lights MAZDA MODEL CX-7 2010 Navigation Manual (in English)

15
Getting Started
Navigation Set Up
lYou can alter the map display conditions, the route guidance conditions and show the
system information.
nStop your vehicle before performing the following operations. Do not change the settings and destination locations while driving. Minimize the time
spent viewing the monitor screen and listening to the voice guidance while driving.
Operating the system will distract the driver from looking ahead of the vehicle and may
cause an accident.
Always stop the vehicle in a safe location and set the parking brake before operating the
system.
Before Stepsselect
Warning
Open the
[Navigation
Setup]
nAuto ZoomThe Auto Zoom function automatically switches the map scale depending
on the distance between the next guidance point and the current position.
Used to switch the Auto Zoom function.
nMap ColorUsed to switch the map mode.
nMap DirectionUsed to switch the map direction.
nShow POI IconsUsed to display the selected POI icons on the Map screen.
nGuidance VolumeUsed to adjust the guidance volume.
Also adjustable using the audio volume knob during
transmission of the voice guidance.
Day: To switch to the daytime screen.
Night: To switch to the nighttime screen.
Auto: The screen switches between
daytime and nighttime displays in
conjunction with the on/off of the
vehicle’s exterior lights.
North Up: Geographic north is up.
Head Up: The direction you are heading is up.
2%:8:9)FSSO4EKI1SRHE].ERYEV]41

19
Getting Started
The screen map can be scaled to 14 different sizes.
nBrightness/Contrast
Brightness and contrast of the navigation screen can be adjusted.
1. Press the INFO switch to display the SETTINGS screen.
2. Select PREFERENCES and press the Enter (up/down) switch.
3. Select SCREEN ADJUSTMENT and press the Enter (up/down) switch.
4. Select BRIGHTNESS/CONTRAST and press the Enter (up/down) switch.
5. Select BRIGHTNESS or CONTRAST using the left or right switch.
6. Adjust the tone by operating the Enter (up/down) switch upward/downward.
7. After setting, press the Enter (up/down) switch to finish the setting.
nDaytime/Night screen
When the headlights are on, daytime mode can also be selected (if a brighter screen is
needed at night). This selection can only be done when the headlights are on.
lThe screen can be returned to the daytime screen while the headlights or running lights are
on by pushing the dashboard illumination knob. You will hear a beep sound and the
illumination dimmer will be canceled. With each press of the dashboard illumination knob,
the dashboard illumination will change from dim to full bright and back to dim again.
Adjusting the Map Scale
1
Press the Enter (up/down) switch up or down while the Map screen is
displayed to zoom in/out of the Map screen.
Screen Adjustments
Scale bar
2%:8:9)FSSO4EKI*VMHE](IGIQFIV41