lights MAZDA MODEL CX-5 2016 Smart Start Guide (in English)

12
Mazda Connect Infotainment System
MAZDA CONNECT SETTINGS (if equipped)
To view the different setting screens:
1 Move the commander switch to the left or right to change tabs.
2 When the desired tab is highlighted, push the knob of the
commander switch down.
3 Turn the dial of the commander switch to scroll down the list.
NOTE: If there is a scroll bar on the right side, there are more items further down.
Safety Settings
Sound Settings
Vehicle Settings
System Settings
Device Settings
Display Settings
Mazda Connect Settings
Use System to change the
brightness of the Display
between Day (bright), Night
(dim), and AUTO (switches
from Day to Night when
headlights are turned ON).
See illumination dimmer pp. 35-36.
1945220_16d_Mazda_CX-5_SSG_062315.indd 126/23/15 9:32 AM
www.MazdaUSA.com

25
Blind Spot Monitoring System
NOTE: Do not rely completely on the BSM system and be sure to look over
your shoulder before changing lanes:
• The BSM system can assist the driver in confirming the safety of the surroundings,
but is not a complete substitute.
• The driver is responsible for ensuring safe lane changes and other maneuvers.
• Always pay attention to the direction in which the vehicle is traveling and the
vehicle’s surroundings.
• The BSM system does not operate when the vehicle speed is lower than about
6.2 mph (10 km/h).
BLIND SPOT MONITORING (BSM) SYSTEM
The Blind Spot Monitoring (BSM) system is designed to assist the driver
by monitoring the blind spots to the rear of the vehicle on both sides.
• If your vehicle speed is about 6.2 mph (10 km/h) or more, the BSM
will warn you of vehicles in the detection area by illuminating the
BSM warning lights located on the left and right door mirrors.
• If you operate a turn signal in the direction of an illuminated BSM warning
light, the system will also warn you with a beep and warning light flash.
• BSM sensors are located under the left and right rear bumper areas.
The BSM system may not operate properly if the rear bumper gets too
dirty, so keep the rear bumper area clean.
Refer to your Owner’s Manual for complete details.
Turning BSM System Off
Turning the BSM system off will turn off both the light and sound
indicators. To manually turn the BSM system off, push the BSM
OFF switch on the dash. The BSM OFF indicator will illuminate
in the instrument cluster when the BSM system is off. The BSM
system will retain the last setting before the ignition was turned off.
Your Vehicle
Detection Areas
Image
is for
reference.
1945220_16d_Mazda_CX-5_SSG_062315.indd 256/23/15 9:33 AM

27
Lights
NOTE: The DRL (Daytime Running Lights) automatically turn on when the vehicle
starts moving . To disable/enable this feature see your Authorized Mazda Dealer.
NOTE: You can adjust the timing of the Auto Headlights OFF and the sensitivity of
the Auto Light Control in the vehicle personalization features.
LIGHTING CONTROL/TURN SIGNAL LEVER
: Turns tail,
parking, and
dashboard
lights on.
Pull
to Flash
High Beams
: Turns fog lights
on only when
headlights are on.
: Turns tail, parking,
dashboard, and headlights on.
AUTO (if equipped): The
light sensor automatically
determines when to turn
the headlights on or off.
(cont’d on pg. 29)
Smart Turn: To signal a lane change, push the
turn signal lever up or down halfway and slightly
release. The turn signal indicator will flash three times.
(Refer to Owner’s Manual for “Personalization Features”) Push

for High
Beams
1945220_16d_Mazda_CX-5_SSG_062315.indd 276/23/15 9:33 AM

29
Headlights (cont’d from pg. 27)
Without AFS
ADAPTIVE FRONT-LIGHTING SYSTEM (AFS) (if equipped)
The adaptive front-lighting system (AFS) automatically turns the
headlight beam to the right or left in conjunction with the direction of
the steering wheel.
The AFS improves the direction of headlight illumination while cornering, and
only works when the vehicle is moving.
NOTE:
• With AFS, it is normal to see the headlights move
and hear the sound of the headlight leveling
motors at the front of the vehicle when the
ignition is ON.
• The system will need to be reset if the vehicle
battery has been disconnected or the system fuse
has been replaced. Please refer to your Owner’s
Manual for easy to follow resetting instructions.
Push AFS OFF to turn
system off or on. When
off, AFS OFF illuminates
in the instrument panel.
COMING/LEAVING HOME LIGHT SYSTEMS
COMING HOME
When the surroundings are dark
while leaving your vehicle, visibility
at the front of the vehicle can be
assured for a certain period of time.
When the ignition is set to ACC or off, the
headlights (Low beams) turn on when
the door lever is pulled. The headlights
turn off after a certain period of time
has elapsed after the doors are closed.

LEAVING HOME
When the surroundings are dark
while approaching your vehicle,
visibility around the vehicle can be
assured for a certain period of time.
When the ignition and the headlight
switch are as indicated below, the
exterior lights will turn on when the
transmitter unlock button is pushed.
The headlights turn off after 30 seconds
have elapsed.
• Ignition: OFF
• Headlights switch:
or
With AFS
1945220_16d_Mazda_CX-5_SSG_062315.indd 296/23/15 9:33 AM

30
High Beam Control
To turn HBC on:
1 Turn the
headlight
switch to the
AUTO position.
2 Push the
headlight lever
forward to the
High Beam
position.
When the HBC system is on, the HBC indicator light in the instrument
cluster will illuminate (
GREEN). The High Beam indicator light will turn on
(BLUE) when the HBC system switches to high beam and will turn off when
the HBC system switches to low beam.
HIGH BEAM CONTROL (HBC) (if equipped)
With HBC, the headlights are switched to high beams at speeds above
18 mph (30 km/h) when there are no vehicles in front of your vehicle or
approaching in the opposite direction.
The HBC system switches to low beam when:
• You are approaching a vehicle or a vehicle is approaching in
the opposite direction.
• Driving on roads lined with street lights or well-lit cities and towns.
• At speeds lower than 12 mph (20 km/h).
AUTO
FORWARD
1945220_16d_Mazda_CX-5_SSG_062315.indd 306/23/15 9:33 AM
www.MazdaUSA.com

35
GLOSSARY OF WARNING AND INDICATOR LIGHTS
Instrument Cluster
TCSOFF Traction Control System (TCS)
Off Indicator Light
Low Engine Oil Pressure
Traction Control System (TCS)/
Dynamic Stability Control (DSC)

On: TCS/DSC malfunction
Flashing: TCS/DSC operating
Shift Position Indicator
KEY Warning Light RED
(pp. 3, 6)
KEY Indicator Light GREEN
(p. 6)
Power Steering Malfunction
Air Bag/Front Seat Belt
Pretensioner System Malfunction
Turn Signals/
Hazard Warning Indicator
4WD
AWD Warning Indication
On:
Flashing: Stop vehicle/tow to
Mazda dealer.
Check Engine
Master Warning
Smart City Brake Support

(SCBS) OFF Indicator
Tire Pressure Monitoring System
(TPMS) Warning* (p. 8) On/ Warning Beep: Low tire pressure in one

or more tires. Flashing: TPMS Malfunction
Security Indicator
Cruise Main Indicator
ON ( AMBER )/Cruise Set
Indicator ON ( GREEN)
Automatic Transaxle Warning
Lights ON (Exterior) (p. 27)
Blind Spot Monitoring OFF
(BSM) (p. 25)
Seat Belt Unbuckled/Malfunction
Headlight High Beams On
Electric Parking Brake Warning
Brake Warning
Parking brake on/low brake fluid/malfunction
AFS
OFF Adaptive Front Lighting System
(AFS) OFF (p. 29)
Charging System Malfunction
NOTE: See Owner’s Manual for more details and explanations.
SHIFT POSITION
INDICATOR LIGHT TACHOMETERODOMETER/

TRIP METER
IMPORTANT: When your
Mazda Connect display setting
is set on “AUTO”, the instrument
cluster and display may become
dimmer when the headlights are
on. If the display and instrument
cluster become too dim or too
bright when the headlights are on,
simply rotate the dimmer knob
located on your instrument cluster
to adjust the brightness.
Type A cluster is shown. Type B
cluster is similar, but with warning
lights in different locations.
1945220_16d_Mazda_CX-5_SSG_062315.indd 356/23/15 9:33 AM

36
Instrument Cluster
Door Ajar
Liftgate Ajar
Low Washer Fluid Level
Warning Light
Antilock Brake System
(ABS) Malfunction
Low Fuel Level
Check Fuel Cap
Perform Maintenance
High Beam Control ON
Mazda Radar Cruise Control
Warning ON ( AMBER)
Set Indicator ( GREEN)
SPORT Mode On

LED Headlight Warning
Brake Pedal
Operation Demand
1 • Rotate the knob to adjust the brightness
of the instrument cluster and other
dashboard illuminations.
ENGINE COOLANT TEMP LIGHTS Since this vehicle does not use an engine
coolant temperature gauge, red and blue
engine coolant temperature lights are used
to indicate high and low coolant temperature.
Red Coolant Temp Light Flashing: Engine is starting to run hot.
Drive slowly to reduce engine load.
On: Engine is overheating. Safely pull
over to the side of the road and turn
the engine off. Refer to the Owner’s
Manual for more information.
Blue Coolant Temp Light
On: Engine coolant is cold
and no warm air is available
for heater/defroster.
Off: Engine coolant is warm and
warm air is available for heater/
defroster. The light may stay on for a
few minutes after start-up when the
engine is cold, but the vehicle can
be driven with the light on or off.
TPMS NOTE: Low ambient temperature and/or high altitude causes tire pressures to
drop and may turn the TPMS warning light on. If the warning light comes on, check the
tire pressure and fill the tires as soon as possible, preferably before moving the vehicle
and warming up the tires. Tire pressure should be checked when the tires are cold.
2 • Push to toggle between trip meter (A & B).
• When a trip meter is selected, push and hold to
reset to zero.
DASHBOARD ILLUMINATION/
DIMMER1/TRIP METER2 FUEL
GAUGE
SPEEDOMETERINFORMATION
D I S P L AY
TYPE B CLUSTER
INFORMATION D I S P L AYSee page 9 or the
Owner’s Manual for
further information.
1945220_16d_Mazda_CX-5_SSG_062315.indd 366/23/15 9:33 AM
www.MazdaUSA.com

Customer Delivery Checklist
SCHEDULED MAINTENANCE:
When replacing or topping off engine oil, use Mazda Genuine oil. For optimal engine performance,
use SAE 0W-20 engine oil. Please consult an Authorized Mazda Dealer for additional information.
Driver’s View ........................ 1
• Location of Switches and Control
Advanced Keyless Entry* .......... 3
• Door Request Switch*
Starting the Engine ................. 5
• Accelerated Warm-Up System (AWS)
• Push Button Start System
• Emergency Engine Stop
Electric Parking Brake ............. 7
Fuel Economy ....................... 7
Tire Pressure Monitor System ....8
• Initialize TPMS before delivery
Seats and Mirrors ................. 10
Mazda Connect* ................... 11
Commander / Voice Control* ....13
Bluetooth®* ......................... 15
• Pair Phone
• Make/Receive Call
• Toll-Free Customer
Service 800-430-0153
Navigation System* ............... 17
• SD Card
• Planning a Route
*if equipped
SALES CONSULTANT DAT ECUSTOMER DAT E
All items in the Customer Deliver y Checklist have been reviewed with the
customer and the first maintenance appointment has been scheduled:
Signed copy must be placed in dealer jacket.
VEHICLE PRESENTATION:
Refer to the Smart Start Guide during presentation
ESSENTIAL INFORMATION
SAFET Y & TECHNOLOGY INFORMATION
GENERAL INFORMATION
Information Display ................ 9
Mazda Connect Settings* ........12
Mazda Radar Cruise Control* ...19
Smart City Brake Support* ....... 21
Lane Departure
Warning System (LDWS)* ........ 23
Distance Recognition
Support System* .................. 24
Blind Spot Monitoring (BSM)* ... 25
Rear Cross Traffic Alert* ......... 26
Lights ............................... 27
Wiper/Washer ......................28
Adaptive Front
Lighting System (AFS)* ........... 29
High Beam Control* ............... 30
Audio Controls ..................... 31 • Bluetooth Audio
Audio USB & AUX Inputs ......... 33
Automatic Climate Control* ......34
Instrument Cluster ................ 35 • Review of Warning and
Indicator Light Function
and Location
Transmission ....................... 37
1945220_16d_Mazda_CX-5_SSG_062315.indd 396/23/15 9:33 AM