MAZDA MODEL CX-9 2015 Owners Manual (in English)

Black plate (221,1)
NOTE
If the vehicle is driven on a road with less
traffic and few vehicles that the radar sensors
can detect, the system may pause (The BSM
OFF indicator light in the instrument panel
flashes). However, it does not indicate a
malfunction.
qBSM OFF Switch
When the BSM switch is pressed, the
BSM system turns off and the BSM OFF
indicator light illuminates.
Press the BSM OFF switch again to turn
on the BSM system. The BSM OFF
indicator light turns off.
NOTE
lThe system may not operate normally when
towing a trailer. Turn off the system by
operating the BSM OFF switch when
towing a trailer.
lIf the ignition is switched off with the BSM
system turned off, the system becomes
operable automatically when the ignition is
switched ON.
qCare of Radar Sensors
The radar sensors are equipped inside the
rear bumper.
Radar sensors
Always keep the bumper surface near the
radar sensor area clean so that the BSM
system operates normally. Refer to the
Exterior Care (page 8-56).
NOTE
lThe BSM OFF indicator light flashes if the
radar sensors cannot operate normally. If
the light remains flashing after cleaning the
bumper surface near the radar sensor area,
consult an Authorized Mazda Dealer.
lFor repairs or paintwork around the radar
sensors, or replacement of the bumper,
consult an Authorized Mazda Dealer.
Driving Your Mazda
Starting and Driving
5-43
CX-9_8DU1-EA-14H_Edition1 Page221
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (222,1)
qSafety Certification
5-44
Driving Your Mazda
Starting and Driving
CX-9_8DU1-EA-14H_Edition1 Page222
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (223,1)
NOTE
During printing time of this user manual the approvals listed above are granted.
WARNING
Change or modifications not expressively approved by the party responsible for
compliance could void the use's authority to operate the equipment.
Driving Your Mazda
Starting and Driving
5-45
CX-9_8DU1-EA-14H_Edition1 Page223
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (224,1)
Parking Sensor System
The parking sensor system uses ultrasonic sensors to detect obstructions around the vehicle
while parking the vehicle in a garage or during parallel parking when the vehicle is driven
at a speed of about 10 km/h (6 mph) or less. The system is equipped with an assist device
to notify the driver of the approximate distance from the vehicle to the surrounding
obstruction using a beep sound.
Rear sensor
Rear corner sensor
WARNING
Do not rely completely on the parking sensor system and be sure to confirm the
safety around your vehicle visually when driving.
This system can assist the driver in operating the vehicle in the forward and
backward directions while parking. The detection ranges of the sensors are limited,
therefore, driving the vehicle while relying only on the system may cause an accident.
Always confirm the safety around your vehicle visually when driving.
5-46
Driving Your Mazda
Starting and Driving
CX-9_8DU1-EA-14H_Edition1 Page224
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (225,1)
NOTElDo not install any accessories within the detection ranges of the sensors. It may affect the system
operation.
lDepending on the type of obstruction and the surrounding conditions, the detection range of a
sensor may narrow, or the sensors may not be able to detect obstructions.
lThe system may not operate normally under the following conditions:lMud, ice, or snow is adhering to the sensor area (Returns to normal operation when removed).lThe sensor area is frozen (Returns to normal operation when the ice is thawed).lThe sensor is covered by a hand.lThe sensor is excessively shocked.lThe vehicle is excessively tilted.lUnder extremely hot or cold weather conditions.lThe vehicle is driven on bumps, inclines, gravel, or grass covered roads.lAnything which generates ultrasound is near the vehicle, such as another vehicle's horn, the
engine sound of a motorcycle, the air brake sound of a large-sized vehicle, or another vehicle's
sensors.
lThe vehicle is driven in heavy rain or in road conditions causing water-splash.lA commercially-available fender pole or an antenna for a radio transmitter is installed to the
vehicle.
lThe vehicle is moving towards a tall or square curbstone.lAn obstruction is too close to the sensor.lObstructions under the bumper may not be detected. Obstructions that are lower than the bumper
or thin which may have been initially detected but are no longer detected as the vehicle
approaches more closely.
lThe following types obstructions may not be detected:lThin objects such as wire or ropelThings which absorb sonic waves easily such as cotton or snowlAngular shaped objectslVery tall objects, and those which are wide at the toplSmall, short objectslAlways have the system inspected at an Authorized Mazda Dealer if any shock is applied to the
bumpers, even in a minor accident. If the sensors are deviated, they cannot detect obstructions.
lThe system may have a malfunction if the beep does not operate or the indicator light does not
illuminate when the park assist sensors switch is turned on. Consult an Authorized Mazda Dealer.
lThe system may have a malfunction if the beep sound which indicates a system malfunction is
heard and the indicator light flashes. Consult an Authorized Mazda Dealer.
lThe beeper which indicates a system malfunction may not be heard if the ambient temperature is
extremely cold, or mud, ice, or snow adheres to the sensor area. Remove any foreign material
from the sensor area.
Driving Your Mazda
Starting and Driving
5-47
CX-9_8DU1-EA-14H_Edition1 Page225
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (226,1)
qSensor Detection Range
The sensors detect obstructions within the following range.
Rear sensor detection range
Rear corner sensor detection range
A
Unit: cm (in)
B A: About 150 (About 59.1)
B: About 150 (About 59.1)
q
Park Assist Sensors Switch
The switch can be activated when the ignition is switched ON, the shift lever is in any
position except reverse (R), and the vehicle speed is about 10 km/h (6 mph) or less.
When the parking sensor switch is pressed, a beep sound is heard and the indicator light in
the switch illuminates.
NOTE
If the system is cancelled, it will not restore automatically even when the vehicle speed is decreased to
10 km/h (6 mph) or less.
5-48
Driving Your Mazda
Starting and Driving
CX-9_8DU1-EA-14H_Edition1 Page226
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (227,1)
Sensor detection condition
The system can be used when the ignition is switched ON and the Park Assist Sensor
Switch has been turned on.
The system will then operate when the shift lever is placed in reverse (R).
The sensors detect obstructions under the following conditions:
SensorCondition
Rear Sensor The shift lever is in reverse (R).
Rear Corner Sensor The shift lever is in reverse (R), and the vehicle speed is about 10 km/h (6 mph) or less.
The system is cancelled under the following conditions:lThe vehicle speed is 10 km/h (6 mph) or more.lThe parking sensor switch is pressed while the parking sensor is in operation.
Driving Your Mazda
Starting and Driving
5-49
CX-9_8DU1-EA-14H_Edition1 Page227
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (228,1)
qParking Sensor Warning Beep
The beeper sounds as follows while the system is operating.
Distance between vehicle and obstruction
Beeper sound*1Rear SensorRear Corner Sensor
Approx. 150 ―100 cm (59.0 ―39.3 in)
Approx. 150 ―100 cm (59.0 ―39.3 in)
Slow intermittent sound
Approx. 100 ―50 cm (39.3 ―19 in)
Approx. 100 ―50 cm (39.3 ―19 in)
Medium intermittent
sound
Approx. 50 ―30 cm (19 ―11 in)
Approx. 50 ―30 cm (19 ―11 in)
Fast intermittent sound
Within approx. 30 cm (11 in)
Within approx. 30 cm (11 in)
Continuous sound
*1 The speed of the intermittent sound increases as the vehicle approaches the obstruction.
5-50
Driving Your Mazda
Starting and Driving
CX-9_8DU1-EA-14H_Edition1 Page228
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (229,1)
qWhen Warning Beep is Activated
The system notifies the driver of an abnormality by activating the beep sound.
Beep How to check
The beep sound is not heard. The system may have a malfunction. Have the vehicle inspected at an Authorized
Mazda Dealer as soon as possible.
1 consecutive beep Corner Left Sensor Remove any foreign material from the sensor area. If
the system does not recover, have the vehicle
inspected at an Authorized Mazda Dealer.
2 consecutive beeps Left Sensor
3 consecutive beeps Right Sensor
4 consecutive beeps Corner Right Sensor
Corner right sensor
Corner left sensor
Right sensor
Left sensor
Driving Your Mazda
Starting and Driving
5-51
CX-9_8DU1-EA-14H_Edition1 Page229
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H

Black plate (230,1)
Meters and Gauges
Speedometer ...................................................................................................... page 5-53
Odometer, Trip Meter and Trip Meter Selector .................................................. page 5-53
Tachometer ........................................................................................................ page 5-54
Engine Coolant Temperature Gauge .................................................................. page 5-54
Fuel Gauge ........................................................................................................ page 5-55
Dashboard Illumination ..................................................................................... page 5-55
NOTE
When the ignition is switched ON, the dashboard gauges illuminate.
5-52
Driving Your Mazda
Instrument Cluster and Indicators
CX-9_8DU1-EA-14H_Edition1 Page230
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H