steering MERCEDES-BENZ C-CLASS 1999 Workshop Manual

Replacing Wiper Blade Insert

For safety reasons, remove electronic key from steering lock before replacing the wiper blade, otherwise
the motor can suddenly turn on and cause injury.

Notes:
Do not open engine hood with wiper arm folded forward.
Do not allow the wiper arm to contact the windshield glass without a wiper blade inserted. The glass may be
scratched or broken. Make certain that the wiper blade is pr operly installed. An improperly installed blade may cause
windshield damage.






Removal:
Fold wiper arm forward. Press
safety tab down (1), push wiper
blade downward (2) and remove.
Place wiper blade on firm support.
Slide (direction of arrow) the wiper
blade insert out of the retainer
claws.





Installation:
Slide (direction of arrow) wiper
blade insert into retainer claws until
tabs are engaged.
Insert wiper blade between tabs (3)
on the wiper arm, and slide into
end of wiper arm. Press safety tab
upward until it locks in place.


Headlamp Wiper Blades


Removal:
Fold wiper arm forward. Push pin
(1) and remove wiper blade.

Installation:
Place wiper blade on wiper arm
and press in pin (1).


ProCarManuals.com

C230

C 280, C 43 AMG



Layout of Poly-V-belt Drive

1. Automatic belt tensioner
2. Crankshaft
3. Air conditioning compressor
4. Generator (alternator)

5. Idler pulley
6. Power steering pump
7. Coolant pump, fan

For dimensions of the poly-V-belt, see Technical Data in Index.

Spare Parts Service

All authorized Mercedes-Benz dealers maintain a stock of original spare parts required for maintenance and repair
work.
In addition, strategically located parts distributi on centers provide quick and reliable parts service.
More than 300,000 different spare parts, for other Mercedes-Benz models, are available.
Mercedes-Benz original spare parts are subjecte d to the most stringent quality inspections.
Each part has been specifically developed, manufactured or selected for and adapted to Mercedes-Benz vehicles.
Therefore, Mercedes-Benz original spare parts should be installed.

Important !

The use of non-genuine parts and accessories not authorized by Mercedes-Benz could damage the vehicle or
compromise its durability or safety.


ProCarManuals.com

Fuels, Coolants, Lubricants etc. - Capacities

Vehicle components and their respective lubricants must match Therefore use only brands tested and
recommended by us. Please refer to the Factory Approv ed Service Products pamphlet, or inquire at your
authorized Mercedes-Benz dealer.

Model Capacity Fuels, coolan ts,
lubricants etc
Engine with
oil filter C 230 6.5 US qt (6.2 l)
C 280 8.5US qt 8.0 l)
C 43 AMG 7.9US qt 7.5 l)
Recommended
engine oils
Automatic transmission C 230 7.9 US qt (7.5 l)
C 280 7.9 US qt (7.5 l)
C 43 AMG 9.9 US qt (9.4 l)
Automatic
transmissio
n fluid
Rear axle C 230
C 280 1.2 US qt (1.1 l)
C 43 AMG 1.4 US qt(1.3 l)
Hypoid gear oil SAL
90, 85 W 90
Power steering approx 1.1 US qt (1.0 l)
MB Power steering
fluid
Front wheel hubs

approx. 2.1 oz (60 g) each High temperature
roller bearing grease

Accelerator
control linkage


Hydraulic fluid
Brake system approx. 0.5 US qt (0.5 I) MB Brake fluid (DOT
4)
Windshield washer

and headlamp
cleaning system
approx. 5.3 US qt (5.0 I)
MB Windshield
washe

r
concentrate "S"
1
Cooling system C 220 approx. 10.0 US qt (9.5 I
C 280
C 36 AMG
approx. 10.6 US qt 10.0 I)
approx. 11.8 US qt (11.2 I
MB
Anticorrosion/antifreez
Fuel tank including
a reserve of
approx. 16.4 US gal (62.0 I)
approx. 2.1 US gal (8.0 I)
Premium unleaded
gasoline:
Posted O
c

tane 91
(Avg. of 96 RON/86
MON)
Air conditioner system

R-134a refrigerant
and special
lubricant (Never R-12)

Use MB Windshield Washer Concentrate "S" and water for temperatures above freezing or MB Windshield Washer
Con c

entrate "S" and commercially available premixed windsh ield washer solvent/antifreeze for temperatures below
freezing. Follow suggested mixing ratios, see Windshield/Headlamp Washer System in Index.


ProCarManuals.com