seats MERCEDES-BENZ C320 2003 W203 Owner's Guide
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2003, Model line: C320, Model: MERCEDES-BENZ C320 2003 W203Pages: 376, PDF Size: 5.97 MB
Page 94 of 376
94 Controls in detailSeatsHead restraints
Information on head restraint adjustment
can be found in the “Getting started” sec-
tion (
page 32).Front seat head restraints, manual seat
Removing front head restraints
Pull head restraint to its highest posi-
tion.
Push button1 and pull out head re-
straint.
Installing front head restraints
Insert head restraint and push it down
to the stop.
Push button1 and adjust head re-
straint to desired position.Front seat head restraints, power seat*
Removing front head restraints
Press switch1 upwards and hold until
the head restraint is fully extended.
Pull out head restraint.
Installing front head restraints
Press switch1 upwards and hold for
about five seconds.
Push the head restraint down until it
engages.
Adjust head restraint to desired posi-
tion (
page 34).
Warning!
G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint to support the back of
the head approximately at ear level.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.iTilt the backrest to the rear for easier
removal and installation of the head re-
straints.
Page 95 of 376
95 Controls in detail
Seats
Rear seat head restraints (outer seats)Removing rear head restraints
Pull head restraint to its highest posi-
tion.
Push button1 and pull out head re-
straint.
Installing rear head restraints
Insert head restraint and push it down
until it engages.
Push button1 and adjust head re-
straint to desired position.
Warning!
G
For safety reasons, always drive with the
rear head restraints in the upright position
when the rear seats are occupied.
Keep the area around head restraints clear
of articles (e.g. clothing) to not obstruct the
folding operation of the head restraints.
!The center rear seat head restraint can-
not be removed.
Page 96 of 376
96 Controls in detailSeatsMulticontour seat*
Some models may be equipped with driv-
er’s multicontour seat. This seat has a
movable seat cushion and inflatable air
cushions built into the backrest to provide
additional lumbar and side support.
The seat cushion movement, backrest
cushion height and curvature can be con-
tinuously varied with regulators on the
right side of the seat after turning the
SmartKey in the starter switch to
position2.1Seat cushion depth
2Backrest bottom
3Backrest center
4Side bolster adjustment
Adjusting the multicontour seat in the or-
der listed above is recommended.
Check that the ignition is switched on.
All lamps in the instrument cluster light
up.The seat cushion movement, backrest
cushion height and curvature can be con-
tinuously varied with regulators1, 2 and3.
The side bolsters of the backrest can be
adjusted with rocker switch4.
Press to the left.
Side support will be increased.
Press to the right.
Side support will be decreased.iWhen the engine is turned off, the last
cushion setting is retained in memory,
and the cushion is automatically ad-
justed to this setting when the engine
is restarted.
Page 97 of 376
97 Controls in detail
Seats
Heated seats*
Both switches for the front seats are locat-
ed in the center console.
1Normal heating
2Rapid heating
Make sure that the ignition is switched
on.
All the lamps in the instrument cluster
light up.
Switching on seat heating
Press upper switch position1.A red indicator lamp on the switch
lights up.
Switching on rapid seat heating
Press lower switch position2.
Both red indicator lamps on the switch
light up.Switching off seat heating
If one indicator lamp is on, press upper
switch position1.
If both indicator lamps are on, press
lower switch position2.
!If one or both of the lamps on the seat
heater switch are blinking, there is in-
sufficient voltage available since too
many electrical consumers are turned
on. The seat heater switches off auto-
matically.
The seat heater will switch back on
again automatically as soon as suffi-
cient voltage is available.iThe system switches over to normal
heating mode after approximately five
minutes. Only one indicator lamp re-
mains lit.
iThe seat heater will be automatically
switched off after approximately
30 minutes.
Page 99 of 376
99 Controls in detail
Memory function*
The memory button and stored position
button are located on the door.
1Memory button
2Stored position button
Make sure that the ignition is switched
on or the relevant door is open and the
SmartKey is inserted in the starter
switch.
Storing positions into memory
Adjust the seats, steering wheel and
rear view mirrors to the desired posi-
tion (
page 32).
Turn button2 to selected memory po-
sition.
Press memory button1.
Release memory button and push
button2 within three seconds.
All the settings are stored at the select-
ed position.
Recalling positions from memory
Turn button2 to selected memory po-
sition.
Press and hold button2 until the seat,
steering wheel and rear view mirrors
have fully moved to the stored posi-
tions.iReleasing the button immediately
stops movement to the stored posi-
tions.Warning!
G
Do not operate the power seats using the
memory button if the seat backrest is in an
excessively reclined position. Doing so
could cause damage to front or rear seats.
First move backrest to an upright position.
Page 131 of 376
131 Controls in detail
Control system
Setting key dependency
Use this function to set whether the
memory settings for the seats, the steering
wheel and the mirrors should be stored
separately for each key (
page 84).
Move the selection marker with
the
æ
or
ç
button to the
CONVENIENCE
submenu.
Press button
j
or
k
repeatedly
until you see this message in the
display:
SETTINGS KEY-DEPENDENT
.
The selection marker is on the current
setting.
Press
æ
or
ç
to set key
dependency to
ON or
OFF
. Setting parking position for exterior rear
view mirror
Use the
MIRROR SETTING WHEN PARKING
function to select whether the passen-
ger-side exterior rear view mirror should be
turned downward during parking maneu-
vers, when reverse gear is engaged.
For additional information, see “Activating
exterior rear view mirror parking position”
(
page 145).l
Move the selection marker with
the
æ
or
ç
button to the
CONVENIENCE
submenu.
Press button
j
or
k
repeatedly
until you see this message in the
display:
MIRROR SETTING WHEN
PARKING.The selection marker is on the current
setting.
Press
æ
or
ç
to switch function
ON or
OFF
.
Page 149 of 376
149 Controls in detail
Climate control
Climate control panel
The storage compartment between the
front seats can be ventilated (
page 155).
Information about “Rear passenger com-
partment adjustable air vents”
(
page 155).
Item
1
Air volume control for left center air
vent
2
Left center air vent, adjustable
3
Right center air vent, adjustable
4
Air volume control for right center
air vent
5
Air volume control for side air vent
6
Side air vent, adjustable
7
Side defroster vent, fixed
8
Climate control paneliFor draft-free ventilation, move the slid-
ers for the center air vents to the mid-
dle position.
Item
1
Air volume control
2
Left-side temperature control
3
Right-side temperature control
4
Air distribution control switch
5
Rear window defroster
6
AC cooling on/off (AC
OFF
)
7
Air distribution and air volume
(automatic)
8
Air recirculation
9
Defrosting
Page 253 of 376
253 Operation
Vehicle care
Leather upholstery
Using aftermarket seat covers or wearing
clothing that have the tendency to give off
coloring (e.g. when wet etc.) may cause
the upholstery to become permanently dis-
colored. By lining the seats with a proper
intermediate cover, contact-discoloration
will be prevented.
Wipe leather upholstery with a damp cloth
and dry thoroughly or clean with
Mercedes-Benz approved Leather Care.
Exercise particular care when cleaning per-
forated leather as its underside should not
become wet.MB Tex upholstery
Pour Mercedes-Benz approved Interior
Care onto soft lint-free cloth and apply
with light pressure.
Page 341 of 376
341 Technical terms
ABS
(A
ntilock B
rake S
ystem)
Prevents the wheels from locking up
during braking so that the vehicle can
continue to be steered.
Alignment bolt
Metal pin with thread. The centering
pin is an aid used when changing a tire
to align the wheel with the wheel hub.
BabySmart
TM
airbag deactivation
system
This system detects if a special system
compatible child restraint seat is in-
stalled on the front passenger seat. The
system will automatically deactivate
the passenger front airbag when such a
seat is properly installed (indicator
lamp
7
located in the center con-
sole lights up). See your authorized
Mercedes-Benz Center for availability. BabySmart
TM
compatible child seats
Special restraint system for children.
The sensor system for the passenger
seat prevents deployment of the pas-
senger side airbag if a BabySmart
TM
compatible child seat is installed.
BAS
(B
rake A
ssist S
ystem)
System for potentially reducing braking
distances in emergency braking situa-
tions. The system is activated when it
senses an emergency based on how
fast the brake is applied.
Bi-Xenon headlamps*
Headlamps which use an electric arc as
the light source and produce a more
intense light than filament headlamps.
Bi-Xenon headlamps produce low
beam and high beam.CAC
(C
ustomer A
ssistance C
enter)
Mercedes-Benz customer service cen-
ter, which can help you with any ques-
tions about your vehicle and provide
assistance in the event of a break-
down.
CAN system
(C
ontroller A
rea N
etwork)
Data bus network serving to control
vehicle functions such as door locking
or windshield wiping.
Cockpit
All instruments, switches, buttons and
indicator/warning lamps in the passen-
ger compartment needed for vehicle
operation and monitoring.
Page 347 of 376
347 Index
A
ABS 23, 73, 341
ABS control 74
Malfunction indicator lamp 257
Messages in display 262
Warning lamp 257
Accelerator position, automatic
transmission 143
Accident
In case of 50
Activating
Air conditioning (cooling) 154, 163
Air recirculation mode 152, 160
Anti-theft alarm system 79
Automatic climate control* 157
Central locking (control system) 129
Charcoal filter 161
Climate control 149
Climate control system 153
Defrosting 151
Easy-entry/exit feature* 129
ESP 77
Exterior headlamps 47
Exterior lamps 102
Exterior rear view mirror
parking position* 145Hazard warning flasher 104
Headlamps 47
High beams 104
Ignition 31
Immobilizer 53, 79
Rear fog lamp 102
Rear window defroster 153, 162
Residual heat 163
Seat heater* 97
Tow-away alarm 80
Windshield wipers 48
Adding
Coolant 239
Engine oil 237
Additional turn signals 290
Adjustable air vents, rear passenger
compartment 155, 164
Adjusting 32
Air distribution 151, 159
Air volume 151, 159
Backrest tilt 33, 35
Exterior rear view mirror 39
Head restraint height 33, 35, 37
Head restraint tilt 34, 35, 36
Head restraints 36
Inside rear view mirror 39Instrument cluster illumination 107
Manual seat 33
Mirrors 39
Multicontour seat* 96
Power seat* 34
Rear seat head restraints 35
Seat belt height 43
Seat cushion depth 96
Seat cushion tilt 33, 35
Seat fore and aft adjustment 33, 34
Seat height 33, 35
Seats 32, 33
Steering column height 37, 38
Steering column length 37, 38
Steering wheel 37
Air conditioner (cooling)
Turning off 154, 163
Turning on 154, 163
Air conditioning refrigerant 332
Air distribution
Adjusting 151, 159
Air pressure
see Tire inflation pressure 243
Air recirculation mode 152, 160
Activating 152, 160
Deactivating 152, 161