remote start MERCEDES-BENZ C55AMG 2005 W203 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2005, Model line: C55AMG, Model: MERCEDES-BENZ C55AMG 2005 W203Pages: 442, PDF Size: 4.62 MB
Page 25 of 442
23 At a glance
Cockpit
Item
Page
1
Steering wheel gearshift
control (C 55 AMG only)
164
2
Cruise control lever
231
3
Multifunction steering
wheel
26,
122
4
Horn
5
Instrument cluster
24,
117
6
Lever for voice control
system*
1, see separate
operating instructions
1Feature description is based on preliminary infor-
mation at time of printing. At time of printing, no
date for availability of voice control had been set.
Contact an authorized Mercedes-Benz Center for
details and availability for your vehicle model.7
Overhead control panel
29
Item
Page
8
Glove box lid release
241
9
Glove box lock
241
a
Center console
27
b
Starter switch
33
c
Hood lock release
278
d
Steering wheel adjustment
handle (manual)
40
e
Steering wheel adjustment
stalk (electrical)*
40
f
Parking brake pedal
48, 54
g
Remote trunk lid switch
93
Item
Page
h
Door control panel
30
j
Parking brake release
48
k
Combination switch
Turn signals
50
Windshield wipers
51
High beam
50
l
Exterior lamp switch
49,
109
m
Exterior rear view mirror
adjustment
41,
108
n
Headlamp washer switch*
168
Page 34 of 442
32 Getting startedThe “Getting started” section provides an
overview of the vehicle’s most basic func-
tions. First-time Mercedes-Benz owners
should pay special attention to the infor-
mation given here.
If you are already familiar with the basic
functions described here, the “Controls in
detail” section will provide you with further
information. The corresponding page
references are located at the end of each
segment.Unlocking
Unlocking with the SmartKeySmartKey with remote control 1‹Lock button
2ŠOpening button for the trunk lid
3ŒUnlock button
4ÂPanic button* (
page 76)
Press unlock buttonŒ on the
SmartKey.
All turn signal lamps flash once. The
locking knobs in the doors move up.
Get in the vehicle and insert the
SmartKey in the starter switch.
For more information, see “Locking and
unlocking” (
page 88).
iCanada only:
Only vehicles equipped with an
anti-theft alarm system* have
SmartKeys with integrated panic
button*4.
Page 90 of 442
88 Controls in detailIn the “Controls in detail” section you will
find detailed information on how to oper-
ate the equipment installed on your vehi-
cle. If you are already familiar with the
basic functions of your vehicle, this section
will be of particular interest to you.
To quickly familiarize yourself with the ba-
sic functions of the vehicle, refer to the
“Getting started” section of this manual.
The corresponding page numbers are giv-
en at the beginning of each segment.Locking and unlocking
For more information on locking and
unlocking, see “Getting started”
(page 32) and (
page 54).
SmartKey
Your vehicle comes supplied with two
SmartKeys, each with remote control and
a removable mechanical key.
The locking tabs for the mechanical key
portion of the two SmartKeys are a
different color to help distinguish each
SmartKey unit.
The SmartKey provides an extended oper-
ating range. To prevent theft, however, it is
advisable to only unlock the vehicle when
you are in close proximity to it.
The SmartKey centrally locks and unlocks:
the doors
the trunk
the fuel filler flap
SmartKey with remote control1‹ Lock button
2Š Opening button for the trunk lid
3Mechanical key locking tab
4Œ Unlock button
5Battery check lamp
6Â Panic button* (
page 76).
iCanada only:
Only vehicles equipped with an
anti-theft alarm system* have
SmartKeys with integrated panic
button6.
Page 260 of 442
258 Controls in detailUseful featuresProgramming or reprogramming the
integrated remote control
Step 1:
Switch on ignition (
page 33).
Step 2:
If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise, press
and hold the two outer signal transmit-
ter buttons2 and4 and release
them only when the indicator lamp1
begins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and/or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3.Step 3:
Hold the end of the hand-held remote
control transmitter6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control
located on the interior rear view mirror,
keeping the indicator lamp1 in view.
Step 4:
Using both hands, simultaneously
press the hand-held transmitter
button5 and the desired integrated
signal transmitter button (2, 3
or4). Do not release the buttons until
completing step 5.
The indicator lamp1 on the
integrated remote control will flash,
first slowly and then rapidly.Step 5:
When the indicator lamp1 flashes
rapidly, release both buttons.
Step 6:
Press and hold the just-trained
integrated signal transmitter button
and observe the indicator lamp1.
If the indicator lamp1 stays on
constantly, programming is complete
and your device should activate when
the integrated signal transmitter
button is pressed and released.iThe indicator lamp1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after
20 seconds.
Page 262 of 442
260 Controls in detailUseful featuresStep 12:
Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3
or4).
Step 13:
To program the remaining two buttons,
repeat the steps above starting with
step 3.Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:Step 4:
Continue to press and hold the
integrated signal transmitter button
(2, 3 or4) while you press and
re-press (“cycle”) your hand-held
remote control transmitter6 every
two seconds until the frequency signal
has been learned. Upon successful
training, the indicator lamp1 will
flash slowly and then rapidly after
several seconds.
Proceed with programming step 5 and
step 6 to complete.
Page 263 of 442
261 Controls in detail
Useful features
Operation of integrated remote control
Switch on ignition (
page 33).
Select and press the appropriate
integrated signal transmitter button
(2, 3 or4) to activate the remote
controlled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.Erasing the integrated remote control
memory
Switch on ignition (
page 33).
Simultaneously hold down the signal
transmitter buttons2 and 4, for
approximately 20 seconds, until the
indicator lamp1 flashes rapidly. Do
not hold for longer than 30 seconds.
The codes of all three channels are
erased.Reprogramming a single integrated
signal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Press and hold the desired signal
transmitter button (2, 3 or4).
Do not release the button.
The indicator lamp will begin to flash
after 20 seconds. Without releasing
the integrated signal transmitter
button, proceed with programming
starting with step 3.
iIf you sell your vehicle, erase the codes
of all three channels.
Page 416 of 442
414 Index
Releasing trunk lid from inside 95
Remote door unlock 255
Unlocking the vehicle 337
Emergency Tensioning Device see ETD
Emission control 273
Emission control information label 376
Ending
A call (telephone*) 152
Engine
Compartment 278
Starting with automatic
transmission* 47
Starting with manual
transmission 46
Starting with the SmartKey,
automatic transmission* 47
Starting with the SmartKey,
manual transmission 46
Technical data 378
Turning off with the SmartKey 56
Engine cleaning 297Engine compartment 278
Fuse box in 370
Hood 278
Engine malfunction
indicator lamp 25, 304
Engine number 376, 400
Engine oil 279
Adding 281
Additives 390
Checking level 277, 280
Consumption 279
Display messages 280, 320–321
Filler neck,
C 230 Kompressor
(all models) 282
Filler neck,
C 240 (all models),
C 320 (all models),
C 55 AMG 282
Messages in display 280, 320–321
Viscosity 400Engine oil level
Checking 277, 280
Engine oils 390
ESP 79, 400
Four wheel electronic traction
system with ESP 82
Messages in display 312–313
Switching off 80
Switching on 81
Warning lamp 25, 306
ETD 67, 400
Safety guidelines 62
Ethanol fuel
At the gas station 275
Requirements 392
Switching fuels 393
Exterior lamp switch 49, 109
Exterior lamps
Delayed shut-off 143
Exterior rear view mirrors
Adjusting 41
Parking position* for 148
Page 421 of 442
419 Index
Key, SmartKey
Battery check lamp 89
Checking the batteries 91
Factory setting 89
Global locking 89
Global unlocking 89
Loss of 91
Messages in display 322
Positions in starter switch 33
Remote control 88
Restoring to factory setting 90
Selective setting 89
Starting the engine,
automatic transmission* 47
Starting the engine,
manual transmission 46
Turning off the engine 56
Unlocking the trunk lid 91
Unlocking with 32
Kickdown 163, 401
Kilometers/miles in speedometer 135
Km/h or mph in speedometer 135L
Labels, identification 376
Lamp bulbs, exterior 344
Lamp sensor
Message in display 324
Lamps, exterior
Front 345
Light sensor 324
Messages in display 323–326
Rear 345
Lamps, indicator and warning
ABS 25, 302
Battery (SmartKey) 89
Brakes 25, 303
Engine diagnostics 304, 307
Engine malfunction 25, 304–305
ESP 25, 306
Front fog lamps 109
Front passenger
front air bag off 27, 63, 70, 308
Fuel reserve 25, 307
High beam headlamps 25Instrument cluster 302–307
Low beam headlamps 25
Maintenance service indicator 292
Rear fog lamp 109
Seat belt telltale 25, 307
SRS 25, 59, 307
Turn signals 25
Language
Multifunction display 136
Setting 136
LATCH-type child seat anchors 73
Folding back 74
Layout of poly-V-belt drive 377
Leather upholstery
Cleaning 299
Lever for voice control system* 23
License plate lamps
Messages in display 324
Replacing bulbs 345
Light alloy wheels
Cleaning 298
Technical data 381, 382