engine MAZDA MODEL CX-5 2015 (in English) Owner's Guide

Black plate (137,1)
NOTElThe cooling fan in the engine compartment
could turn on for a few minutes after the
ignition is switched from ON to OFF,
whether or not the A/C is on or off, to cool
the engine compartment quickly.
lIf the system detects that the remaining
battery power of the key is low when the
ignition is switched from ON to ACC or
OFF, the following is indicated.
Replace with a new battery before the key
becomes unusable.
Refer to Replace Electrical Battery on page
6-33.
(Vehicle equipped with Type A
*1
instrument cluster)
A message is indicated in the display of the
instrument cluster.
*1 Refer to Type A on page 4-22.
(Vehicle equipped with Type B
*2
instrument cluster)
The KEY indicator light (green) flashes for
approximately 30 seconds.
*2 Refer to Type B on page 4-26.
l(Automatic transaxle)
If the engine is turned off while the shift
lever is in a position other than P, the
ignition switches to ACC.
qEmergency Engine Stop
Continuously pressing the push button
start while the engine is running or the
vehicle being driven, or quickly pressing
it any number of times will turn the
engine off immediately. The ignition
position will be ACC.
When Driving
Start/Stop Engine
4-9
CX-5_8DR2-EA-14A_Edition1 Page137
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (140,1)
For instance, trip meter A can record the
distance from the point of origin, and trip
meter B can record the distance from
where the fuel tank is filled.
When trip meter A is selected, pressing
the selector again within one second will
change to trip meter B mode.
When trip meter A is selected, TRIP A
will be displayed. When trip meter B is
selected, TRIP B will be displayed.
The trip meter records the total distance
the vehicle is driven until the meter is
again reset. Return it to“0.0 ”by holding
the selector depressed for 1 second or
more. Use this meter to measure trip
distances and to compute fuel
consumption.
NOTE
lOnly the trip meters record tenths of
kilometers (miles).
lThe trip record will be erased when:lThe power supply is interrupted (blown
fuse or the battery is disconnected).
lThe vehicle is driven over 9999.9 km
(mile).
q Tachometer
The tachometer shows engine speed in
thousands of revolutions per minute
(rpm).
CAUTION
Do not run the engine with the
tachometer needle in the RED ZONE.
This may cause severe engine
damage.
*1 The range varies depending on the type
of gauge.
*1 Striped zone
*
1 Red zone
NOTE
When the tachometer needle enters the
STRIPED ZONE, this indicates to the driver
that the gears should be shifted before entering
the RED ZONE.
4-12
When Driving
Instrument Cluster and Display
CX-5_8DR2-EA-14A_Edition1 Page140
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (144,1)
5. Press the upor downpart of the
INFO switch to change the set distance
or time, and press the INFO button. If
no changes are necessary, press the
INFO button.
NOTElThe initial setting values are displayed
corresponding to the maintenance schedule
(except some countries). For each regional
maintenance schedule, Refer to Scheduled
Maintenance on page 6-4.
lis displayed on the set items.
Message display
When the remaining time or the distance
approaches 0, a message is displayed each
time the ignition is switched ON.
NOTElIf any of the INFO switches (up, down
, or INFO button) is pressed while a
message is displayed, it will no longer be
displayed the next time the ignition is
switched ON.
lAfter the vehicle is serviced and the
remaining time/distance is reset, the
message for the next maintenance period
will be displayed when the remaining
distance or time to the next maintenance
period approaches 0 (displays when engine
is started).
lIf there are multiple messages, they are
displayed according to their order.
lIf OFF is set for Messages, messages are
not displayed.
4-16
When Driving
Instrument Cluster and Display
CX-5_8DR2-EA-14A_Edition1 Page144
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (152,1)
Indication and method for taking action list
SignalWarning/Indicator Lights Page
Master Warning Light 4-28
Brake System Warning Light4-28
ABS Warning Light4-29
Charging System Warning Indication4-30
Engine Oil Warning Indication4-30
Check Engine Light4-31
High Engine Coolant Temperature Warning Light (Red) 4-31
AWD Warning Indication4-32
BSM OFF Indicator Light4-43
Automatic Transaxle Warning Indication4-32
Power Steering Malfunction Indication4-33
Air Bag/Front Seat Belt Pretensioner System Warning Light4-33
Low Fuel Warning Light4-34
Check Fuel Cap Warning Indication4-34
Seat Belt Warning Light4-34
4-24
When Driving
Instrument Cluster and Display
CX-5_8DR2-EA-14A_Edition1 Page152
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (153,1)
SignalWarning/Indicator Lights Page
Door-Ajar Warning Indication 4-35
Liftgate-Ajar Warning Indication4-36
Low Washer Fluid Level Warning Indication4-36
Tire Pressure Monitoring System Warning Light4-36
KEY Warning Indication4-38
Wrench Indication4-40
TCS/DSC Indicator Light4-40
TCS OFF Indicator Light4-40
AFS OFF Indicator Light4-40
Smart City Brake Support (SCBS) OFF Indicator Light4-41
Low Engine Coolant Temperature Indicator Light (Blue) 4-41
Shift Position Indication4-41
Headlight High-Beam Indicator Light4-42
Turn Signal/Hazard Warning Indicator Lights4-42
When Driving
Instrument Cluster and Display
4-25
CX-5_8DR2-EA-14A_Edition1 Page153
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (154,1)
SignalWarning/Indicator Lights Page
Security Indicator Light 4-42
Cruise Main Indicator Light (Amber)/Cruise Set Indicator Light (Green) 4-42
Lights-On Indicator Light4-43
qType B
Warning/Indicator lights will appear in any of the highlighted areas
Signal Warning/Indicator Lights Page
Master Warning Light 4-28
Brake System Warning Light4-28
ABS Warning Light4-29
Charging System Warning Light4-30
Engine Oil Warning Light4-30
Check Engine Light4-31
High Engine Coolant Temperature Warning Light (Red) 4-31
4-26
When Driving
Instrument Cluster and Display
CX-5_8DR2-EA-14A_Edition1 Page154
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (155,1)
SignalWarning/Indicator Lights Page
AWD Warning Light 4-32
BSM OFF Indicator Light4-43
Automatic Transaxle Warning Light4-32
Power Steering Malfunction Indicator Light4-33
Air Bag/Front Seat Belt Pretensioner System Warning Light4-33
Low Fuel Warning Light4-34
Check Fuel Cap Warning Light4-34
Seat Belt Warning Light4-34
Door-Ajar Warning Light4-35
Low Washer Fluid Level Warning Light4-36
Tire Pressure Monitoring System Warning Light4-36
KEY Warning Light4-38
TCS/DSC Indicator Light4-40
TCS OFF Indicator Light4-40
AFS OFF Indicator Light4-40
Low Engine Coolant Temperature Indicator Light (Blue) 4-41
When Driving
Instrument Cluster and Display
4-27
CX-5_8DR2-EA-14A_Edition1 Page155
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (157,1)
Low brake fluid level warning
If the brake warning light remains
illuminated even though the parking brake
is released, the brake fluid may be low or
there could be a problem with the brake
system. Park the vehicle in a safe place
immediately and contact an Authorized
Mazda Dealer.
WARNING
Do not drive with the brake system
warning light illuminated. Contact an
Authorized Mazda Dealer to have the
brakes inspected as soon as possible:Driving with the brake system
warning light illuminated is
dangerous. It indicates that your
brakes may not work at all or that
they could completely fail at any
time. If this light remains
illuminated, after checking that the
parking brake is fully released, have
the brakes inspected immediately.
CAUTION
In addition, the effectiveness of the
braking may diminish so you may
need to depress the brake pedal more
strongly than normal to stop the
vehicle.
qABS Warning Light
The warning light stays on for a few
seconds when the ignition is switched
ON. If the ABS warning light stays on while
you're driving, the ABS control unit has
detected a system malfunction. If this
occurs, your brakes will function normally
as if the vehicle had no ABS.
Should this happen, consult an Authorized
Mazda Dealer as soon as possible.
NOTE
When the engine is jump-started to charge the
battery, uneven rpm occurs and the ABS
warning light may illuminate. If this occurs, it
is the result of the weak battery and does not
indicate an ABS malfunction.
Recharge the battery.
q
Electronic Brake Force
Distribution System Warning
If the electronic brake force distribution
control unit determines that some
components are operating incorrectly, the
control unit may illuminate the brake
system warning light and the ABS
warning light simultaneously. The
problem is likely to be the electronic
brake force distribution system.
When Driving
Instrument Cluster and Display
4-29
CX-5_8DR2-EA-14A_Edition1 Page157
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (158,1)
WARNING
Do not drive with both the ABS warning
light and brake warning light
illuminated. Have the vehicle towed to
an Authorized Mazda Dealer to have
the brakes inspected as soon as
possible:Driving when the brake system
warning light and ABS warning light
are illuminated simultaneously is
dangerous.
When both lights are illuminated, the
rear wheels could lock more quickly
in an emergency stop than under
normal circumstances.
qCharging System Warning
Indication/Warning Light
Type B
This warning light illuminates when the
ignition is switched ON and turns off
when the engine is started.
Type A/Type B
If the warning light/indication illuminates
while driving, it indicates a malfunction
of the alternator or of the charging system.
Drive to the side of the road and park off
the right-of-way. Consult an Authorized
Mazda Dealer.
CAUTION
Do not continue driving when the
charging system warning light is
illuminated because the engine could
stop unexpectedly.
qEngine Oil Warning Indication/
Warning Light
Type B
This warning light illuminates when the
ignition is switched ON and turns off
when the engine is started.
Type A/Type B
This warning light/warning indication
indicates low engine oil pressure.
CAUTION
Do not run the engine if the oil
pressure is low. Otherwise, it could
result in extensive engine damage.
If the light illuminates or the warning
indication is displayed while driving:
1. Drive to the side of the road and park off the right-of-way on level ground.
2. Turn off the engine and wait 5 minutes for the oil to drain back into the oil
pan.
3. Inspect the engine oil level (page 6-22). If it's low, add the appropriate amount
of engine oil while being careful not to
overfill.
4-30
When Driving
Instrument Cluster and Display
CX-5_8DR2-EA-14A_Edition1 Page158
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A

Black plate (159,1)
CAUTION
Do not run the engine if the oil level
is low. Otherwise, it could result in
extensive engine damage.
4. Start the engine and check the warning light/warning indication.
If the light/indication remains illuminated
even though the oil level is normal or after
adding oil, stop the engine immediately
and have your vehicle towed to an
Authorized Mazda Dealer.
q Check Engine Light
This indicator light illuminates when the
ignition is switched ON and turns off
when the engine is started.
If this light illuminates while driving, the
vehicle may have a problem. It is
important to note the driving conditions
when the light illuminated and consult an
Authorized Mazda Dealer.
The check engine light may illuminate in
the following cases:
lThe fuel tank level being very low or
approaching empty.
lThe engine's electrical system has a
problem.
lThe emission control system has a
problem.
l(U.S.A. and Canada)
The fuel-filler cap is missing or not
tightened securely. If the check engine light remains on, do
not drive at high speeds and consult an
Authorized Mazda Dealer as soon as
possible.
qHigh Engine Coolant Temperature
Warning Light (Red)
When the ignition is switched ON, the
light illuminates momentarily and then
turns off.
The light flashes when the engine coolant
temperature is extremely high, and
illuminates when the engine coolant
temperature increases further.
Handling Procedure
Flashing light
Drive slowly to reduce engine load until
you can find a safe place to stop the
vehicle and wait for the engine to cool
down.
Illuminated light
This indicates the possibility of
overheating. Park the vehicle in a safe
place immediately and stop the engine.
Refer to Overheating (page 7-18).
CAUTION
Do not drive the vehicle with the high
engine coolant temperature warning
light illuminated. Otherwise, it could
result in damage to the engine.
When Driving
Instrument Cluster and Display
4-31
CX-5_8DR2-EA-14A_Edition1 Page159
Thursday, November 21 2013 8:48 AM
Form No.8DR2-EA-14A