ECU MAZDA MODEL MX-5 MIATA 2010 Workshop Manual
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2010, Model line: MODEL MX-5 MIATA, Model: MAZDA MODEL MX-5 MIATA 2010Pages: 446, PDF Size: 5.61 MB
Page 301 of 446

Black plate (301,1)
3. If your vehicle has a lid, pull the latchto open.
When finished, return the seat to its
original position and secure it. After
returning the seat to its original position,
make sure the seat is secured by
attempting to lightly move it forward and
backward.
CAUTION
Do not store excessive weight in the
back trim storage box as it could be
damaged.
q Mesh Pocket
Maps or pamphlets can be placed in the
mesh pocket.
Mesh pocket
CAUTION
Do not place thick objects in the
mesh pocket as they could damage
the pocket.
Accessory Socket
The ignition switch must be in the ACC
or ON position.
Only use genuine Mazda accessories or
the equivalent requiring no greater than
120 W (DC 12 V, 10 A).
CAUTION
To prevent accessory socket damage
or electrical failure, pay attention to
the following:
Ø Do not use accessories that require
more than 120 W (DC 12 V, 10 A).
Ø Do not use accessories that are not
genuine Mazda accessories or the
equivalent.
Ø Close the cover when the accessory
socket is not in use to prevent
foreign objects and liquids from
getting into the accessory socket.
Ø Correctly insert the plug into the
accessory socket.
NOTE
To prevent discharging of the battery, do not
use the socket for long periods with the engine
off or idling.
Interior Comfort
Interior Equipment
6-83
MX-5_8AV1-EA-09F_Edition5 Page301
Friday, May 7 2010 9:17 AM
Form No.8AV1-EA-09F
Page 308 of 446

Black plate (308,1)
qJack
To remove the jack
1. Turn the knob and remove the cover.
2. Turn the wing bolt and jack screw
counterclockwise.
Wing bolt
Jack screw
To secure the jack
1. Insert the wing bolt into the jack withthe jack screw pointing back and turn
the wing bolt clockwise to temporarily
tighten it.
2. Turn the jack screw in the direction shown in the figure.
Wing bolt
Jack screw
3. Turn the wing bolt completely tosecure the jack.
NOTE
If the jack is not completely secured, it could
rattle while driving. Make sure the jack screw
is sufficiently tightened.
7-6
In Case of an Emergency
Flat Tire
MX-5_8AV1-EA-09F_Edition5 Page308
Friday, May 7 2010 9:17 AM
Form No.8AV1-EA-09F
Page 319 of 446

Black plate (319,1)
If you're unsure of how tight the nuts
should be, have them inspected at an
Authorized Mazda Dealer.
Nut tightening torque
N·m (kgf·m, ft·lbf) 88
―118
(9 ― 12, 65 ―87)
WARNING
Always securely and correctly tighten
the lug nuts:
Improperly or loosely tightened lug
nuts are dangerous. The wheel could
wobble or come off. This could result
in loss of vehicle control and cause a
serious accident.
Be sure to reinstall the same nuts you
removed or replace them with metric
nuts of the same configuration: Because the wheel studs and lug nuts
on your Mazda have metric threads,
using a non-metric nut is dangerous.
On a metric stud, it would not secure
the wheel and would damage the
stud, which could cause the wheel to
slip off and cause an accident.
5. Check the inflation pressure. Refer to the specification charts on page 10-7.
WARNING
Do not drive with any tires that have
incorrect air pressure: Driving on tires with incorrect air
pressure is dangerous. Tires with
incorrect pressure could affect
handling and result in an accident. NOTE
To prevent the jack and tool from rattling, store
them properly.
(With Tire Pressure Monitoring System)
A tire pressure sensor is not installed to the
temporary spare tire. The warning light will
flash continuously while the temporary spare
tire is being used (page 5-31).
In Case of an Emergency
Flat Tire
7-17
MX-5_8AV1-EA-09F_Edition5 Page319
Friday, May 7 2010 9:17 AM
Form No.8AV1-EA-09F
Page 326 of 446

Black plate (326,1)
NOTElBefore installing the battery cover, make
sure both of the cables connecting the
negative battery terminal (right side of
battery) are connected with the cables
routed toward the right and back of the
battery as shown in the figure.
lVerify that the covers are securely installed.
Push-Starting
Do not push-start your Mazda.
WARNING
Never tow a vehicle to start it:Towing a vehicle to start it is
dangerous. The vehicle being towed
could surge forward when its engine
starts, causing the two vehicles to
collide. The occupants could be
injured.
CAUTION
Do not push-start a vehicle that has
a manual transmission. It can
damage the emission control system.
NOTE
You can't start a vehicle with an automatic
transmission by pushing it.
7-24
In Case of an Emergency
Emergency Starting
MX-5_8AV1-EA-09F_Edition5 Page326
Friday, May 7 2010 9:17 AM
Form No.8AV1-EA-09F
Page 328 of 446

Black plate (328,1)
Tiedown Hooks
CAUTION
Do not use the front and rear
tiedown eyelets for towing the
vehicle.
The have been designed only for
securing the vehicle to a transport
vessel during shipping.
Using the eyelets for any other
purpose could result in the vehicle
being damaged.
qTiedown Hooks
1. Remove the tiedown eyelet, lug
wrench, and jack lever from the trunk
(page 7-5).
2. Wrap the jack lever with a soft cloth to prevent damage to a painted bumper,
and open the cap located on the front or
rear bumper.
Front
Type A
Type B
Rear
CAUTION
Ø Do not use excessive force as it
may damage the cap or scratch
the painted bumper surface.
Ø The rear bumper cover cannot be
removed completely. Attempting
to forcefully remove the rear
bumper cover could result in it
being damaged.
NOTE
Remove the front bumper cover completely and
store it so as not to lose it.
3. Securely install the tiedown eyelet using the lug wrench.
7-26
In Case of an Emergency
Emergency Towing
MX-5_8AV1-EA-09F_Edition5 Page328
Friday, May 7 2010 9:17 AM
Form No.8AV1-EA-09F
Page 329 of 446

Black plate (329,1)
Front
Lug wrench
Rear
Lug wrench
4. Hook the tying rope to the tiedowneyelet.
Front
Rear
CAUTION
If the tiedown eyelet is not securely
tightened, it may loosen or disengage
from the bumper when tying down
the vehicle. Make sure that the
tiedown eyelet is securely tightened
to the bumper.
In Case of an Emergency
Emergency Towing
7-27
MX-5_8AV1-EA-09F_Edition5 Page329
Friday, May 7 2010 9:17 AM
Form No.8AV1-EA-09F
Page 359 of 446

Black plate (359,1)
NOTElRemove the rubber hose first, and then
battery cover before performing battery
maintenance.
Battery coverRubber hose
lBefore installing the battery cover, make
sure both of the cables connecting the
negative battery terminal (right side of
battery) are connected with the cables
routed toward the right and back of the
battery as shown in the figure.
qBattery Maintenance
To get the best service from a battery:lKeep it securely mounted.lKeep the top clean and dry.lKeep terminals and connections clean,
tight, and coated with petroleum jelly
or terminal grease.
lRinse off spilled electrolyte
immediately with a solution of water
and baking soda.
lIf the vehicle will not be used for an
extended time, disconnect the battery
cables.
Maintenance and Care
Owner Maintenance
8-29
MX-5_8AV1-EA-09F_Edition5 Page359
Friday, May 7 2010 9:17 AM
Form No.8AV1-EA-09F
Page 442 of 446

Black plate (442,1)
F
Flat Tire ............................................... 7-3Changing .................................... 7-13
Instant Mobility System
(IMS) Emergency Flat Tire Repair
Kit ................................................ 7-7
Tool storage .................................. 7-5
Fluids
Classification .............................. 10-4
Owner maintenance ................... 8-15
Fog Lights ......................................... 5-58
Foot Brake .......................................... 5-6
Fuel Filler lid and cap ........................ 3-40
Gauge ......................................... 5-39
Requirements ............................... 4-2
Tank capacity ............................. 10-5
Fuses ................................................. 8-42 Panel description ........................ 8-45
Replacement ............................... 8-42
G
Glove Box ......................................... 6-82
H
Hazard Warning Flasher .................... 5-61
Hazardous Driving .............................. 4-7
HeadlightsControl ....................................... 5-56
Flashing ...................................... 5-57
High-low beam .......................... 5-57
On reminder ............................... 5-56
HomeLink Wireless Control
System .............................................. 5-62
Hood Release .................................... 3-42
Horn .................................................. 5-61
I
Ignition
Keys ........................................... 3-23
Switch .......................................... 5-2
Immobilizer System
(with Advanced Key) ........................ 3-63
Immobilizer System
(without Advanced Key) ................... 3-67
Indicator Lights ................................. 5-41 Cruise ......................................... 5-53
DSC OFF .................................... 5-53
Headlight high-beam .................. 5-52
KEY ............................................ 5-50
Security ...................................... 5-52
Shift position .............................. 5-52
TCS/DSC ................................... 5-53
Turn-signal/hazard warning ....... 5-54
Inside Trunk Release Lever ............... 3-35
Instrument Cluster ............................. 5-36
Interior Care ...................................... 8-55
Interior Lights ................................... 6-80
J
Jump-Starting .................................... 7-21
K
Keyless Entry System ....................... 3-24
Keys .................................................. 3-23
L
Label Information ............................. 10-2
Lane-Change Signals ........................ 5-58
Light Bulbs Replacement ............................... 8-34
Specifications ............................. 10-6
Lighting Control ............................... 5-56
11-4
Index
MX-5_8AV1-EA-09F_Edition5 Page442
Friday, May 7 2010 9:18 AM
Form No.8AV1-EA-09F
Page 443 of 446

Black plate (443,1)
L
Lubricant Quality .............................. 10-4
M
MaintenanceIntroduction .................................. 8-2
Owner maintenance
precautions ................................. 8-16
Owner maintenance schedule ..... 8-15
Scheduled ..................................... 8-3
Manual Transmission Operation ....... 5-11 Recommendations for shifting.... 5-12
Mesh Pocket ..................................... 6-83
Mirrors Outside mirrors .......................... 3-73
Rearview mirror ......................... 3-74
Money-Saving Suggestions ................ 4-6
Multi Pocket ...................................... 6-81
O
Odometer and Trip Meter .................. 5-37
Outside Mirrors ................................. 3-73
Outside Temperature Display ............ 5-37
Overhead Lights ................................ 6-80
Overheating ....................................... 7-18
Overloading ...................................... 4-11
P
Paint Damage .................................... 8-48
Parking Brake ..................................... 5-7
Parking in an Emergency .................... 7-2
Power Door Locks ............................ 3-31
Power Retractable Hardtop ............... 3-48
Power Steering .................................. 5-21
Fluid ........................................... 8-23
Power Windows ................................ 3-37
P
Push-Starting ..................................... 7-24
R
Rear Window Defroster .................... 5-60
Rearview Mirror ................................ 3-74
Recreational Towing ......................... 7-28
Registering Your Vehicle in A Foreign
Country ............................................. 9-18
Rocking the Vehicle ............................ 4-8
S
Safety Defects, Reporting ................. 9-42
Seat Belt System 3-point type ................................ 2-11
Automatic locking ...................... 2-10
Belt minder ................................. 2-16
Caution label .............................. 2-12
Emergency locking ...................... 2-9
Extender ..................................... 2-15
Pregnant women .......................... 2-9
Pretensioner and load limiting .... 2-13
Seat belt precautions .................... 2-7
Warning light/beep ..................... 2-16
Seats .................................................... 2-2
Seat warmer .................................. 2-5
Security System Immobilizer system
(with advanced key) ................... 3-63
Immobilizer system
(without advanced key) .............. 3-67
Theft-deterrent system ............... 3-71
Service Publications .......................... 9-44
Soft Top ............................................ 3-43
Specifications .................................... 10-4
Speedometer ...................................... 5-37
Starting the Engine .............................. 5-4
Index
11-5
MX-5_8AV1-EA-09F_Edition5 Page443
Friday, May 7 2010 9:18 AM
Form No.8AV1-EA-09F