check engine light MAZDA MODEL 626 2001 Owners Manual

Form No. 8P95-EA-00G
How to Use This ManualHAZARD WARNINGFLASHER
SEAT BELTS
FLOOR
FLOOR
DEFROSTING
DEFROSTING
REAR WINDOW DEFROSTER
WINDSHIELD
WIPER & WASHER
LIGHTER
HORN
WASHER FLUID
CHECK ENGINE LIGHT

Form No. 8P95-EA-00G
Knowing Your Mazda
3-23
NOTE•Signals from a TV or radio
station, or from a transceiver or
a mobile telephone, could
interfere with your immobilizer
system. If you are using the
proper key and your engine
fails to start, check the warning
light. If it is flashing, turn the
key to the OFF position and try
again. If the engine doesn’ t start
after 3 or more tries, contact an
Authorized Mazda Dealer.
(Continued)
• If the warning light flashes
continuously while you are
driving, don’ t shut off the
engine. Go to an Authorized
Mazda Dealer and have it
checked. If you shut off the
engine while the light is
flashing you won’ t be able to
restart it.
J94S3001 Operation
When you start the engine with a key
the system recognizes, the system will
allow the engine to continue running.
However, if someone attempts to start
the engine with an unrecognized key,
the system will stall the engine

Form No. 8P95-EA-00G
Knowing Your Mazda
3-31
015-3AE
WARNING
!
Fuel Spray:Fuel spray is dangerous. Fuel can
burn skin and eyes and cause
illness when ingested. Fuel spray
happens when there is pressure in
the fuel tank and the fuel cap is
removed too quickly. When
removing the fuel cap, loosen the
cap slightly and wait for any
hissing to stop. Then remove it.
WARNING
!
Fuel Vapor:Fuel vapor is dangerous. It could
be ignited by sparks or flames;
causing serious burns and
injuries. Before refueling, stop
the engine. And always keep
sparks and flames away from the
filler neck.
015-4AE
CAUTION
!
Always use only a designated
Mazda fuel cap or an approved
equivalent, available at Authorized
Mazda Dealers. The wrong cap
can result in a serious malfunction
of the fuel and emission control
systems. If may also cause the
check engine light in the
instrument cluster to appear.

Form No. 8P95-EA-00G
Knowing Your Mazda3-32
015-5AE
CAUTION
!
Make sure the fuel-filler cap is
tightened securely. The check
engine light comes on when the
cap isn’ t tightened securely. If the
light remains on (even after you
have tightened the cap securely,
driven, and restarted the engine
several times), it may indicate a
different problem. Contact an
Authorized Mazda Dealer as soon
as possible.
 022-1FE
Steering WheelJ94A2052_aTilt wheel
release lever Tilt Wheel
To change the angle of the steering
wheel, stop the vehicle, pull the tilt
wheel release lever on the left side of
the steering column down, adjust the
wheel, then push the release lever up
to lock the column. After adjusting, push the wheel up and
down to be certain it’
s locked before
driving.
WARNING
!
Adjusting the Tilt Wheel:Adjusting the tilt wheel while the
vehicle is moving can be
dangerous. Moving it up and
down can very easily cause the
driver to abruptly turn to the left
or right. This can lead to loss of
control or an accident. Never
adjust the tilt wheel while the
vehicle is moving.

Form No. 8P95-EA-00G
Protecting Your Mazda4-8
Q034-3BE
After Getting In
• Are all doors closed and locked?
• Are the inside and outside mirrors
adjusted?
• Is everyone’ s seat belt fastened?
• Do all the lights work?
• Check all gauges.
• Check all warning lights when the
ignition switch is turned to the ON
position. •
Release the parking brake and
make sure the brake warning light
goes off.
Always be thoroughly familiar with
your Mazda.

035-1AE
Break-In PeriodNo special break-in is necessary, but a
few precautions in the first 1,000 km
(600 miles) may add to the
performance, economy, and life of
your Mazda.
• Don’ t race the engine.
• Don’ t maintain one constant speed
for long periods.
• Avoid unnecessary hard stops.
• Avoid full-throttle starts.

Form No. 8P95-EA-00G
Driving Your Mazda5-2

042-1CE
Ignition Switch PositionsWithout immobilizer
system
J94A4001A
 ON
This is the normal running position
after the engine is started. The warning
lights (except brakes) should be
inspected before the engine is started
(page 5-35).
With immobilizer
system
J94S5001
 START
The engine is started in this position. It
will crank until you release the key;
then it returns to the ON position. The
brake warning light can be checked
after the engine is started (page 5-35). 
ACC (Accessory)
The steering wheel unlocks and some
electrical accessories will operate.
 LOCK
The steering wheel locks to protect
against theft. Only in this position can
the key be removed.

Form No. 8P95-EA-00G


Driving Your Mazda5-36

Q053-2GE
 Brake System Warning
Light
This warning has two functions.
 Parking brake warning
The light comes on when the parking
brake is applied with the ignition
switch in the START or ON position.
It goes off when the brake is fully
released.
 Low brake fluid level warning
If the light stays on after the parking
brake is fully released, you may have a
brake problem. If it stays on:
1. Be sure the parking brake is fully
released.
2. Check the light. If this light is still on, drive to the
side of the road and park off the
right-of-way.
You may notice that the pedal is
harder to push or that it may go
closer to the floor. In either case, it
will take longer to stop the vehicle.
3. With the engine stopped, check the brake fluid level immediately and
add fluid as required (page 8-25). 4. After adding fluid, check the light
again.
If the warning light remains on, or
if the brakes do not operate
properly, do not drive the vehicle.
Have it towed to an Authorized
Mazda Dealer.
Even if the light goes off, have
your brake system inspected as
soon as possible.

Form No. 8P95-EA-00G
Driving Your Mazda5-383. If it’s OK, the charging system has
a problem. Consult an Authorized
Mazda Dealer as soon as possible.
053-6AE
CAUTION
!
Don’ t drive with a loose or broken
alternator belt. The engine could
overheat because this belt also
drives the water pump.

053-7EE
 Engine Oil Pressure
Warning Light
This warning light indicates low
engine oil pressure.
If the light comes on while driving:
1. Drive to the side of the road and park off the right-of-way.
2. Turn off the engine and inspect the engine oil level (page 8-17). If it’ s
low, add oil. 3. Check the light.
If the light remains on even after
you add oil, have your vehicle
towed to the nearest service station
or to an Authorized Mazda Dealer.
CAUTION
!
Don’ t run the engine if oil pressure
is low. It could result in extensive
engine damage.

Form No. 8P95-EA-00G


*Some models.Driving Your Mazda
5-39

053-55A1E
 Traction Control System
(TCS) Warning Light*
This warning light stays on for a few
seconds when the ignition switch is
turned to the ON position.
The light flashes when the system
regulates engine torque and will stay
on if the system malfunctions. If it
stays on while the system is operating,
consult an Authorized Mazda Dealer.
053-8BE
 Low Fuel Warning Light
This warning signals that the fuel tank
will soon be empty. Get fuel as soon as
possible.

053-9FE
 Check Engine Light
If this light comes on while driving,
the vehicle may have a problem. It is
important to note the driving
conditions when the light came on and
consult an Authorized Mazda Dealer. The check engine light may come on
in the following cases:
•
The fuel tank level being very low
or approaching empty.
• The engine’ s electrical system has a
problem.
• The emission control system has a
problem.
• A ROOM fuse blows or is
removed.
• The fuel-filler cap is missing or not
tightened securely.

Form No. 8P95-EA-00G
*Some models.
Driving Your Mazda5-40If the check engine light flashes
continuously, decrease your speed and
consult an Authorizd Mazda Dealer as
soon as possible.

053-12CE
 Door-Ajar Warning
Light
This warning light comes on when any
door or trunk isn’ t securely closed.
Q053-15IE
Antilock Brake System
(ABS) Warning Light*
The warning light stays on for a few
seconds when the ignition switch is
turned to the ON position.
If the ABS warning light stays on
while you’re driving, the ABS control
unit has detected a system
malfunction. If this occurs, your
brakes will function normally as if the
vehicle had no ABS. Should this
happen, consult an Authorized Mazda
Dealer as soon as possible.
NOTEWhen the engine is jump-started to
charge the battery, uneven rpm
occurs and the ABS warning light
comes on. This is due to a weak
battery, not a malfunction.
Recharge the battery.