reset MAZDA MODEL CX-5 2015 Quick Guide (in English)

When Driving
14For details, refer to Section 4, “Mazda Radar Cruise Control (MRCC)”.
Mazda Radar Cruise Control (MRCC) system
The Mazda Radar Cruise Control (MRCC) system is designed to maintain
headway control according to the vehicle speed using a radar sensor to detect the
distance to a vehicle ahead, and by presetting the vehicle speed between 30 km/h
(19 mph) and 145 km/h (90 mph), the driver is freed from having to constantly use
the accelerator or brake pedals.
Use the Mazda Radar Cruise Control (MRCC) system on expressways and other
highways which do not require a lot of repeated acceleration and deceleration.
Do not rely completely on the Mazda Radar Cruise Control (MRCC) system
and always drive carefully:
The Mazda Radar Cruise Control (MRCC) system has limitations in its ability to
detect vehicles ahead depending on the weather and road conditions.
Additionally, the system may be unable to decelerate sufficiently to avoid
hitting the vehicle ahead if the vehicle ahead applies the brakes suddenly or
another vehicle cuts into the driving lane, which could result in an accident.
Check the safety of the surroundings and pay sufficient attention to the
distance between your vehicle and the vehicles travelling in front and behind.
WARNING
Do not use the Mazda Radar Cruise Control (MRCC) system in the
following locations. Otherwise, it could lead to an accident:
• Roads with sharp curves, heavy traffic, or roads requiring repeated and
frequent acceleration.
• When entering expressway interchanges and service areas.
• Slippery roads such as ice or snow-bound roads.
• Long descending slopes. Additionally, if your vehicle starts closing in on the vehicle ahead because, for
example, the vehicle ahead brakes suddenly, a warning sound and a warning
indication in the display are activated simultaneously to alert you to maintain a
sufficient distance between the vehicles.
%:A&8''.A'FKVKQPA3WKEM)WKFGKPFD

25
When Driving
X Mark Full Low
Diesel Particulate Filter
The diesel particulate filter collects and removes most of the particulate matter
(PM) in the exhaust gas of a diesel engine.
Inspect the engine oil level periodically (before getting in the vehicle). When
inspecting the engine oil, if the engine oil level is close to or exceeds the “X” mark
on the dipstick, replace the engine oil.
Whenever the engine oil is replaced, the vehicles engine control unit needs to be
reset as soon as possible. Otherwise the wrench indicator light or engine oil
warning light may turn on.
For details, refer to Section 4, “i-ELOOP”, “Tyre Pressure Monitoring System”,
“Diesel Particulate Filter” or Section 6, “Owner Maintenance”.
The Tyre Pressure Monitoring System (TPMS) monitors the air pressure of all
four wheels. If the air pressure of one or more tyres is too low, the system warns
the driver by indicating the tyre pressure monitoring system warning light in the
instrument cluster and operating a beep sound.
In the following cases, system initialization must be performed so that the system
operates normally.
• A tyre pressure is adjusted.
• Tyre rotation is performed.
• A tyre or wheel is replaced.
• The battery is replaced or completely drained.
• The tyre pressure monitoring system warning
light is illuminated.
Tyre Pressure Monitoring System
To reset the engine control unit, refer to the vehicle engine control unit reset
procedure or consult an expert repairer, we recommend an Authorised Mazda
Repairer.
i-ELOOP Charging Display
If the vehicle is driven while “i-ELOOP charging”
is displayed, a beep sound is heard. Make sure the
message is no longer displayed before driving.
%:A&8''.A'FKVKQPA3WKEM)WKFGKPFD