dashboard warning lights MAZDA MX5 MIATA 2017 Owners Manual

3 –7 Before Driving
KeysNOTE
The panic button will work whether any
door or the trunk lid is open or closed.
(Turning on the alarm)
Pressing the panic button for 1 second or
more will trigger the alarm for about 2
minutes and 30 seconds, and the following
will occur: 
The horn sounds intermittently. 
The hazard warning lights flash.
(Turning off the alarm)
The alarm stops by pressing any button on
the key.
Operational RangeThe system operates only when the driver
is in the vehicle or within operational
range while the key is being carried.
Starting the Engine
NOTE 
Starting the engine may be possible
even if the key is outside of the vehicle
and extremely close to a door and
window, however, always start the
engine from the driver's seat.
If the vehicle is started and the key
is not in the vehicle, the vehicle will
not restart after it is shut off and the
ignition is switched to off. 
The trunk is out of the assured
operational range, however, if the key
(transmitter) is operable the engine will
start. With the advanced keyless function Interior antenna
Operational range
Without the advanced keyless function
Operational rangeInterior antenna
NOTE
The engine may not start if the key is
placed in the following areas: 
Around the dashboard 
In the storage compartments or the
center console
Key Suspend Function
If a key is left in the vehicle, the
functions of the key left in the vehicle are
temporarily suspended to prevent theft of
the vehicle.
To restore the functions, press the unlock
button on the functions-suspended key in
the vehicle.
MX-5_8FR4-EA-16J_Edition1.indb 7 2016/08/11 20:28:29

4 –89 When Driving
i-ACTIVSENSEReverse driving (Rear Cross Traffic Alert (RCTA) system operation)
The Rear Cross Traffic Alert (RCTA) system detects vehicles approaching from the left and
right of your vehicle and flashes the Blind Spot Monitoring (BSM ) warning lights.
Function for cancelling illumination dimmer
If the Blind Spot Monitoring (BSM) warning lights turn on when the parking lights are
turned on, the brightness of the Blind Spot Monitoring (BSM) wa rning lights is dimmed.
If the Blind Spot Monitoring (BSM) warning lights are difficult to see due to glare from
surrounding brightness when traveling on snow-covered roads or under foggy conditions,
press the dimmer cancellation button to cancel the dimmer and increase the brightness of
Blind Spot Monitoring (BSM) warning lights when they turn on.
Refer to Dashboard Illumination on page 4-15 .
Blind Spot Monitoring (BSM) warning beep
The Blind Spot Monitoring (BSM) warning beep is activated simul taneously with the
flashing of a Blind Spot Monitoring (BSM) warning light.
MX-5_8FR4-EA-16J_Edition1.indb 89 2016/08/11 20:29:02