MAZDA MX5 MIATA 2017 Owners Manual

4 –107 When Driving
Tire Pressure Monitoring SystemNOTE
Because this system detects slight changes in tire conditions, the timing of the warning may
be faster or slower in the following cases: 
The size, manufacturer, or the type of tires is different from the specification. 
The size, manufacturer, or the type of a tire is different from the others, or the level of tire
wear is excessively different between them. 
A run-flat tire, studless tire, snow tire, or tire chains are used. 
An emergency tire is used (The tire pressure monitoring system warning light may flash
and then continue illuminating). 
A tire is repaired using the emergency flat tire repair kit. 
The tire pressure is excessively higher than the specified pressure, or the tire pressure is
suddenly lowered for some reason such as a tire burst during driving. 
The vehicle speed is lower than about 15 km/h (9.3 mph) (including when the vehicle is
stopped), or the drive period is shorter than 5 minutes. 
The vehicle is driven on an extremely rough road or a slippery, icy road. 
Hard steering and rapid acceleration/deceleration are repeated such as during aggressive
driving on a winding road. 
Load on the vehicle is applied to a tire such as by loading heavy luggage to one side of
the vehicle. 
System initialization has not been implemented with the specifie d tire pressure.
MX-5_8FR4-EA-16J_Edition1.indb 107 2016/08/11 20:29:05

4 –10 8 When Driving
Tire Pressure Monitoring System Tire Pressure Monitoring System
InitializationIn the following cases, system
initialization must be performed so that the
system operates normally. 
A tire pressure is adjusted. 
Tire rotation is performed. 
A tire or wheel is replaced. 
The battery is replaced or completely
drained. 
The tire pressure monitoring system
warning light is illuminated.
Initialization method
1. Park the car in a safe place and firmly
apply the parking brake.
2. Let the tires cool, then adjust the tire
pressure of all four (4) tires to the
specified pressure indicated on the tire
pressure label located on the driver's
door frame (door open).
Refer to Tires on page 9-8 .
3. Switch the ignition ON.
4. Press and hold the tire pressure
monitoring system set switch and
verify that the tire pressure monitoring
system warning light in the instrument
cluster flashes twice and a beep sound
is heard once. CAUTION If the system initialization is performed
without adjusting the tire pressure,
the system cannot detect the normal
tire pressure and it may not illuminate
the tire pressure monitoring system
warning light even if a tire pressure is
low, or it may illuminate the light even
if the pressures are normal.
Adjust the tire pressure on all four
tires and initialize the system when
the warning light is turned on. If the
warning light turns on for a reason
other than a flat tire, the tire pressure
of all four tires may have decreased
naturally.
The system initialization will not be
performed if the switch is pressed while
the vehicle is being driven.
MX-5_8FR4-EA-16J_Edition1.indb 108 2016/08/11 20:29:06

5 –15 Interior Features Use of various features for ride comfort, including air-conditioning and
audio system.
Climate Control System ..................................................................... 5-2
Operating Tips ............................................................................... 5-2
Vent Operation
.............................................................................. 5-3
Manual Type
................................................................................. 5-5
Fully Automatic Type
.................................................................... 5-9
Audio System .................................................................................... 5-13
Antenna
....................................................................................... 5-13
Operating Tips for Audio System
............................................... 5-14
Audio set [Type A (non-touchscreen)]
........................................ 5-22
Audio set [Type B (touchscreen)]
............................................... 5-34
Audio Control Switch Operation
................................................ 5-55
AUX/USB mode
......................................................................... 5-57
Bluetooth ®
......................................................................................... 5-74
Bluetooth ®
................................................................................... 5-74
Bluetooth ®
Hands-Free (Type A) ................................................ 5-97
Bluetooth ®
Hands-Free (Type B) .............................................. 5-103
Bluetooth ®
Audio (Type A) ....................................................... 5-113
Bluetooth ®
Audio (Type B) ....................................................... 5-115
Troubleshooting
........................................................................ 5-129
Interior Equipment ........................................................................ 5-132
Sunvisors
................................................................................... 5-132
Interior Lights
........................................................................... 5-132
Accessory Sockets
.................................................................... 5-134
Cup Holder
................................................................................ 5-135
Storage Compartments
.............................................................. 5-138
Windblocker
.............................................................................. 5-140
MX-5_8FR4-EA-16J_Edition1.indb 1 2016/08/11 20:29:06

5 –2 Interior Features
Climate Control System
Operating Tips 
Operate the climate control system with
the engine running. 
To prevent the battery from being
discharged, do not leave the fan control
dial on for a long period of time with the
ignition switched ON when the engine is
not running. 
Clear all obstructions such as leaves,
snow and ice from the hood and the air
inlet in the cowl grille to improve the
system efficiency. 
Use the climate control system to defog
the windows and dehumidify the air. 
The recirculate mode should be used
when driving through tunnels or while in
a traffic jam, or when you would like to
shut off outside air for quick cooling of
the interior. 
Use the outside air position for
ventilation or windshield defrosting. 
If the vehicle has been parked in direct
sunlight during hot weather, open the
windows to let warm air escape, then
run the climate control system. 
Run the air conditioner about 10 minutes
at least once a month to keep internal
parts lubricated. 
Have the air conditioner checked before
the weather gets hot. Lack of refrigerant
may make the air conditioner less
efficient.
The refrigerant specifications are
indicated on a label attached to the
inside of the engine compartment. Check
the label before refilling the refrigerant.
If the wrong type of refrigerant is used,
it could result in a serious malfunction
of the air conditioner.
For details, consult an Authorized
Mazda Dealer. Label
MX-5_8FR4-EA-16J_Edition1.indb 2 2016/08/11 20:29:06

5 –3 Interior Features
Climate Control System
Vent Operation Adjusting the VentsDirecting airflow
To adjust the direction of airflow, move the
adjustment knob.
NOTE
When using the air conditioner under
humid ambient temperature conditions,
the system may blow fog from the vents.
This is not a sign of trouble but a result of
humid air being suddenly cooled.
Center vents (driver) and Side vents
Air vent open/close
NOTE
The air vents can be fully opened and
closed by operating the knob. Open
Close
Knob
Airflow direction adjustment
Knob Center vents (passenger)
Air vent open/close OpenClose
Knob
Airflow direction adjustment
Knob
MX-5_8FR4-EA-16J_Edition1.indb 3 2016/08/11 20:29:06

5 –4 Interior Features
Climate Control System Selecting the Airflow ModeDashboard Vents
Dashboar d and Floor Vents
Floor Vents Defroster and Floor Vents
Defroster Vents
MX-5_8FR4-EA-16J_Edition1.indb 4 2016/08/11 20:29:07

5 –5 Interior Features
Climate Control System
Manual Type Rear window defogger switchAir intake selector switch Fan control dialTemperature control dial
A/C switch
Rear window defogger switchAir intake selector switchA/C switch Mode selector dial
Fan control dialTemperature control dial Mode selector dialType A
T
ype B
MX-5_8FR4-EA-16J_Edition1.indb 5 2016/08/11 20:29:07

5 –6 Interior Features
Climate Control System Control SwitchesTemperature control dial
This dial controls temperature. Turn it
clockwise for hot and counterclockwise
for cold.
NOTE
(Type A)
When the mode is set to
, or a position
in between them with the fan control dial
in a position other than 0 and the
temperature control dial in the maximum
cold position, the air intake selector
switches to the recirculated air position
and the A/C turns on automatically.
If A/C is not desired, press the A/C switch
to turn it off.
Fan control dial
This dial allows variable fan speeds.
The fan has seven speeds.
Mode selector dial
Turn the mode selector dial to select
airflow mode (page 5-4 ).
NOTE 
The mode selector dial can be set at the
intermediate positions ( ) between
each mode. Set the dial to an
intermediate position if you want to split
the airflow between the two modes. 
For example, when the mode selector
dial is at the position between the
and positions, airflow from the floor
vent is less than that of the position. A/C switch
Press the A/C switch to turn the air
conditioner on. The indicator light on the
switch will illuminate when the fan control
dial is in any position except OFF.
Press the switch once again to turn the air
conditioner off.
NOTE
The air conditioner may not function when
the outside temperature approaches 0 °C
(32 °F).
Air intake selector
This switch controls the source of air
entering the vehicle.
Outside or recirculated air positions can be
selected. Press the switch to select outside/
recirculated air positions.
Recirculated air position (indicator light
illuminated)
Outside air is shut off. Use this position
when going through tunnels, driving in
congested traffic (high engine exhaust
areas) or when quick cooling is desired.
Outside air position (indicator light
turned off)
Outside air is allowed to enter the
cabin. Use this mode for ventilation or
windshield defrosting.
WARNING Do not use the position in cold or
rainy weather:
Using the
position in cold or rainy
weather is dangerous as it will cause
the windows to fog up. Your vision will
be hampered, which could lead to a
serious accident.
MX-5_8FR4-EA-16J_Edition1.indb 6 2016/08/11 20:29:07

5 –7 Interior Features
Climate Control SystemRear window defogger switch
Press the rear window defogger switch to
defrost the rear window.
Refer to Rear Window Defogger on page
4-55 .
Heating1. Set the mode selector dial to the
position.
2. Set the air intake selector to the outside
air position (indicator light turns off).
3. Set the temperature control dial to the
hot position.
4. Set the fan control dial to the desired
speed.
5. If dehumidified heating is desired, turn
on the air conditioner.
NOTE 
If the windshield fogs up easily, set the
mode selector dial to the position.
If cooler air is desired at face level, set
the mode selector dial at the position
and adjust the temperature control dial
to maintain maximum comfort. 
The air to the floor is warmer than air
to the face (except when the temperature
control dial is set at the extreme hot or
cold position).
Cooling (With air conditioner)
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the
cold position.
3. Set the fan control dial to the desired
speed.
4. Turn on the air conditioner by pressing
the A/C switch.
5. After cooling begins, adjust the fan
control dial and temperature control
dial as needed to maintain maximum
comfort. CAUTION If the air conditioner is used while
driving up long hills or in heavy
traffic, monitor the engine coolant
temperature warning light to see if it is
illuminated or flashing (page 4-18 ).
The air conditioner may cause engine
overheating. If the warning light is
illuminated or flashing, turn the air-
conditioning off (page 7-27 ).
NOTE 
When maximum cooling is desired,
set the temperature control dial to the
extreme cold position and set the air
intake selector to the recirculated air
position, then turn the fan control dial
fully clockwise. 
If warmer air is desired at floor level,
set the mode selector dial at the
position and adjust the temperature
control dial to maintain maximum
comfort. 
The air to the floor is warmer than air
to the face (except when the temperature
control dial is set at the extreme hot or
cold position).
Ventilation
1. Set the mode selector dial to the
position.
2. Set the air intake selector to the outside
air position (indicator light turns off).
3. Set the temperature control dial to the
desired position.
4. Set the fan control dial to the desired
speed.
MX-5_8FR4-EA-16J_Edition1.indb 7 2016/08/11 20:29:08

5 –8 Interior Features
Climate Control System Windshield Defrosting and
Defogging1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the
desired position.
3. Set the fan control dial to the desired
speed.
4. If dehumidified heating is desired, turn
on the air conditioner.
WARNINGDo not defog the windshield using the
position with the temperature
control set to the cold position:
Using the
position with the
temperature control set to the cold
position is dangerous as it will cause
the outside of the windshield to fog up.
Your vision will be hampered, which
could lead to a serious accident. Set
the temperature control to the hot or
warm position when using the

position.
NOTE 
For maximum defrosting, turn on the air
conditioner, set the temperature control
dial to the extreme hot position, and
turn the fan control dial fully clockwise. 
If warm air is desired at the floor, set the
mode selector dial to the position.
When the fan control dial is ON, and the
mode selector dial is in the or
position, the air conditioner is
automatically turned on and the outside
air position is automatically selected to
defrost the windshield. In the
or
position, the outside air position cannot
be changed to the recirculated air
position. Dehumidifying (With air
conditioner) Operate the air conditioner in cool or cold
weather to help defog the windshield and
side windows.
1. Set the mode selector dial to the desired
position.
2. Set the air intake selector to the outside
air position (indicator light turns off).
3. Set the temperature control dial to the
desired position.
4. Set the fan control dial to the desired
speed.
5. Turn on the air conditioner by pressing
the A/C switch.
NOTE
One of the functions of the air conditioner
is dehumidifying the air and, to use
this function, the temperature does not
have to be set to cold. Therefore, set the
temperature control dial to the desired
position (hot or cold) and turn on the air
conditioner when you want to dehumidify
the cabin air.
MX-5_8FR4-EA-16J_Edition1.indb 8 2016/08/11 20:29:08