check engine MAZDA MODEL MILLENIA 2002 (in English) User Guide

5-26
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8Q47-EA-01F

Engine Oil Pressure Warning
Light
This warning light indicates low engine
oil pressure.
If the light comes on while driving:
1. Drive to the side of the road and park
off the right-of-way.
2. Turn off the engine and inspect the
engine oil level (page 8-10). If it’s low,
add oil.
3. Check the light.
If the light remains on even after you add
oil, have your vehicle towed to the nearest
service station or to an Authorized Mazda
Dealer.

Check Engine Light
If this light comes on while driving, the
vehicle may have a problem. It is
important to note the driving conditions
when the light came on and consult an
Authorized Mazda Dealer.
The check engine light may come on in
the following cases:
•The fuel tank level being very low or
approaching empty.
•The engine’s electrical system has a
problem.
•The emission control system has a
problem.
•The fuel-filler cap is missing or not
tightened securely.
If the check engine light flashes
continuously, decrease your speed and
consult an Authorized Mazda Dealer as
soon as possible. Don’t run the engine if oil pressure is
low. It could result in extensive engine
damage.
CAUTION
J76Y.book Page 26 Wednesday, March 27, 2002 5:04 PM

6-2
Interior Comfort
Form No. 8Q47-EA-01F
Climate Control System

Operating the Climate Control
System
Operate the climate control system with
the engine running.

Clearing the Air Inlet
Clear all obstructions like leaves, snow
and ice from the hood and the air inlet in
the cowling grille to improve the system
efficiency.

Foggy Windows
The windows may fog up easily in humid
weather. Use the climate control system to
defog the windows.
To help defog the windows, operate the air
conditioner to dehumidify the air.

Outside/Recirculated Air
Position
Use the outside air position in normal
conditions. The recirculated air position
can be used temporarily when driving on
dusty roads or for quick cooling of the
interior.

Parking in Direct Sunlight
If the vehicle has been parked in direct
sunlight during hot weather, open the
windows to let warm air escape, then run
the climate control system.

Not Using for a Long Period
Run the air conditioner at least once a
month to keep internal parts lubricated.

Check the Refrigerant before
Weather Gets Hot
Have the air conditioner checked before
the weather gets hot. Lack of refrigerant
may make the air conditioner less
efficient. Consult an Authorized Mazda
Dealer for refrigerant inspection.
The optional air conditioner is filled with
R134a, a refrigerant that will not damage
the ozone layer.
If the air conditioner is low on refrigerant
or has a malfunction, consult an
Authorized Mazda Dealer.

Replacement of the Cabin Air
Filter
If your vehicle is equipped with an air
filter for the air conditioner, it is necessary
to change the filter periodically as
indicated in scheduled maintenance (page
8-3). Consult an Authorized Mazda
Dealer for replacement of the cabin air
filter.
Operating Tips
J76Y.book Page 2 Wednesday, March 27, 2002 5:04 PM

7-10
In Case of an Emergency
Form No. 8Q47-EA-01F
Overheating
If the temperature gauge indicates
overheating, you experience power loss,
or you hear a loud knocking or pinging
noise, the engine is probably too hot.
If this happens:
1. Drive safely to the side of the road and
park off the right-of-way.
2. Shift into park (P) .
Apply the parking brake.
3. Turn off the air conditioner.
4. Check whether coolant or steam is
escaping from under the hood or from
the engine compartment.
If steam is coming from the engine
compartment:
Don’t go near the front of the vehicle.
Stop the engine. Then turn the ignition
switch to the ON position without
starting the engine.
The radiator cooling fans will start to
cool the engine.
If neither coolant nor steam is
escaping:
Open the hood and idle the engine until
it cools. If this doesn’t lower the
temperature, stop the engine and let it
cool.5. Check the coolant level.
If it’s low, look for leaks in the radiator
hoses and connections, heater hoses
and connections, radiator, and water
pump.
If you find a leak or other damage, or if
coolant is still leaking, stop the engine
and call an Authorized Mazda Dealer.
If you find no problems, the engine is
cool, and no leaks are obvious, carefully
add coolant as required (page 8-12).
Overheating
Steam from Overheated Engine:
Steam from an overheated engine is
dangerous. The escaping steam could
seriously burn you. Open the hood
ONLY after steam is no longer
escaping from the engine.
WARNING
Coolant filler cap
2.5 liter V6 DOHC
Engine coolant
reservoir
Coolant system cap
Miller Cycle Engine V6 DOHC
Engine coolant
reservoir
J76Y.book Page 10 Wednesday, March 27, 2002 5:04 PM

8-11
Maintenance and Care
Owner Maintenance
Form No. 8Q47-EA-01F
5. Pull it out again and examine the level.
It’s OK between L and F.
But if it’s near at or below L, add
enough oil to bring the level to F.
6. Make sure the O-ring is positioned
properly before reinserting the
dipstick.
The distance between L and F on the
dipstick represents the following:

Changing Engine Oil and Filter
Change engine oil and filter according to
Scheduled Maintenance (page 8-3).
Please act responsibly—protect the
environment and take used oil to a
recycling facility. Ask your dealer or a
service station for information.Changing engine oil
1. Warm up the engine for a few minutes
and turn it off. Remove the oil-filler
cap.
2. Remove the drain plug and drain the oil
into a suitable container. Don’t add engine oil over F. This may
cause engine damage.
L (US qt, Imp qt) 0.9 (1.0, 0.8)
Handling Used Engine Oil:
Continuous contact with used engine
oil is dangerous. It could cause skin
cancer. Always wash with soap and
water immediately after changing oil
and filter.
CAUTION
WARNING
Checking or Changing Engine Oil:
Hot engine oil is dangerous. If the
engine has been running, the engine
oil becomes very hot. You could be
seriously burned. Don’t check or
change the engine oil when the
engine is hot.
WARNING
2.5 liter V6 DOHC
Loosen
Tighten
Drain plug
Loosen
Tighten Miller Cycle Engine V6 DOHC
Drain plug
J76Y.book Page 11 Wednesday, March 27, 2002 5:04 PM

8-12
Maintenance and Care
Owner Maintenance
Form No. 8Q47-EA-01F
3. Replace the plug tightly after the oil
has thoroughly drained.
4. Fill the engine with new oil to the F
mark on the dipstick.
5. Securely replace the oil-filler cap.
6. Start the engine and inspect around the
drain plug for leaks.
7. Turn it off and wait 5 minutes for the
oil to return to the oil pan.
Check the oil level and fill to the F mark if
necessary.
Oil capacity (General reference only,
refer to Specifications section for
capacities.)
Changing oil filter
Because you need a special tool to
retighten the filter, an Authorized Mazda
Dealer should do the work.

Inspecting Coolant Level
Inspect the antifreeze protection and
coolant level in the coolant reservoir at
least once a year—at the beginning of the
winter season—and before traveling
where temperatures may drop below
freezing.
Inspect the condition and connections of
all cooling system and heater hoses.
Replace any that are swollen or
deteriorated.
The coolant should be at full in the
radiator and between the FULL and LOW
marks on the coolant reservoir when the
engine is cool.
NOTE
•The indicated engine oil capacities
are for general reference purposes
only. When adding or changing oil,
verify the engine oil level with the
oil dipstick.
•Use only specified engine oil (page
10-4).
Engine Coolant
Hot Engine:
A hot engine is dangerous. If the
engine has been running, parts of the
engine compartment can become very
hot. You could be burned. Don’t
inspect the coolant system or add
coolant when the engine is hot.
WARNING
J76Y.book Page 12 Wednesday, March 27, 2002 5:04 PM

8-17
Maintenance and Care
Owner Maintenance
Form No. 8Q47-EA-01F
The level must be kept between MIN and
MAX.
Visually examine the lines and hoses for
leaks and damage.
If new fluid is required frequently, consult
an Authorized Mazda Dealer.

Inspecting Automatic Transaxle
Fluid Level
The automatic transaxle fluid level should
be inspected regularly. Measure it as
described below.
The volume of fluid changes with the
temperature. Fluid must be checked at idle
without driving at normal operating
temperature.
1. Park on a level surface and set the
parking brake firmly.
2. Idle the engine about two minutes.
Push down on the brake pedal.
3. Move the shift lever through all ranges
and set it at P.
Miller Cycle Engine V6 DOHCAutomatic Transaxle Fluid
(ATF)
•Low fluid level causes transaxle
slippage. Overfilling can cause
foaming, loss of fluid, and transaxle
malfunction.
•Use specified fluid (page 10-4). A
nonspecified fluid could result in
transaxle malfunction and failure.
CAUTION
J76Y.book Page 17 Wednesday, March 27, 2002 5:04 PM

10-5
Specifications
Form No. 8Q47-EA-01F

Capacities
(Approximate Quantities)
Check oil and fluid levels with dipsticks or reservoir gauges.

Dimensions
*With license plate holder

We i g h t s
ItemUnit
L US qt Imp qt
Engine oil2.5 liter V6 DOHCWith oil filter
replacement4.0 4.2 3.5
Without oil filter
replacement3.7 3.9 3.3
Miller Cycle
Engine V6 DOHCWith oil filter
replacement4.1 4.3 3.6
Without oil filter
replacement3.8 4.0 3.4
Coolant 7.5 7.9 6.6
Automatic transaxle
fluid2.5 liter V6 DOHC 8.0 8.4 7.0
Miller Cycle Engine V6 DOHC 7.4 7.8 6.5
Fuel tank 68 18.0 (US gal) 15.0 (Imp gal)
Item mm (in)
Overall length
4,860 (191.3), 4,870 (191.7)
*
Overall width 1,770 (69.7)
Overall height 1,395 (54.9)
Front tread 1,520 (59.8)
Rear tread 1,520 (59.8)
Wheelbase 2,750 (108.3)
Item Weight
GVWR (Gross Vehicle Weight Rating) 1,985 kg (4,376 lb)
GAWR (Gross Axle Weight Rating)Front 1,116 kg (2,460 lb)
Rear 880 kg (1,940 lb)
J76Y.book Page 5 Wednesday, March 27, 2002 5:04 PM

11-6
Index
Form No. 8Q47-EA-01F
T
Traction Control System (TCS) ....... 5-16
TCS indicator light
................... 5-16
TCS OFF indicator light
........... 5-17
TCS OFF switch
....................... 5-17
Trailer Towing
................................. 4-10
Trip Meter
........................................ 5-19
Trunk Lid
......................................... 3-10
Trunk Light
...................................... 3-11
Trunk Release Handle
...................... 3-11
Turn and Lane-Change Signals
....... 5-32
V
Vanity Mirrors ................................. 6-34
Vehicle Information Labels
............. 10-2
W
Warning Lights ................................ 5-22
ABS
.......................................... 5-27
Air bag system
.......................... 5-27
Brake system
............................ 5-24
Charging system
....................... 5-25
Check engine
............................ 5-26
Door-ajar
................................... 5-28
Engine oil pressure
................... 5-26
Low fuel
.................................... 5-28
Low washer fluid level
............. 5-28
Seat belt
.................................... 5-28
Warranty
............................................ 9-8
Washer Fluid
.................................... 8-19
Weights
............................................ 10-5
Wheel Replacement
......................... 8-27
Windows
Power windows
........................ 3-13
Windshield Washer
.......................... 5-35
Windshield Wipers
.......................... 5-34
Blades replacement
................... 8-21
W
Winter Driving ................................... 4-8
J76Y.book Page 6 Wednesday, March 27, 2002 5:04 PM