infotainment MAZDA MODEL CX-3 2018 Smart Start Guide (in English)

[x] Cancel search | Manufacturer: MAZDA, Model Year: 2018, Model line: MODEL CX-3, Model: MAZDA MODEL CX-3 2018
Pages: 50, PDF Size: 3.76 MB

Page 3 of 50

$MAZDA MODEL CX-3 2018 Smart Start Guide (in English) TABLE OF \bONTENT\f m{zd{ C X-3 2 Drivers View 4 A dvanced Keyless Entry 5 S tarting the Engine 6 T ire Pressure Monitoring System 7 S eats 8 MAZD A CONNECT Infotainment Syst$

Page 5 of 50

MAZDA MODEL CX-3 2018 Smart Start Guide (in English) m{zd{ c x-3 3
A Lane Departure
Warning System 24
Tire Pressure
Monitoring System 6
B Fuel Filler Lid /
Hood Release —
C Active Driving Display 19
STEERING COLUMN
D L

Page 10 of 50

MAZDA MODEL CX-3 2018 Smart Start Guide (in English) 8 MAZDAUSA.COM
MAZDA CONNECT INFOTAINMENT SYSTEM
MAZDA CONNECT is designed to be operated using one of the following three interfaces:
1 The commander switch (p. 12).
2 Voice control (p. 13).
3

Page 11 of 50

$MAZDA MODEL CX-3 2018 Smart Start Guide (in English) m{zd{ c x-3 9 NOTE: In the interest of safety, the touchscreen is disabled at speeds over 5 mph. Use the commander switch or voice control to operate the infotainment system. To purchase \fD cards$

Page 43 of 50

$MAZDA MODEL CX-3 2018 Smart Start Guide (in English) m{zd{ c x-3 41 IN\fTRUMENT \bLU\fTER \fee your Owner’s Manual for more details and explanations. 1 Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illumina$

m{zd{ c x-3 41
IN\fTRUMENT \bLU\fTER
\fee your Owner’s Manual for more details and explanations. 1 Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.
2 Push to toggle between trip meter (A & B). When a trip meter is selected, push and hold \.to reset to zero.
Push the knob for 1.5 seconds or more to change the speed\. units between mph.
ENGINE COOLANT TEMPERATURE LIGHTS
Since this vehicle does not use an engine coolant temperature gauge, red and blue
engine coolant temperature lights are used to indicate high and low coolant temperature.
Red Coolant Temperature
FLA\fHING: Engine is starting to run hot.
Drive slowly to reduce engine load.
ON: Engine is overheating. \fafely pull
over to the side of the road and turn the
engine off. Refer to the Owner’s Manual for more information. Blue Coolant Temperature
ON: Engine coolant is cold and no warm air is available for heater/defroster.
OFF: Engine coolant is warm and warm air is available for heater/defroster. The light
may stay on for a few minutes after start- up when the engine\. is cold, but the vehicle
can be driven with the light on or off.
TRIP COMPUTER
The following information can be selected by pushing the or of the INFO button on
the steering wheel.
• Approximate distance you can travel on the available fuel (RANGE)
•
Average fuel economy •
\burrent fuel economy • Average vehicle speed

To reset, push and hold th\.e INFO button for more than 1.5 seconds.
OUTSIDE TEMPERATURE DISPLAY
The outside temperature unit can be switched between °\b and °F using\. \fystem \fettings
in the Infotainment \fystem.
IMPORTANT: When your MAZDA \bONNE\bT display setting is set on “AUTO”, the
instrument cluster and display may become dimmer when th\.e headlights are on. If the
display and instrument cluster become too dim or too bright when the headlights are on, simply rotate the dimmer knob \.located on your instrument cluster to adjust the brightness.
TPMS NOTE: Low ambient temperature and/or high altitude may cause tire pressures to
change and turn the TPM\f warning light on. If the warning light comes on, see p. 6.
2940109_18b CX-3 SSG_060817.indd 416/8/17 2:40 PM

Page 48 of 50

$MAZDA MODEL CX-3 2018 Smart Start Guide (in English) VEHICLE PRESENTATION: Refer to the \fmart \ftart Guide during presentation. ESSENTIAL INFORMATION Driver\bs View • Location of \fwitches and \bontrols Advanced Keyless Entry System* •$