
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (332,1)
WARNING
Use only the front and rear jacking
positions recommended in this manual:Attempting to jack the vehicle in
positions other than those
recommended in this manual is
dangerous. The vehicle could slip off
the jack and seriously injure or even
kill someone. Use only the front and
rear jacking positions recommended
in this manual.
Use only the jack provided with your
Mazda: Using a jack that is not designed for
your Mazda is dangerous. The vehicle
could slip off the jack and seriously
injure someone.
Never place objects under the jack: Jacking the vehicle with an object
under the jack is dangerous. The jack
could slip and someone could be
seriously injured by the jack or the
falling vehicle.
4. Turn the lug wrench clockwise and raise the vehicle high enough so that
the spare tire can be installed. Before
removing the lug nuts, make sure your
Mazda is firmly in position and that it
cannot slip or move.
5. Remove the lug nuts by turning themcounterclockwise; then remove the
wheel and center cap.
qLocking Lug Nutsí
If your vehicle has optional antitheft
wheel lug nuts, one on each wheel will
lock the tires and you must use a special
key to unlock them. This key is attached
to the lug wrench and is stored with the
spare tire. Register them with the lock
manufacturer by filling out the card
provided in the glove box and mailing it
in the accompanying envelope. If you lose
this key, consult an Authorized Mazda
Dealer or use the lock manufacturer's
order form, which is with the registration
card.
Special key
Antitheft lug nut
To remove an antitheft lug nut
1. Obtain the key for the antitheft lug nut.
2. Place the key on top of the nut, and be
sure to hold the key square to it. If you
hold the key at an angle, you may
damage both key and nut. Don't use a
power impact wrench.
3. Place the lug wrench on top of the key and apply pressure. Turn the wrench
counterclockwise.
7-8
In Case of an Emergency
íSome models.
Flat Tire
Mazda6_8Z64-EA-08H_Edition1 Page332
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (333,1)
To install the nut
1. Place the key on top of the nut, and besure to hold the key square to it. If you
hold the key at an angle, you may
damage both key and nut. Don't use a
power impact wrench.
2. Place the lug wrench on top of the key, apply pressure, and turn it clockwise.
qMounting the Spare Tire
1. Remove dirt and grime from the
mounting surfaces of the wheel and
hub, including the hub bolts, with a
cloth.
WARNING
Make sure the mounting surfaces of
the wheel, hub and lug nuts are clean
before changing or replacing tires: When changing or replacing a tire,
not removing dirt and grime from the
mounting surfaces of the wheel, hub
and hub bolts is dangerous. The lug
nuts could loosen while driving and
cause the tire to come off, resulting in
an accident.
2. Mount the spare tire. 3. Install the lug nuts with the beveled
edge inward; tighten them by hand.
WARNING
Do not apply oil or grease to lug nuts
and bolts and do not tighten the lug
nuts beyond the recommended
tightening torque: Applying oil or grease to lug nuts and
bolts is dangerous. The lug nuts
could loosen while driving and cause
the tire to come off, resulting in an
accident. In addition, lug nuts and
bolts could be damaged if tightened
more than necessary.
4. Turn the lug wrench counterclockwise and lower the vehicle. Use the lug
wrench to tighten the nuts in the order
shown.
In Case of an Emergency
Flat Tire
7-9
Mazda6_8Z64-EA-08H_Edition1 Page333
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (337,1)
Starting a Flooded Engine
Except 3.7-liter engine
If the engine fails to start, it may be
flooded (excessive fuel in the engine).
Follow this procedure:
(Without Advanced Keyless Entry &
Push Button Start System)
1. If the engine does not start within fiveseconds on the first try, turn the key to
the LOCK position, wait ten seconds
and try again.
2. Depress the accelerator all the way and hold it there.
3. Turn the ignition switch to the START position and hold it there ―for up to
ten seconds. If the engine starts, release
the key and accelerator immediately
because the engine will suddenly rev
up.
4. If the engine fails to start, crank it without depressing the accelerator ―for
up to ten seconds.
(With Advanced Keyless Entry & Push
Button Start System)
1. If the engine does not start within five seconds on the first try, wait ten
seconds and try again.
2. Depress the accelerator all the way and hold it there.
3. Depress the clutch pedal then press the push button start. If the engine starts,
release the key and accelerator
immediately because the engine will
suddenly rev up.
4. If the engine fails to start, crank it without depressing the accelerator. If the engine still does not start using the
above procedure, have your vehicle
inspected by an Authorized Mazda
Dealer.
In Case of an Emergency
Emergency Starting
7-13
Mazda6_8Z64-EA-08H_Edition1 Page337
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (392,1)
DESCRIPTIONFUSE
RATING PROTECTED COMPONENT
18 P.SEAT (D) 30 A Power seat
í
19 BTN 30 A For protection of various circuits
20 IG KEY2 40 A Starting system
21 BLOWER 40 A Blower motor
22 FUEL PUMP 25 A Fuel pump
23 ENGINE2 15 A Engine control system
24 EGI INJ 15 A Injector
25 PCM 10 A Engine control system
26 ENGINE 10 A
*1Engine control system
20 A*2
27 IG 20 A For protection of various circuits
28 TCM 20 A TCMí
29ESCL 10 A Electronic steering lock
30 IG KEY1 40 A For protection of various circuits
31 MAIN 125 A For protection of all circuits
32 DRL 20 A DRL
í
33 HAZARD 10 A Hazard warning flashers
34 ENG+B 10 A PCM
35 STOP 10 A Brake lights
36 HORN 15 A Horn
37 HEAD HI RH 15 A Headlight-high beam (Right)
38 HEAD LO RH 10 A Headlight-low beam (Right)
39 HEAD HI LH 15 A Headlight-high beam (Left)
40 HEAD LO LH 10 A Headlight-low beam (Left)
*1 2.5-liter engine
*2 3.7-liter engine
8-50
Maintenance and Care
íSome models.
Owner Maintenance
Mazda6_8Z64-EA-08H_Edition1 Page392
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (421,1)
Keyless entry system
Customer Information and Reporting Safety Defects
Type Approval of Equipment
9-21
Mazda6_8Z64-EA-08H_Edition1 Page421
Wednesday, June 25 2008 10:6 AM
Form No.8Z64-EA-08H

Black plate (454,1)
Personalization Features
The following“Personalization Features ”are possible. These settings can only be changed by an Authorized
Mazda Dealer.
Setting FunctionInitial Setting After Setting Change
Auto headlight on/off Adjusts headlight illumination on/off timing
based on surrounding lightness/darkness 2000
―4000 lx 1000 ―2000 lx
Auto headlight off Time required for headlights to turn off after
ignition is switched off 30 seconds 0/60/120 seconds
Turn indicator Sets beep sound volume level HighLow
Blind spot warning Deactivates warning beep function Activated Deactivated
Illumination entry Time required for interior lamp to turn off
automatically after all doors are closed
15 seconds 7.5/30/60 seconds
Deactivates function that allows interior lamp
to illuminate automatically when ignition is
switched off Activated Deactivated
Deactivates function that allows interior lamp
to illuminate automatically when doors are
unlocked Activated Deactivated
Time required for interior lamp to turn off
automatically
(prevents battery depletion when a door is
open/ajar) 30 minutes 10 minutes
Smart turn Activates function that allows turn signal lights
to flash three times with momentary turn switch
operation (when changing lanes)
Deactivated Activated
Keyless entry Selects unlocking method with the retractable
key
Press×2
Press×1
Time required for doors to relock automatically
after unlocking with transmitter 30 seconds 60/90 seconds
Deactivates function that allows horn to sound
automatically when doors are locked by
pressing transmitter two consecutive times Activated Deactivated
10-8
Personalization Features
Mazda6_8Z64-EA-08H_Edition1 Page454
Wednesday, June 25 2008 10:6 AM
Form No.8Z64-EA-08H

Black plate (455,1)
SettingFunctionInitial Setting After Setting Change
Advanced keyless
entry Activates function to automatically lock doors
when leaving vehicle
(with key being carried away)
Deactivated Activated
Deactivates advanced key remaining battery
level warning light in instrument cluster Activated Deactivated
Adjusts sound volume of answer-back beep
during keyless entry system operation Low High/Deactivated
Adjusts sound volume of warning beep for
advanced keyless entry system High
Low
Chooses whether permission is given to open
trunk when advanced keys are both inside trunk
or outside vehicle Permitted Not permitted
Deactivates function that allows power supply
to turn off automatically when ignition has been
switched to ACC for a long period of time Activated Deactivated
Selects a transition pattern in which ignition
position can be switched when pressing push
button start ON> Off ON> ACC> Off
Deactivates advanced key function Activated Deactivated
Selects door unlocking method with the door
handle sensor and/or the request switch. 1. Touch the
handle, and only
the driver's door
unlocks.2. Touch the handle,
and all doors unlock./3.
Press the request
switch once to unlock
driver's door. Press
again to unlock the
rest./4. Touch the
handle to unlock
driver's door, then
press the request
switch to unlock the
rest.
The following “Personalization Features ”can be changed by customer.
Setting FunctionInitial Setting After Setting Change
Welcome sound Deactivates welcome sound function 6-28 Activated Deactivated
Personalization Features
10-9
Mazda6_8Z64-EA-08H_Edition1 Page455
Wednesday, June 25 2008 10:6 AM
Form No.8Z64-EA-08H