child lock MAZDA MODEL MILLENIA 2001 Quick Tips (in English)
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2001, Model line: MODEL MILLENIA, Model: MAZDA MODEL MILLENIA 2001Pages: 10, PDF Size: 0.97 MB
Page 5 of 10
SWITCHES
Always check the Owner’s Manual for more operating information and safety features
Switches
Locks
Quick Tips 2001 Mazda Millenia page 8
page 9
Revised January 9, 2001
Master front door lock
switches
To unlock all doors: Press
UNLOCK (1) on either switch,
turn key counterclockwise in
driver’s/front passenger’s door
To lock all doors: Press LOCK (2)
on either switch, manually lock
driver’s door, or lock either front
door with keyRemote
keyless entry
system
Functions
only with
ignition in
OFF position
To lock doors: Press
button (4); pressing again within
5 seconds causes doors to relock
and horn to beep
To unlock: Press (5)
for driver’s door; press again
within 5 seconds to unlock
other doors
To open trunk: Press (6)
Panic alarm: Press (7); horn
sounds, headlights/taillights flash;
to stop, press (7) again or turn
ignition to ON position
Dual power mirrors
Operates only with ignition on
To adjust left/right mirror:
Slide selector switch (4) left/
right, press perimeter switch (5)
in direction of desired mirror
movement
Tip: To lock mirrors in place,
move switch to center position
Childproof locks
Located at the edge of rear doors
To activate: Push tab (3) right; door
opens from outside only
To cancel: Push tab (3) left Power window switches
Operates only with ignition ON
All windows controlled from
driver’s door; passenger doors
have separate switches
Driver’s window (1): “One-touch-
down,” press bottom of switch
and release, window goes down
all the way; tap top of switch to
stop; press and hold top of switch
to close
Passenger window switches (2):
Press bottom/top of switch to
open/close
Power window lock switch:
Press LOCK (3): Only driver’s
window switches function;
push (3) again; all window
switches function again
45
3
7
6
LOCK
UN
LOCK4
5
2211
LOCK AUTO
1
3
2
Page 7 of 10
SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Seats
Quick Tips 2001 Mazda Millenia page 12
page 13
Revised January 9, 2001
1. Head restraint
To raise/lower: Press release
button (4) and pull up/
push down
To move forward/aft: Rotate
(driver’s seat only)
Power seats
2. Raise/lower front of seat
Move front of switch vertically
Fore/aft adjustment
Move switch horizontally
Raise/lower rear of seat
Move rear of switch vertically
Raise/lower seat cushion
Movecenter of switch vertically
3. Seatback angle
Rotate fore/aft for desired angleLumbar support
(driver’s seat only)
Located at front of
center console
Press top/bottom of switch to
increase/decrease firmness WARNINGS: Always wear
your safety belt and properly
secure children 12 and under
in the rear seat
If you choose to install a
forward-facing child restraint
seat, move vehicle seat as
far back as possible
Air bag is supplemental
and does not replace safety
belt usage
Do not adjust seat while driving
1
4
23
1
Shoulder belt height
adjustment
To raise/lower belt, press
button (1) and move up/down
WARNING: Make sure
adjuster locks in position
WARNINGS: Children less
than 4 years old and under
40 pounds should always
use a safety seat
Never place rear-facing child
restraint seat in front seatChild restraint seat
Some child restraint systems are
equipped with tethers that must
be installed on one of the three
anchors on the rear seats
To install in rear outboard seats:
Use dual locking mode retractor
safety belt; see Owner’s Manual
for proper installation and child
seat tether instructionsWARNING: Read all
information and warnings
in Owner’s Manual and
attached to seat before using
child safety seat
Dual locking mode
lap/shoulder belt retractor
(front passenger and rear
outboard safety belts only)
Emergency locking mode: Belt
locks only on hard braking/
cornering or impacts of about
5 mph or more
Automatic locking mode:
Must be used when installing
child safety seat
To activate: Pull webbing fully
out of retractor until click is
heard; belt will only tighten
To disengage: Unbuckle belt and
allow webbing to retract fully