heating MAZDA MODEL MX-5 2016 Smart Start Guide (in English)

30
AUTO: Set the Fan Control and Mode Selector
Dials in the AUTO position. The airflow mode
and amount will be automatically controlled in
accordance with the set temperature.MODE SELECTOR DIAL
Rotate the dial to select
airflow mode.
Dashboard vents
Dashboard

and floor vents
Floor vents
Defroster
and floor vents
Defroster vents
Rear defroster
Automatic Climate Control
TEMPERATURE
CONTROL DIAL
Rotate the dial for
temperature control.
Push to
manually turn
air conditioning
on or off. FAN CONTROL DIAL

• Rotate the dial
to set desired
fan speed.
• Rotate dial
to OFF to turn
system of f.
Push to recirculate
cabin air to reduce
outside odors and
improve cooling
(indicator on) or
receive fresh air
(indicator off).
VENTS:
The air vents can be
opened or closed by
rotating the knob.
NOTE: Automatic
temperature control
is always on, even if
the AUTO indicator
light is turned off when
changing the fan speed
or air flow mode.
Knob Close
Open
NOTE: A/C indicator
will illuminate when
AUTO ON is active. The
air conditioning cycles
on/off as necessary
to maintain the set
temperature. The A /C
may operate even
while heating is desired
- this is to prevent
excess humidity and
fogging while the
system operates.
1860318_16_Mazda_MX5_SSG_051115.indd 305/11/15 5:50 PM

32
Automatic
Transaxle Warning
Blind Spot Monitoring OFF
(BSM) (p. 23)
KEY Warning RED
KEY Indicator GREEN
Door Ajar
Low Washer Fluid
Level Warning
Check Fuel Cap
Perform Maintenance
Lane Departure
Warning System (LDWS)
ON ( AMBER )
Lane Detected ( GREEN)
3
( p. 21)
Lane Departure

Warning System (LDWS)
OFF ( AMBER )
1 • Rotate the knob to adjust the brightness of the instrument cluster and o\
ther dashboard illuminations.2 • Push to toggle between trip meter (A & B).
• When a trip meter is selected, push and hold to reset to zero.
ENGINE COOLANT TEMP LIGHTS
Since this vehicle does not use an engine
coolant temperature gauge, red and blue
engine coolant temperature lights are used to
indicate high and low coolant temperature.
Red Coolant Temp Light
Flashing : Engine is starting to run hot.
Drive slowly to reduce engine load.
On: Engine is overheating. Safely pull
over to the side of the road and turn
the engine off. Refer to the Owner’s
Manual for more information.
Blue Coolant Temp Light On: Engine coolant is cold and no warm
air is available for heater/defroster.
Off: Engine coolant is warm and
warm air is available for heater/
defroster. The light may stay on for a
few minutes after start-up when the
engine is cold, but the vehicle can
be driven with the light on or off.
SPEEDOMETER
1860318_16_Mazda_MX5_SSG_051115.indd 325/11/15 5:50 PM
www.MazdaUSA.com