34
Fuel door Rele ase (located on floor next to driver’s seat)
To open, pull the remote fuel
door release.
NOTE :
Fuel requirement 87 Octane.
Fuel d oor
To avoid scratching the paint
during refueling, secure the fuel
filler cap tether over the hook
as shown.
ALUMINUM W hEEL CARE
Your aluminum wheels have a
protective coating on them. Only
use a mild soap or neutral detergent
with a sponge or soft cloth to clean
them. Using a wire brush, polishing
compound, solvent, or any type of
abrasive cleaner may damage the
protective coating.
genuine Mazda Accessory
Wheel Locks are available at
your Mazda dealer. g
enuine Mazda
Accessory
Chrome or Pearl
Satin Finish Fuel
Filler doors are
available at your
Mazda dealer.
Seats
ELECTRONICALLY OPERATE d d RIVER SEAT CONTROLS
Slide/Tilt Switch
Seat can be moved back and forth, raised,
lowered, or tilted with this control.
Lumbar Adjustment
Rotate clockwise to
increase support and
counterclockwise to
decrease support.
Recline Switch
Push forward or backward
to adjust seatback angle.
Memor y Seat Switch
To Program the d river’s Seat Position
1 Park vehicle.
2 Adjust seat to desired position using the slide/tilt and recline switches.
3 While pushing the memory seat SET button, push one of the three
programming buttons until a beep is heard. Programming is now
complete. Program the remaining two buttons as desired.
NOTE: You can also program one seat position for each advanced key/retractable
type key used with the vehicle. See Owner’s Manual for programming instructions.
To Move the Seat to a Programmed Position
• With driver’s door OPEN and ignition OFF , push and release one
of the programmed buttons (1, 2, or 3) when entering the vehicle.
OR
• With driver’s door CLOSE d and ignition ON, push and hold one of
the programmed buttons (1, 2, or 3).
NOTE:
Memory seat functions DO NOT operate when driver’s door is OPEN and
ignition is ON, when driver’s door is CLOSED and ignition is OFF, or when the vehicle
is in motion.
www.MazdaUSA.com
927630_12a_Mazda6_SSG_041911b.indd 4-54/19/11 2:29 PM
