headlamp MAZDA MODEL TRIBUTE 2008 Quick Tips (in English)
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2008, Model line: MODEL TRIBUTE, Model: MAZDA MODEL TRIBUTE 2008Pages: 15, PDF Size: 3.69 MB
Page 4 of 15

GETTING STARTED
Always check the Owner’s Manual for more operating information and safety features 
Lighting control knob= Lights off
=  Tail, parking and 
dashboard lights on: Rotate 
knob to first notch
=  Tail, parking, dashboard 
and headlights on: Rotate knob 
to second notch
= Autolamp control*: 
With ignition switch in ON position;
headlights and exterior lights
automatically turn ON/OFF
depending on surrounding 
darkness/lightness
A
= Foglamp control:
Pull headlamp control knob
towards you while in 
,   
or position
Tip: Exterior lights turn on
automatically with ignition 
on, headlamp control in
Autolamp position and 
windshield wipers activated
for a fixed period of time.
Turn signals/headlight high
beams/wiper/washer lever
High beams on/off: Push lever 
forward to detent/pull back.
To flash high beams: Pull lever
rearward and release.
A
Ignition switch must be in ACC 
or ON position.
To turn on wipers: Rotate knob (
1)
forward to increase; turn rearward
to decrease speed.
To activate washers: Push in end of
knob (1); will also operate wipers.
Rear wiper/washer 
0= OFF
1= Intermittent: Rotate 
knob (2) to first notch
2= Normal speed: Rotate 
knob (2) to second notch
= Rear wash/wiper cycle:
Rotate knob (2) to third notch,
hold as desired
Tip: Courtesy wipe feature 
will give one extra wipe a few
seconds after wipers are turned
off, this will help clear off 
any residual drops left from
using the washer fluid.
Cruise control*Operates above 30 mph. 
Press ON (1).
To set speed:Press and release
SET+ (2) at desired speed; hold 
(2) to accelerate.
To decelerate:Press and hold
CST – (3), release at desired 
speed; or tap brake pedal, press
and release (2) at desired speed.Incremental deceleration:
Press and release (3), each 
tap = minus 1 mph.
Incremental acceleration:
Press and release (2), each 
tap = plus 1 mph.
To cancel: Tap brake/clutch* 
pedal or press OFF button (1).
Return to preset speed 
(after braking):Press and 
release RESUME button (4).
Tilt steering-wheel 
release lever
Pull lever (5) down to unlock column
and pull up to lock column.
WARNING: Do not adjust 
steering-wheel while driving
because you may lose control
of the vehicle.
Getting
Started
Getting
Started
RES
UME
SET
 +
C
ST –
O
FF   
ON1324
5*Denotes optional equipment
A
2
1
0
0
12