warning MAZDA MODEL CX-9 2013 Smart Start Guide (in English)

Driver’s View (shown with optional
56
Navigation System)
1 This indicator light illuminates to remind you that the front passenger’s front/side airbags and seat
belt pretensioner will not deploy during a collision. The reason for this is that the weight in the seat is
less than approximately 66 lbs. Always wear your seat belt and secure children in the rear seats in
appropriate child restraints. See the Owner’s Manual for important information on this safety feature.
B LU etOOth®
hA nDS -FRee
( P P. 1 9 - 2 0 )/
AUDi O
( P P. 17-1 8 )
BACKUP
S en SOR
SYS teM
( P. 14 )
heADLight
Le Ve Ling
( P. 9 )
P OW eR
L i Ft g At e
SW itCh
( P. 14 )
tRACti On
CO ntROL
SYS teM
( tCS)BL inD SPO t
MOnit ORing
(BS M)
( P. 1 3 )
nAV igAti On
S YS teM
SD CARD

( P. 2 3 )
in FORMA tiOn
D iS P L AY
(PP. 15, 25)
C LiM A t e
CO ntROL

( P P. 1 5 -1 6 )
L ighting /
t URn Sign ALS
( P. 9 )
hOOD
R eLe AS e ACCe
SSORY
SOCK et
ti
Lt/ te Le SCOP ing
Stee Ring W heeL
Le Ve R (behind
steering wheel)
hA zARD
WARning
S e At
WARM eRS
( P P. 1 5 -1 6 )
P ASS enge R
A iRBA g OFF
in DiCA tOR
1
www.MazdaUSA.com
CLOCK
S etting
nAV igAti On/
AUDi O
(PP. 17-18, 23-24)
Wi Pe R /
WAS heR
( P. 1 0 )
C RU iS e CO ntROL /
nAV igAti On V OiC e
Re CO gniti On
1284179_13a_Mazda_CX-9_SSG_101512.indd 6-710/15/12 3:03 PM

Instrument Cluster
78
Low Fuel Level

Ke
Y Warning Light (Re D) Advanced key not detected
or transmitter battery is dead.

K
eY indicator L ight (gR een ) On: Advanced key detected; engine
is ready to start.
Flashing: Advanced key battery is low.
Check Fuel Cap

ABS (Antilock Brake
System) Malfunction

Lights On (
exterior)

t
ire Pressure
Monitoring System
( t PMS
) Warning Light On/ Warning Beep: Low tire
pressure in one or more tires.
Flashing: TPMS Malfunction
tCS
OFF

t
CS OFF
( t raction Control System)

Charging System Malfunction

Powertra
in Malfunction/
Reduced Power
BSM OFF

BSM OFF

(Blind Spot Monitoring)

Check e
ngine Light

Brake Warning Light
Parking brake on/low brake
fluid/malfunction

t
urn Signals/ hazard
Warning i ndicator Lights

Automatic t
ransmission
Malfunction

Shift Position i
ndicator Light

h
eadlight h igh Beams On

t
raction Control System
( t CS)/Dynamic Stability
Control (DSC)/Roll
Stability Control (RSC)
On: TCS/DSC malfunction
Flashing: TCS/DSC operating
Air Bag/Front Seat Belt
Pretensioner System
Malfunction
Low e
ngine Oil Pressure

Security i
ndicator Light

Door/Liftgate Ajar
4WD

4WD
On: System is not normal; dealer
inspection required.
Flashing: Differential oil temperature
is high; dealer inspection required.
Seat Belt

Unbuckled/Malfunction

Cruise Main indicator

Light On (A MBe R)/
Cruise Set indicator
Light On (
gR een)

Low Washer Fluid Level
tAC
hO M e t e R
F
U eL gAU ge SPeeDOM eteRtRiP M ete R
S eLeCt OR2in StRUM ent
CLUSte R D iMM eR1engine COOLA nt
teMP eRAtUR e g AUgeODOM eteR/
tR iP M ete RShiFt Le VeR
P OS itiOn in DiCA tOR
gLOSSARY OF W ARning A nD in DiCA tOR L ight S
nOte : See Owner’s Manual for more details and explanations.
nOte : Low ambient temperature and/or high altitude causes tire pressures to drop
and may turn the TPMS warning light on. If the warning light comes on, check the tire
pressure and fill the tires as soon as possible, preferably before moving the vehicle and
warming up the tires. Tire pressure should be checked when the tires are cold.1 If the instrument cluster and other dashboard illuminations do not dim when turning on the headlights,
push the Instrument Cluster Dimmer knob.
2 • Push to toggle between trip meter A & B.
• When a trip meter is selected, push and hold to reset to zero.
The instrument cluster has a dimmer function that
can be cancelled to make the illumination brighter
during the day when the headlights are on. If
the illumination is too dim during the day,
press the knob, or if the illumination does
not dim when turning on the headlights
at night, press the knob.
When dimmed, rotate the
knob to adjust the brightness
of the illumination.
www.MazdaUSA.com
1284179_13a_Mazda_CX-9_SSG_101512.indd 8-910/15/12 3:03 PM

Feature Highlights
1314
ReAR Vie W MOnit OR
(if equipped)
Placing the gearshift lever
into Reverse automatically
operates the Rear View
Parking Camera and is
viewable via the 5.8”
LCD screen.
Rear View Parking Camera
n Ote : When using the Rear View Parking Camera, please check your
surroundings as objects may be closer than they appear.
BL inD SPO t MOnit ORing (BSM) SYSte M (if equipped)
The Blind Spot Monitoring (BSM) system is designed to assist the driver
by monitoring the blind spots to the rear of the vehicle on both sides.
• If your vehicle speed is 20 mph (32 km/h) or more, the BSM will warn
you of vehicles in the detection area by illuminating the BSM warning
lights located on the left and right door mirrors.
• If you operate a turn signal in the direction of an illuminated BSM
warning light, the system will also warn you with a beeping sound and
warning light flash.
• BSM sensors are located under the left and right rear bumper areas.
The BSM system may not operate properly if the rear bumper gets too
dirty, so keep the rear bumper area clean.
Please refer to your Owner’s Manual for complete details.
Your Vehicle
Detection Areas
n Ote : Do not rely completely on the BSM system and be sure to look over
your shoulder before changing lanes:
• The BSM system can assist the driver in confirming the safety of the surroundings,
but is not a complete substitute.
• The driver is responsible for ensuring safe lane changes and other maneuvers.
• Always pay attention to the direction in which the vehicle is traveling and the
vehicle’s surroundings.
• The BSM system does not operate when the vehicle speed is lower than about
20 mph (32 km/h).
turning BSM System Off
To manually turn the BSM system off, push the BSM OFF switch on the dash.
The BSM OFF indicator will illuminate in the instrument cluster when the BSM
system is off. The BSM system will automatically turn on the next time the
vehicle is started.
BACKUP Sen SOR SYSteM (if equipped)
The backup sensor system uses ultrasonic sensors to detect
obstructions around the vehicle while parking the vehicle in a
garage or during parallel parking when the vehicle is driven at a
speed of about 6 mph (10 km/h) or less. The system will notify
the driver of the approximate distance from the vehicle to the
surrounding obstruction using a beep sound.
This can be turned ON or OFF using the Backup Sensor Button located on
the left side of dash.
P OW eR L iF tg Ate *
• To open or close using the advanced keyless transmitter, unlock the
liftgate and push and hold the liftgate button for one second or more.
•
To open or close from the driver’s seat, unlock the liftgate and push
and hold the power liftgate switch on the dashboard (see Driver’s View)
for one second or more.
•
To close when the liftgate is open, push and hold the power liftgate
switch located on the lower edge of the liftgate panel for one second
or more.
Power liftgate will only operate under the following conditions:
1 The power liftgate is unlocked.
2 The shift lever is in park (P). Liftgate

h andle
Liftgate h andle
Power Liftgate Switch
MAnUAL L iF tg Ate
•
To open, unlock the liftgate, pull up on
the handle and raise the liftgate.
•
To close, push liftgate down until it
securely locks, but do not slam. www.MazdaUSA.com
1284179_13a_Mazda_CX-9_SSG_101512.indd 14-1510/15/12 3:04 PM

© Mazda North American Operations
Printed in U.S.A. 10/12 Print 1
9999 95 011C 13SS
FR ee FULL C iRCLe
S eRV iC e in SPeC ti On
We’re committed to providing
expert Mazda service.
You love to drive your Mazda, and we love to service your Mazda. With our Full Circle
Service, we’ll give your vehicle a COMPLIMENTARY MULTI-POINT INSPECTION.
Your Mazda will receive a thorough review of its most crucial components.
This easy-to-use Smart Start Guide is intended to help you more fully appreciate some
of the unique features and functions of your new vehicle. However, it is not intended to
replace your Owner’s Manual. The Owner’s Manual contains more detailed information
to help you better understand the important safety warnings, features, operation, and
maintenance of your vehicle. All information, specifications, photographs and illustrations
in this publication are those in effect at the time of printing. Mazda reserves the right to
change specifications or design without obligation.
g en Uine MA zDA S eRV iC e
Because you and your Mazda deserve the best
Your new Mazda deserves nothing less than the very best. To keep it running
like new for years to come, trust the experts at your local Authorized Mazda
Dealer. Simply bring your vehicle in for your scheduled maintenance and any
needed repairs.*
At participating Mazda Full Circle Service Centers,** our technicians will
automatically perform a complimentary Full Circle inspection on your vehicle
and issue a detailed report card at every visit. This is designed to help you
keep track of your Mazda’s critical operating condition. Our factory-trained
technicians know your vehicle inside out and use Genuine Mazda Parts,
giving your vehicle the optimum care and maintenance it requires to run
with flawless precision.
Remember, to further enhance your driving experience, visit your local
Mazda Service Center for your scheduled maintenance. It’s also the place
where you can find a wide variety of tires, parts, and accessories that are
just right for your vehicle.
* See vehicle’s scheduled-maintenance program for details.
** Visit the Mazda Owners website at www.MyMazda.com/fullcircle to find a
participating Mazda Full Circle Service Dealer.
Customer Assistance Center:
1-800-222-5500
Roadside Assistance Contact: 1-800-866-1998
www.MazdaUSA.com
1284179_13a_Mazda_CX-9_SSG_101512.indd 3010/15/12 3:05 PM