set clock MERCEDES-BENZ C WAGON 2005 S203 Owner's Manual

25 At a glance
Instrument cluster
Item
Page
1
Speedometer with:vElectronic Stability
Program (ESP)
warning lamp
81,
298
;Brake warning
lamp, USA only
47,
55,
295
3Brake warning
lamp, Canada only
47,
55,
295
BLow beam head-
lamp indicator lamp
49,
108
2
LLeft turn signal
indicator lamp
50
3
Multifunction display
with:
119
Trip odometer
117
Main odometer
119
Gear selector lever
position
46,
156
Item
Page
Program mode
158
Status indicator (outside
temperature/digital
speedometer
118,
134
Digital clock
119,
135
4
KRight turn signal
indicator lamp
50
5
Tachometer with:
118
-Antilock Brake
System (ABS)
indicator lamp
79,
294
úEngine malfunction
indicator lamp,
USA only
296,
297
±Engine malfunction
indicator lamp,
Canada only
296,
297
1Supplemental
restraint system
indicator lamp
60,
299
Item
Page
66,
299
AHigh beam head-
lamp indicator lamp
49,
112
6
Fuel gauge with:Fuel reserve warning lamp
299
4Fuel filler cap
location indicator:
The fuel filler cap is
on the rear
right-hand side.
7
Coolant temperature
gauge
117
8
Reset button for:

Resetting trip
odometer
117


Resetting individual
settings
130


Instrument cluster
illumination
116

116 Controls in detailInstrument clusterFor a full view illustration of the instrument
cluster, see “At a glance” (
page 24).
1Reset button
The instrument cluster is activated when
you


open a door


switch on ignition


press reset button1


switch on the exterior lamps
You can change the instrument cluster
settings in the Instrument cluster submenu
of the control system (
page 133).
Instrument cluster illumination
Use reset button1 to adjust the
illumination brightness for the instrument
cluster.To brighten illumination

Turn reset button1 clockwise.
The instrument cluster illumination will
brighten.
To dim illumination

Turn reset button1 counterclock-
wise.
The instrument cluster illumination will
dim.
iThe instrument cluster illumination is
dimmed or brightened automatically to
suit ambient light conditions.
The instrument cluster illumination will
also be adjusted automatically when
you switch on the vehicle’s exterior
lamps.

119 Controls in detail
Control system
Control system
The control system is activated as soon as
the SmartKey in the starter switch is
turned to position1. The control system
enables you to

call up information about your vehicle


change vehicle settings
For example, you can use the control
system to find out when your vehicle is
next due for service, to set the language
for messages in the instrument cluster
display, and much more.
The control system relays information to
the multifunction display.
Multifunction display
1Trip odometer
2Main odometer
3Current program mode
4Current gear selector lever
position/gear range
5Digital clock
6Status indicator (outside tempera-
ture/digital speedometer)
iThe displays for the audio systems
(radio, CD player) will appear in English,
regardless of the language selected.
Warning!
G
A driver’s attention to the road and traffic
conditions must always be his/her primary
focus when driving.
For your safety and the safety of others,
selecting features through the multifunction
steering wheel should only be done by the
driver when traffic and road conditions
permit it to be done safely.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.

137 Controls in detail
Control system
Selecting time display mode
Move the selection marker with
buttonæ orç to the
Time/Date

submenu.

Press buttonj ork repeatedly
until the message
Clock display

appears in the multifunction display.
The selection marker is on the current
setting.

Press buttonæ orç to set
the
12h
or
24h
time display mode.Selecting automatic time change
(Daylight Saving Time (DST)
summer/Standard time winter)

Move the selection marker with
buttonæ orç to the
Time/Date

submenu.

Press buttonj ork repeatedly
until the message
Change-over
Summer / Winter time
appears in the
multifunction display.
The selection marker is on the current
setting.

Press buttonæ orç to select if
the changeover between summer and
winter time should be automatic or
manual.
Setting the date (month)
This function can only be seen with audio
system.

Move the selection marker with
buttonæ orç to the
Time/Date

submenu.

Press buttonj ork repeatedly
until the message
Date Set MM
appears
in the multifunction display.
iVehicles with COMAND*:
For information on setting the date,
refer to the separate COMAND
operating instructions.


268 OperationAt the gas station
Open the fuel filler flap by pushing at
the point indicated by arrow1.
The fuel filler flap springs open.

Turn fuel cap counterclockwise and
hold on to it until possible pressure is
released.

Take off cap and set it in direction of
arrow2 in the recess on fuel filler
flap.
To prevent fuel vapors from escaping
into open air, fully insert filler nozzle
unit.

Only fill your tank until the filler nozzle
unit cuts out – do not top up or
overfill.

Replace fuel cap by turning it
clockwise.
You will hear when fuel cap is
tightened.

Close fuel filler flap.Warning!
G
Overfilling of the fuel tank may create
pressure in the system which could cause a
gas discharge. This could cause the gas to
spray back out when removing the fuel
pump nozzle, which could cause personal
injury.
iOnly use premium unleaded gasoline
with a minimum Posted Octane Rating
of 91 (average of 96 RON/86 MON).
Information on gasoline quality can
normally be found on the fuel pump.
More information on gasoline can be
found in the Factory Approved Service
Products pamphlet.
Flexible Fuel Vehicles are identified by
a label reading Premium gasoline or
E85 only! on fuel filler flap.
For more information, see “Flexible
Fuel Vehicles” (
page 377).
iLeaving the engine running and the fuel
cap open can cause theú malfunc-
tion indicator lamp (USA only) or
the± malfunction indicator lamp
(Canada only) to illuminate.
For more information, see “Practical
hints” (
page 296) and (
page 297).


323 Practical hints
Where will I find ...?
Operational position
Turn crank handle clockwise until it
engages (operational position).
Before storing the vehicle jack in its
compartment:


It should be fully collapsed.


The handle must be folded in (storage
position).Setting up the collapsible wheel chock
The collapsible wheel chock serves to
additionally secure the vehicle, e.g. while
changing the wheel.
1Tilt the plates upward
2Fold the lower plate outward
3Insert the plate

Tilt both plates upward1.

Fold the lower plate outward2.

Guide the tabs of the lower plate all the
way into the openings of the base
plate3.

338 Practical hintsReplacing bulbsFront turn signal lamp bulb
Turn bulb socket3 with the bulb
counterclockwise and remove it.

Press gently onto the bulb and turn it
counterclockwise out of bulb
socket3.

Press new bulb gently into bulb
socket3 and turn clockwise until it
engages.

Place bulb socket3 back into the
lamp and turn it clockwise.Parking and standing lamp bulb

Press the clamp on housing cover2
and remove it.

Pull out bulb socket5 with the bulb.

Pull the bulb out of bulb socket5.

Press the new bulb into bulb socket5.

Press bulb socket5 back into the
lamp.

Align housing cover2 and press until
it engages.Side marker lamp

Carefully slide the lamp towards the
rear in direction of arrows.

Remove the front end first.

Turn the bulb socket with the bulb
counterclockwise and remove it.

Pull the bulb out of the bulb socket.

Insert the new bulb into the bulb
socket.

Place the bulb socket back into the
lamp and turn it clockwise.

To reinstall the lamp, set the rear end in
the bumper and let the front end
engage.

349 Practical hints
Battery
Reconnecting the battery
Turn off all electrical consumers.

Remove SmartKey from starter switch.

Connect the battery positive lead and
fasten its cover2.

Connect the battery negative lead.

Reinstall the filter box (
page 347).Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12 volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
!NEVER invert the terminal connections.!The battery, its filler caps and the vent
tube must always be securely installed
when the vehicle is in operation.
iThe following procedures must be
carried out following any interruption of
battery power (e.g. due to reconnec-
tion):

Set the clock (
page 135).
Vehicles with COMAND*:
See COMAND operator’s manual.


Synchronize side windows
(page 218).


Synchronize tilt/sliding sunroof*
(page 222).

413 Index
Seats 97
Adjusting 35
Easy entry/exit feature* 97
Heating* 104
Manual seat 36
Multicontour seat* 103
Power seat* 38
Split rear bench seat 230
Securing cargo
Cargo tie-down rings 233
Selecting
Automatic time change
(Daylight Saving Time
(DST) summer/winter) 137
Display for status indicator 134
station (satellite radio) 190
Selecting radio mode 183
Selector lever see gear selector lever
Self-test
BabySmart
TM air bag
deactivation system 72
Tele Aid* 243Service
Parts 362
Service and Warranty Booklet
Loss of 363
Service and warranty information 10
Service life (tires) 279
Service see Maintenance
Service System see FSS
Setting
Convenience functions 132, 144
Cruise control 224
Date (day) 138
Date (month) 137
Date (year) 139
Daytime running lamp mode 140
Exterior rear view mirror
parking position* 107
Higher speed in cruise control 225
Hours (clock) 135
Individual vehicle settings 130
Instrument lighting 116
Interior lighting delayed shut-off 143Key dependent memory 145
Lamps and lighting
(control system) 139
Language, multifunction display 134
Locator lighting 141
Lower speed in cruise control 225
Miles/kilometers
in speedometer 133
Minutes (clock) 136
Night security illumination 141
Parking position* for exterior
rear view mirrors 146
Radio station 190
Slower speed in cruise control 225
Speed in cruise control 225
Speedometer display mode 133
Temperature (interior) 169
Temperature indicator 133
Time display mode (Clock) 137
Units
Speedometer 133
Temperature 133