high beam MERCEDES-BENZ C CLASS COUPE 2004 Owners Manual

Contents
Introduction.......................................... 9
Product information ................................ 9
Operator’s Manual ............................... 10 Service and warranty information .. 10
Important notice for California
retail buyers and lessees of
Mercedes-Benz automobiles .......... 11
Maintenance .................................. 12
Roadside Assistance ...................... 12
Change of address or ownership.... 12
Operating your vehicle
outside the USA or Canada ............ 13
Where to find it .................................... 14
Symbols ............................................... 15
Operating safety .................................. 16 Proper use of the vehicle ............... 16
Problems with your vehicle .................. 17
Reporting safety defects...................... 18 Reporting Safety Defects ............... 18At a glance ......................................... 19
Cockpit ................................................ 20
Instrument cluster ............................... 22
Multifunction steering wheel ............... 24 Center console ..................................... 25
Upper part ...................................... 25
Lower part ...................................... 26
Overhead control panel ........................ 27
Door control panel................................ 28
Getting started ................................... 29
Unlocking ............................................. 30 Unlocking with the SmartKey.......... 30
Adjusting .............................................. 32 Seats............................................... 32
Steering wheel ................................ 37
Mirrors ............................................ 39
Driving .................................................. 41 Fastening the seat belt ................... 41
Starting the engine ......................... 44
Switching on headlamps ................. 48
Turn signals .................................... 48
High beam ...................................... 48
Windshield wipers ........................... 49
Problems while driving .................... 50
Parking and locking .............................. 52 Parking brake.................................. 52
Switching off headlamps................. 53
Turning off the engine ..................... 53
Safety and Security ........................... 55
Occupant safety ................................... 56 Airbags ........................................... 57
Seat belts ....................................... 62
Children in the vehicle .................... 65
Panic alarm* ........................................ 72 Activating........................................ 72
Deactivating.................................... 72
Driving safety systems ......................... 73 ABS ................................................. 73
BAS ................................................. 74
ESP ................................................. 75
Anti-theft systems ................................ 78 Immobilizer ..................................... 78
Anti-theft alarm system* ................ 78
Tow-away alarm* ............................ 79Controls in detail ................................ 81
Locking and unlocking ......................... 82 Keys ................................................ 82
Opening the doors from the inside . 85
Opening the trunk lid ...................... 85
Closing the trunk lid ....................... 86
Trunk lid emergency release ........... 86

21
At a glance
Cockpit
Item
Page
1
Headlamp washer switch*
148
2
Combination switch
48


Turn signals
48


Windshield wipers
49


High beam
102
3
Cruise control lever
194
4
Instrument cluster
22,
105
5
Multifunction steering
wheel
24,
110
6
Horn
7
Lever for voice control
system*, see separate op-
erating instructions
8
Overhead control panel
27
9
Glove box lid release
200
Item
Page
a
Glove box lid
200
b
Center console
25
c
Starter switch
31
d
Steering wheel adjustment
handle, manual
38
e
Hood lock release
236
f
Parking brake pedal
46
g
Power window switches
186
h
Steering wheel adjustment
stalk, electrical*
38
j
Parking brake release
46
k
Door control panel
28
l
Exterior lamp switch
48, 98
m
Exterior mirror adjustment
40

23
At a glance
Instrument cluster
Item
Page
1
Reset button for:

Resetting trip odome-
ter
107


Instrument cluster illu-
mination
105


Resetting individual
settings
119
2
Tachometer with:?
Engine malfunction
indicator lamp
260
-Antilock Brake Sys-
tem (ABS) malfunc-
tion warning lamp
258
;Brake warning
lamp, except Cana-
da
259
3Brake warning
lamp, Canada only
259
Item
Page
3
Speedometer with:LLeft turn signal indi-
cator lampKRight turn signal in-
dicator lampvElectronic Stability
Program (ESP)
warning lamp
261
AHigh beam head-
lamp indicator
102
EIndicator lamp
without function
1
DTRIndicator lamp
without function
1
1The indicator lamp illuminates briefly when you
turn the SmartKey in the starter switch to
position 2
Item
Page
4
Multifunction display
with:Trip odometer
107
Main odometerOutside temperature dis-
play
107
Digital clock
122
Display for program mode
and gear selector lever
position
142
144
5
Fuel gauge with:Fuel reserve warning lamp
262
warning lamp
262
1Supplemental re-
straint system indi-
cator lamp
262

48 Getting startedDrivingSwitching on headlampsExterior lamp switch1Off
2 Low beam headlamps on
Turn the switch to B.
For more information on headlamps, see
“Lighting” (
page 98).
Turn signals
The combination switch is located on the
left of the steering column.Combination switch1 Turn signal, right
2 Turn signal, left
Press the combination switch up 1 or
down 2.
The corresponding turn signal indicator
lamp L or K in the instrument clus-
ter flashes.
High beam
Push the combination switch forward.
The high beam symbol A in the
instrument cluster comes on.
For more information on high beam, see
“Combination switch” (
page 102).
1 High beam
2 High beam flasher
iTo signal minor directional changes,
move combination switch to point of
resistance only and release. The turn
signal flashes three times.

98 Controls in detailLighting
LightingFor information on how to switch on the
headlamps and use the turn signals, see
the “Getting started” section (
page 48).
Exterior lamp switch
The exterior lamp switch is located on the
dashboard to the left of the steering wheel M
Off
U Automatic headlamp mode
C Parking lamps (also side marker
lamps, tail lamps, license plate
lamps, instrument panel lamps)
Canada only: When engine is run-
ning, the low beam is also switched
on.
B Low beam plus parking lamps or
high beam headlamps (combination
switch pushed forward).
ˆ Standing lamps, right (turn left one
stop)
‚ Standing lamps, left (turn left two
stops)
iIf you drive in countries where vehicles
drive on the other side of the road than
the country where the vehicle is regis-
tered, you must have the headlamps
modified for symmetrical low beams.
Relevant information can be obtained
at your authorized Mercedes-Benz Cen-
ter.

100 Controls in detailLighting
Daytime running lamp mode
Turn exterior lamp switch to
positionM orU .
When the engine is running, the low beam
headlamps are automatically switched on.
In low ambient light conditions, the parking
lamps will also switch on.
Canada only
When you shift from a driving position to
position N or P, the low beam switches off
(with a three-minute delay).
For nighttime driving you should turn the
exterior lamp switch to position B to
permit activation of the high beam head-
lamps. USA only
The high beam headlamps can also be ac-
tivated when driving with the daytime run-
ning lamp mode activated and exterior
lamp switch in position
M.
To activate the daytime running lamp
mode, see “Setting daytime running lamp
mode (USA only)” (
page 125).
Locator lighting and night security illu-
mination
Locator lighting and night security illumi-
nation are described in the control system
section under “Setting locator lighting”
(
page 126) and “Exterior lamps delayed
shut off” (
page 127).
iWith the daytime running lamp mode
activated, the low beam headlamps will
not be switched off automatically.iThe front fog lamps and rear fog lamp
cannot be switched on manually with
exterior lamp switch in position U.
To activate the fog lamps, turn exterior
lamp switch to position B and pull
the exterior lamp switch to first or sec-
ond stop.
iFor exterior lamp switch, see
(page 98).

102 Controls in detailLightingCombination switch
The combination switch is located on the
left side of the steering column.1 High beam
2 High beam flasher
Switching on high beams
Turn exterior lamp switch to
position B or to U (
page 98).

Push the combination switch in
direction 1.
The high beam indicator B on the
instrument cluster is illuminated
(page 22). High beam flasher

Pull the combination switch briefly in
direction
2.
Hazard warning flasher
The hazard warning flasher can be activat-
ed with the ignition switched on or off. It is
activated automatically when an airbag is
deployed.
The switch is located on the center con-
sole.
1 Hazard warning flasher switch Switching on the hazard warning
flasher

Press the hazard warning flasher
switch.
All turn signals will flash.
Switching off the hazard warning
flasher

Press hazard warning flasher switch
again.iWith the hazard warning flasher acti-
vated and the combination switch set
for either left or right turn, only the re-
spective left or right turn signals will
operate when the SmartKey in the
starter switch is in position 1 or 2.iIf the hazard warning flasher was acti-
vated automatically press switch 1
twice.

278 Practical hintsWhat to do if …Display symbol
Display message
Possible cause
Possible solution
.
FRONT FOGLIGHT, L
CHECK LIGHT!
The left front fog lamp is malfunctioning.

Replace the bulb as soon as possible.
FRONT FOGLIGHT, R
CHECK LIGHT!
The right front fog lamp is malfunctioning.

Replace the bulb as soon as possible.
REAR FOGLIGHT
CHECK LIGHT!
The rear fog lamp is malfunctioning.

Replace the bulb as soon as possible.
HIGH BEAM, L
CHECK LIGHT!
The left high beam lamp is
malfunctioning.

Replace the bulb as soon as possible.
HIGH BEAM, R
CHECK LIGHT!
The right high beam lamp is
malfunctioning.

Replace the bulb as soon as possible.
LIGHT SENSOR
VISIT WORKSHOP!
The lamp sensor is malfunctioning. The
headlamps switch on automatically.

In the control system, set lamp
operation to manual (
page 125).

Switch on headlamps using the
exterior lamp switch.

Visit an authorized Mercedes-Benz
Center as soon as possible.
LICENSE PLATE LIGHT, L
CHECK LIGHT!
The left license plate lamp is
malfunctioning.

Replace the bulb as soon as possible.
LICENSE PLATE LIGHT, R
CHECK LIGHT!

The right license plate lamp is
malfunctioning.

Replace the bulb as soon as possible.

293
Practical hints
Replacing bulbs
 Replacing bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp as-
semblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See your autho-
rized Mercedes-Benz Center for headlamp
adjustment.
Bulbs Front lamps
iBackup bulbs will be brought into use
when the following lamps malfunction:

Rear fog lamp


Tail lamps


Standing lamps
Lamp
Type
1
Additional turn sig-
nal lamps
LED
2
Turn signal lamp
Halogen headlamp
Turn signal lamp
Bi-Xenon* headlamp
1156A
2357A
3
Halogen headlamps:
Low beam
Bi-Xenon* head-
lamps:
Low and high beam
H7 (55W)
D2S-35W
4
Halogen headlamps:
High beam
Bi-Xenon* head-
lamps:
High beam flasher
H7 (55 W)
H7 (55 W)
Parking and stand-
ing lamp
W 5 W
5
Fog lamp
HB4/9006
(55 W)

295
Practical hints
Replacing bulbs
Replacing bulbs for front lamps
Halogen headlamps
1 Bulb socket for turn signal lamp
2 Headlamp cover for high beam head-
lamp and for parking and standing
lamp
3 Headlamp cover for low beam head-
lamp 4
Low beam bulb
5 High beam bulb
6 Parking and standing lamp
Low and high beam bulb

Switch off the lights.

Open the hood (
page 236).

Turn headlamp cover 2 or 3 to the
left and remove.

Turn bulb holder with bulb to the left
and pull out.

Pull out the bulb from the base (do not
pull on glass tube).

Insert new bulb so that the base fits in
the bulb holder recess and is level.

Place the bulb holder with bulb on the
headlamp mounting and turn the bulb
holder to the right until it engages.

Replace headlamp cover 2 or 3 and
turn to the right until it engages.
Front turn signal lamp bulb

Switch off the lights.

Open the hood (
page 236).

Turn bulb socket 1 to the left and pull
out.

Push bulb into socket, turn to the left
and remove.

Insert new bulb in socket, push in and
turn to the right.

Reinsert bulb socket in lamp and turn
to the right.