park assist MERCEDES-BENZ C240 4MATIC WAGON 2003 S203 Owner's Manual

51 Getting started
Parking and locking
Parking and locking
You have now completed your first drive.
You have properly stopped and parked
your vehicle. End your drive as follows.
Parking brake
1Release handle
2Parking brake
Step firmly on parking brake 2.
When the engine is running, the indica-
tor lamp
;
(USA only) or
3

(Canada only) in the instrument cluster
will be illuminated.
Warning!
G
Wait until the vehicle is stationary before re-
moving the key from the starter switch. The
vehicle cannot be steered when the key is
removed.Warning!
G
With the engine not running, there is no
power assistance for the brake and steering
system. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to stop or steer the vehi-
cle.
Warning!
G
Do not park this vehicle in areas where com-
bustible materials such as grass, hay or
leaves can come into contact with the hot
exhaust system, as these materials could be
ignited and cause a vehicle fire.
To reduce the risk of personal injury as a re-
sult of vehicle movement, before turning off
the engine and leaving the vehicle always:

Keep right foot on brake pedal.


Firmly depress parking brake pedal.


Move the selector lever to positionP
(manual transmission: first or reverse
gear).


Slowly release brake pedal.


When parked on an incline, turn front
wheels towards the road curb.


Turn the key to starter switch position0
and remove.


Take the key and lock vehicle when leav-
ing.
S203 MY03_A.book Page 51 Tuesday, January 28, 2003 2:22 PM

216 Controls in detailUseful featuresUpgrade signals
The Tele Aid system processes calls using
the following priority.

Automatic emergency – First priority


Manual emergency – Second priority


Roadside assistance – Third priority


Information – Fourth priority
Should a higher priority call be initiated
while you are connected, an upgrade (al-
ternating) tone will be heard, and the ap-
propriate indicator lamp will flash. If
certain information such as vehicle identi-
fication number or customer information is
not available, the operator may need to re-
transmit.
During this time you will hear a beep and
voice contact will be interrupted. Voice
contact will resume once the retransmis-
sion is completed. Once a call is conclud-
ed, a beep will be heard and the
appropriate indicator lamp will stop flash-
ing. The COMAND* system operation will
resume.
!If the indicator lamp continues to flash
or the system does not reset, contact
the Response Center at
1-800-756-9018 (in the USA) or
1-888-923-8367 (in Canada), or
Mercedes-Benz Customer Assistance
at 1-800-FOR-MERCedes
(1-800-367-6372) in the USA or Cus-
tomer Service at 1-800-387-0100 in
Canada.iThe indicator lamp in the respective
button flashes until the call is conclud-
ed. Calls can only be terminated by a
Response Center or Customer Assis-
tance Center representative except
Roadside Assistance and Information
calls, which can also be terminated by
pressing button
ì
on the multifunc-
tion steering wheel.
iWhen a Tele Aid call has been initiated,
the audio system or the COMAND* sys-
tem audio is muted and the selected
mode (radio, tape or CD) pauses. The
optional cellular phone (if installed)
switches off. If you must use this
phone, the vehicle must be parked. Dis-
connect the coiled cord and place the
call. The COMAND* navigation system
(if engaged) will continue to run. The
display in the instrument cluster is
available for use and spoken com-
mands are only available by pressing
the RPT button on the COMAND* unit.
A pop-up window will appear in the
COMAND* display to indicate that a
Tele Aid call is in progress.
S203 MY03_A.book Page 216 Tuesday, January 28, 2003 2:22 PM

224 OperationDriving instructionsBrakesTo help prevent brake disk corrosion after
driving on wet road surfaces (particularly
salted roads), it is advisable to brake the
vehicle with considerable force prior to
parking. The heat generated serves to dry
the brakes.
If your brake system is normally only sub-
jected to moderate loads, you should occa-
sionally test the effectiveness of the
brakes by applying above-normal braking
pressure at higher speeds. This will also
enhance the grip of the brake pads.
If the parking brake is released and the
brake warning lamp in the instrument clus-
ter stays on, the brake fluid level in the res-
ervoir is too low.Brake pad wear or a leak in the system may
be the reason for low brake fluid in the res-
ervoir.
Have the brake system inspected at an au-
thorized Mercedes-Benz Center immedi-
ately.
All checks and service work on the brake
system should be carried out by an autho-
rized Mercedes-Benz Center.
Only install brake pads and brake fluid rec-
ommended by Mercedes-Benz.Warning!
G
After driving in heavy rain for some time
without applying the brakes or through wa-
ter deep enough to wet brake components,
the first braking action may be somewhat
reduced and increased pedal pressure may
be necessary to obtain expected braking ef-
fect. Maintain a safe distance from vehicles
in front.
Resting your foot on the brake pedal will
cause excessive and premature wear of the
brake pads.
It can also result in the brakes overheating,
thereby significantly reducing their effec-
tiveness. It may not be possible to stop the
vehicle in sufficient time to avoid an acci-
dent.
!Be very careful not to endanger other
road users when you apply the brakes.
Refer to the description of the Brake
Assist System (BAS) (
page 75).
Warning!
G
If other than recommended brake pads are
installed, or other than recommended brake
fluid is used, the braking properties of the
vehicle can be degraded to an extent that
safe braking is substantially impaired. This
could result in an accident.
S203 MY03_A.book Page 224 Tuesday, January 28, 2003 2:22 PM

342 Technical termsPower train
Collective term designating all compo-
nents used to generate and transmit
motive power to the drive axles, includ-
ing


engine


clutch/torque converter


transmission


transfer case


drive shaft


differential


axle shafts/axles
Program mode selector switch
Used to switch the automatic transmission
between standard operation S and winter
operation W.Remote Vehicle Diagnostics
Transmission of vehicle data and current
location to the Mercedes-Benz Customer
Assistance Center for subscribers to
Tele Aid service.
REST
(Residual engine heat utilization)
Feature that uses the engine heat
stored in the coolant to heat the vehi-
cle interior for a short time after the en-
gine has been turned off.
Restraint systems
Seat belts, belt tensioners, airbags and
child restraint systems. As independent
systems, their protective functions com-
plement one another.RON
(Research Octane Number)
The Research Octane Number for gaso-
line as determined by a standardized
method. It is an indication of a gaso-
line's ability to resist undesired detona-
tion (knocking). The average of both
the ->MON (Motor Octane Number)
and RON (Research Octane Number) is
posted at the pump, also known as AN-
TI-KNOCK INDEX.
Shift lock
When the vehicle is parked, this lock pre-
vents the transmission selector lever from
being moved out of position P without key
turned and brake pedal depressed.
SRS
(Supplemental Restraint System)
Seat belts, emergency tensioning de-
vice and airbags. Though independent
systems, they are closely interfaced to
provide effective occupant protection.
S203 MY03_A.book Page 342 Tuesday, January 28, 2003 2:22 PM

347 Index
Gear shifting malfunctions 140
Kickdown 140
Manual shifting 136
One-touch gearshifting 136
Program mode selector switch 139
Selector lever position 135
Starting with 44
Transmission fluid 237
Winter program mode 139
Auxiliary fuse box 315
B
BabySmart
TM
Airbag deactivation system 67
Compatible child seats 67
Self-test 67
BabySmart
TM airbag deactivation
system 339
BabySmartTM compatible child
seats 339
Backrest
Folding forward 199
Folding rearward 200
Backrest tilt 33
Backup lamps 293, 298
Bulbs 293BAS 75, 339
Messages in display 262
Batteries, electronic key
Checking 86
Batteries, SmartKey
Changing 287
Check lamp 85
Checking 86
Battery discharged
Jump starting 308
Battery, vehicle 239, 305
Charging 306
Disconnecting 306
Messages in display 278
Reconnecting 307
Reinstalling 306
Removing 306
Bi-Xenon headlamps* 339
Bi-Xenon type
Front lamp bulbs 295
Block heater 245
Blocking
Rear door window operation 71
Bolts
For Minispare wheel 284
For spare wheel 282Brake assist system (BAS) 339
Brake fluid 233, 330
Brake lamp bulbs 293
Brake lamp, high mounted 293
Brake pads
Message in display 263
Brakes 224
Break-in period 222
Bulbs, replacing 292
Additional turn signals 292
Backup lamps 293
Brake lamps 293
Fog lamps 292
Front lamps 292
High beam 292
High mounted brake lamp 293
License plate lamps 293, 298
Low beam 292
Parking lamps 292, 293, 295, 296
Rear fog lamp 293
Rear fog lamps 297
Side marker lamps 292, 297
Standing lamps 292, 293, 295, 296
Tail lamp assemblies 293, 297
Turn signal lamps 292, 293
S203 MY03_A.book Page 347 Tuesday, January 28, 2003 2:22 PM

359 Index
Overhead control panel 27
P
Paintwork 249
Panic alarm 72
Panic button on SmartKey 72
Parcel net
In cargo compartment 196
In front passenger footwell 206
Parking 51, 225
Parking brake 46, 51
Engaging 51
Message in display 275
Releasing 46
Parking lamps
Replacing bulbs 292, 293, 295, 296
Switching on 98
Parking position
Exterior rear view mirrors 97, 128,
142
Partition net 197
Parts see Spare parts service 318
Passenger compartment 229
Fuse box in 314
Inside rear view mirror 38
Interior lighting 102Parcel net in front passenger
footwell 206
Passenger safety see Occupant
safety 56
Pedals 223
Performance
In cold weather 333
In hot weather 333
Phone book*
Loading 132
Quick search 133
Phone number*
Dialing 132
Redialing 133
Plastic and rubber parts
Cleaning 252
Playing
CDs 175
Poly-V-belt drive 341
Layout 321
Positions (Memory function*)
Recalling from memory 96
Storing into memory 96
Power assistance 223Power seat*
Adjusting 34
Adjusting backrest tilt 35
Adjusting head restraint height 35
Adjusting head restraint tilt 35
Adjusting seat cushion tilt 35
Adjusting seat height 35
Front seat head restraints 91
Seat fore and aft adjustment 34
Power train 342
Power washer 249
Power windows 184
Blocking of rear door window
operation 71
Side windows 184
Synchronizing 186
Practical hints
First aid kit 279
Fuses 314
Lamp in center console 259
Lamps in instrument cluster 254
Messages in the display 260
Spare wheel 281
Spare wheel bolts 282
Towing the vehicle 310
Vehicle jack 280
S203 MY03_A.book Page 359 Tuesday, January 28, 2003 2:22 PM

361 Index
Replacing
Backup lamp bulbs 297
Brake lamp bulbs 297
Bulbs 292
Front lamp bulbs 294
Front turn signal bulbs 294, 295
Fuses 315
High beam bulbs 294
High beam bulbs (xenon-type
headlamps) 295
License plate lamp bulbs 298
Low beam bulbs 294
Parking lamp bulbs 295, 296
Rear fog lamp bulbs 297
Rear lamp bulbs 293, 297
Rear turn signal bulbs 297
Side marker lamp bulbs 297
Standing lamp bulbs 295, 296
Wiper blades 299
Reporting
Safety defects 18
Reset knob in the instrument cluster 116
Resetting
All functions (control system) 116
All functions of a submenu 117
Fuel consumption 129Service indicator (FSS) 247
Trip odometer 105
Residual heat utilization 159
Residual ventilation 159
REST 342
Restraint system see Infant and child re-
straint systems 65, 69
Restraint systems 342
Reverse (manual transmission)
Shifting into 134
Rims 323
Roadside Assistance 12
Roadside assistance
Tele Aid* 213
Rolling code programming 219
RON 233
RON (Research Octane Number) 342
Roof rack 193
Rotating wheels 243
Rubber parts
Cleaning 252
S
Safety
Occupant 56
Safety belts see Seat belts 40Safety defects
Reporting 18
Safety systems
Driving 73
Saving current speed 191
Searching
Radio station 113
Seat belt force limiter 64
Seat belt height adjustment 42
Front seats 42
Rear outer seats 42
Seat belts 61
Cleaning 252
Fastening 40
Height adjustment 42
Proper use of 43, 63
Safety guidelines 59
Warning lamp 258
Seat cushion depth
Adjusting 93
Seat heater
Switching off 94
Switching on 94
S203 MY03_A.book Page 361 Tuesday, January 28, 2003 2:22 PM