remote start MERCEDES-BENZ C280 2006 W203 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2006, Model line: C280, Model: MERCEDES-BENZ C280 2006 W203Pages: 474
Page 24 of 474
23 At a glance
Cockpit
Item
Page
1
Cruise control lever
247
2
Multifunction steering
wheel
26,
131
3
Horn
4
Instrument cluster
24,
127
5
Lever for voice control
system*, see separate
operating instructions
6
Overhead control panel
29
7
Glove box lid release
257
8
Glove box lock
257
Item
Page
9
Center console
27
a
Starter switch
33
b
Hood lock release
297
c
Steering wheel adjustment
handle (manual)
40
d
Steering wheel adjustment
lever (electrical)*
41
e
Parking brake pedal
50, 58
f
Remote trunk opening
switch
104
g
Door control panel
30
h
Parking brake release
50
Item
Page
j
Combination switch
Turn signals
53
Windshield wipers
53
High beam
52
k
Exterior lamp switch
52,
118
l
Exterior rear view mirror
adjustment
43,
117
m
Headlamp washer button*
170
Page 33 of 474
32 Getting startedThe “Getting started” section provides an
overview of the vehicle’s most basic func-
tions. First-time Mercedes-Benz owners
should pay special attention to the infor-
mation given here.
If you are already familiar with the basic
functions described here, the “Controls in
detail” section (
page 98) will provide you
with further information. The correspond-
ing page references are located at the end
of each segment.
Unlocking
Unlocking with the SmartKeySmartKey with remote control 1‹Lock button
2ŠOpening button for trunk
3ŒUnlock button
4ÂPanic button* (
page 86)
Press unlock buttonŒ on the
SmartKey.
All turn signal lamps flash once. The
locking knobs in the doors move up.
The anti-theft alarm system* is
disarmed.
Get in the vehicle and insert the
SmartKey in the starter switch.
For more information, see “Locking and
unlocking” (
page 98).
iCanada only:
Only vehicles equipped with an
anti-theft alarm system* have
SmartKeys with integrated panic
button*4.
Page 99 of 474
98 Controls in detailIn the “Controls in detail” section you will
find detailed information on how to oper-
ate the equipment installed on your vehi-
cle. If you are already familiar with the
basic functions of your vehicle, this section
will be of particular interest to you.
To quickly familiarize yourself with the ba-
sic functions of the vehicle, refer to the
“Getting started” section of this manual.
The corresponding page numbers are giv-
en at the beginning of each segment.
For more information on locking and
unlocking, see “Getting started”
(page 32) and (
page 57).
Locking and unlocking
SmartKey
Your vehicle comes supplied with two
SmartKeys, each with remote control and
a removable mechanical key.
The locking tabs for the mechanical key
portion of the two SmartKeys are a
different color to help distinguish each
SmartKey unit.
The SmartKey provides an extended oper-
ating range. To prevent theft, however, it is
advisable to only unlock the vehicle when
you are in close proximity to it.
The SmartKey centrally locks and unlocks:
the doors
the trunk
the fuel filler flap
SmartKey with remote control1‹ Lock button
2Š Opening button for trunk
3Mechanical key locking tab
4Œ Unlock button
5Battery check lamp
6Â Panic button* (
page 86)
iCanada only:
Only vehicles equipped with an
anti-theft alarm system* have
SmartKeys with integrated panic
button6.
Page 276 of 474
275 Controls in detail
Useful features
Step 3:
Hold the end of the hand-held remote
control5 of the device you wish to
train approximately 2 to 5 in (5
to12 cm) away from the signal trans-
mitter button (2, 3 or4) to be pro-
grammed, while keeping the indicator
lamp1 in view.
Step 4:
Using both hands, simultaneously
press the hand-held remote control
button6 and the desired signal trans-
mitter button (2, 3 or4). Do not
release the buttons until step 5 is com-
pleted.
The indicator lamp1 will flash, first
slowly and then rapidly.Step 5:
After the indicator lamp1 changes
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter but-
ton.Step 6:
Press and hold the just-trained signal
transmitter button (2, 3 or4) and
observe the indicator lamp1.
If the indicator lamp1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3 or4) is pressed and re-
leased.
iThe indicator lamp1 flashes immedi-
ately the first time the signal transmit-
ter button is programmed. If this button
has already been programmed, the in-
dicator lamp will only start flashing af-
ter 20 seconds.
iIf the indicator lamp1 flashes rapidly
for about 2 seconds and then turns to a
constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the “rolling code”
feature.
Page 278 of 474
277 Controls in detail
Useful features
Step 12:
Confirm the garage door operation by
pressing the programmed signal trans-
mitter button (2, 3 or4).
Step 13:
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner. If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
Press and hold the signal transmitter
button (2, 3 or4). Do not release
this button until it has been successful-
ly trained.
While still holding down the signal
transmitter button (2, 3 or4),
“cycle” your hand-held remote control
button6 as follows: Press and hold
button6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, the
indicator lamp1 will flash slowly and
then rapidly after several seconds.
iSome garage door openers (or other
rolling code equipped devices) may re-
quire you to press, hold for 2 seconds
and release the same signal transmit-
ter button a third time to complete the
training process.
Page 279 of 474
278 Controls in detailUseful features
Proceed with programming step 5 and
step 6 to complete. Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Switch on the ignition (
page 33).
Press and hold the desired signal
transmitter button (2, 3 or4).
Do not release the button.
The indicator lamp1 will begin to
flash after 20 seconds. Without releas-
ing the signal transmitter button, pro-
ceed with programming starting with
step 3.Operation of integrated remote control
Switch on the ignition (
page 33).
Select and press the appropriate inte-
grated signal transmitter button (2,
3 or4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
iUpon completion of programming the
integrated remote control, make sure
you retain the hand-held remote con-
trol that came with the garage door
opener, gate operator or other device.
You may need it for use in other vehi-
cles, for future programming of an
integrated remote control, or simply for
continued use as a hand-held remote
control to operate the respective
device in other situations.
Page 459 of 474
458 IndexControl system submenus 132, 134
Convenience 153
Instrument cluster 143
Lighting 149
Time/Date 145
Vehicle 152
Controller Area Network see CAN system
Coolant 301, 444
Anticorrosion/antifreeze
quantity 445
Capacities 440, 441
Checking coolant level 295, 301
Messages in display 371–373
Temperature 293
Temperature gauge 25, 128
Corner-illuminating front fog lamps* 123
Replacing bulbs 398
Cruise control 247, 450
Message in display 374
Cup holder 259, 260
Cleaning 346
Curb weight 331
Customer Assistance Center see CACD
Date display, setting 147, 148
Daytime running lamp mode 120
Setting 149
Deep water see Standing water
Defogging windshield
Automatic climate control*
(Canada only) 192
Climate control 181
Defrosting, Front
Automatic climate control*
(Canada only) 191
Climate control 181
Defrosting, Rear 175
Delayed shut-off
Exterior lamps 151
Interior lighting 152
Department of Transportation see DOT
Difficulties
While driving 56
With starting 50
Digital clock see clock
Digital speedometer 135Dimensions, vehicle 438
Direction of rotation (tires) 307
Displays
Digital speedometer 135
Maintenance service indicator 338
Messages in display 374
Multifunction display 130
Outside temperature 135
Symbol messages 369
Text messages 360
Vehicle status messages
memory 139, 358
Distance to empty (range),
Trip computer 156
Door control panel 30
Doors
Entry lamps 126
Locking/unlocking, SmartKey 98
Message in display 374
Opening from inside/outside 100,
102
Remote door unlock (Tele Aid*) 272
Unlocking, Mechanical key 389
Page 460 of 474
459 Index
DOT 331
Downhill driving
Cruise control 248
Drinking and driving 283
Driving
Abroad 290
Hydroplaning 287
In winter 289
Instructions 45, 283
Problems 56
Safety systems 87
Systems 247
Through standing water 290
Driving safety systems
4MATIC 92
ABS 87
BAS 88
ESP
®
89E
Easy-entry/exit feature* 42, 153
Electrical fuses see Fuses
Electrical outlet 263
Electrical system, Technical data 437
Electronic Stability Program see ESP
®
Emergency calls
911 calls 237
Tele Aid* calls 267, 268, 271
Emergency operation
(Limp Home Mode) 169
Emergency operations
Fuel filler flap 391
Gear selector lever, Unlocking 392
Locking/unlocking the vehicle 389
Power tilt/sliding sunroof*,
Manual operation 393
Remote door unlock 272
Trunk lid, Releasing from inside 105
Trunk lid, Unlocking 390
Emergency Tensioning Device see ETDEmergency, in case of
Battery, Jump starting 415
First aid kit 350, 383
Flat tire, Changing 406
Fuses 421
Hazard warning flasher 124
Instrument cluster,
Indicator lamps 350–355
Roadside Assistance 12, 268
Towing the vehicle 417
Emission control 292
Information label 428
System warranties 10
Engine
Belt layout 429
Block heater (Canada only) 337
Brake-in recommendations 282
Cleaning 343
Compartment 297
Malfunction indicator lamp 25, 352
Maximum engine speed 430
Page 464 of 474
463 Index
J
Jack 383
Jacking up the vehicle 407
Jump starting 415
K
Key, mechanical 389
Key, SmartKey
Batteries 101
Battery check lamp 101
Changing batteries 396
Factory setting 100
Locking/unlocking 32, 100
Locking/unlocking, Global
setting 100
Locking/unlocking, Selective
setting 100
Loss of 102
Messages in display 376
Opening and closing the power
windows 243
Opening and closing the tilt/sliding
sunroof* 243
Positions in starter switch 33Remote control 98
Starting the engine 48, 49
Turning off the engine 59
Unlocking, Trunk lid 102
Valet locking 106
Kickdown 165, 451
Kilopascal 332
L
Labels 428
Certification 428
Emission control information 428
Emission control vacuum line
routing 428
Lamp sensor
Message in display 378
Lamps, exterior 398, 399
Light sensor 378
Messages in display 377, 378, 379,
380
Lamps, indicator and warning
ABS 25, 350
Battery (SmartKey) 100
Brakes 25, 351Engine diagnostics 352, 355
Engine malfunction 25, 352–353
ESP
®
25, 354
Fog lamps 118
Front passenger front air bag off 27,
68
Fuel reserve 25, 354
High beam headlamps 25
Instrument cluster 350, 355
Low beam headlamps 25
Maintenance service indicator 338
Rear fog lamp 118
Seat belt telltale 25
SRS 25, 63, 355
Turn signals 25
Language, Setting 143
LATCH-type child seat anchors see
Children in the vehicle
Leather upholstery, Cleaning and
care of 348
License plate lamps
Messages in display 378
Replacing bulbs 399