phone MERCEDES-BENZ CL-Class 2004 C215 Comand Manual

23 At a glance
Quick reference COMAND
Switching on
Turn the key in the steering column
lock to position 1 or 2.
or

Press e.
In both cases, the system will activate
the operating mode which was active
when the system was switched off.Switching off

Turn the key in the steering column
lock to position 0 and pull the key out.
or

Press e.
The volume is adjusted jointly for the
telephone*, the navigation system and the
Voice control system.
The volume setting applies to other
operating modes as well: radio, tape, CD,
CD changer*, MP3-CD and DVD.
When you adjust the volume, the system
will automatically store the setting for the
current operating mode. The volume for
the navigation announcements can only be
changed while an announcement is being
made.
iYou have the following options to
control the system:
at the COMAND

at the multifunction steering wheel
(refer to vehicle Operator's Manual)

using the Voice control system*
(refer to separate operating
instructions for further information)
This Operator’s Manual describes the
control at the COMAND.
Unless otherwise indicated, the
descriptions and illustrations refer to
the COMAND.
Switching the COMAND control unit
on and offiIf the key is not in the steering lock in
position 1 or 2, the system will
automatically stop after around 30
minutes. A warning is displayed prior to
the system switching off.
Volume

Quick reference COMAND

25 At a glance
Quick reference COMAND
Common balance and fader settings apply
to the following sytems:
Radio operation

Tape operation

CD operation (single CD)

CD changer* operation

MP3-CD operation

DVD operation
Different balance and fader settings can be
set for navigation and telephone*.The balance/fader settings for navigation
announcements are described at “Audio
settings for the navigation
announcements” (
page 117).
When you make balance or fader settings,
the system will automatically save the
settings for the current operating mode
and others.
Setting balance and fader
In radio, tape, CD, CDC*, MP3-CD or DVD
operation:

Press the
Bal/Fad
soft key.
Cross-hairs are displayed. The
horizontal line indicates the balance
setting. The vertical line indicates the
fader setting. You can now make
balance and fader settings.
Balance and fader

40 AudioTape operation
Do not expose the tapes to direct
sunlight or high temperatures.

Do not leave tapes near magnetic fields
or magnets.

Ensure that the tape is adequately
tightened before you insert it into the
tape slot.

Do not touch the tape with your fingers.

Do not insert a tape if its label is not
stuck on properly.

Press A.
The Audio menu will appear
(page 30).

Press the
Tape
soft key.
The Tape main menu will appear.
Tape main menu
E.g.:
Tape
= Tape operation switched on

Side 1
= Side display
Tape inserted:
Tape operation begins with the track
last played.
No tape inserted:
The message
No tape
will appear.

Insert a cassette (
page 41).
In the case of a device or tape error:
The message
Tape error
will appear.
Notes on tape careWarning
G
In order to avoid distraction which could
lead to an accident, the driver should insert
tapes with the vehicle at a standstill and
operate the audio system only if permitted
by road, weather and traffic conditions.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your car covers a
distance of 50 feet (approximately 14 m)
every second.
Switching tape operation on
iThe
Sound
soft key will appear if the
COMAND is provided with sound
functions* (page 27).
iThe telephone and navigation functions
can be used while a tape is playing.

Tape operation

79 Satellite radio*
Important notes

Press B to switch to satellite radio
operation.
The Satellite radio main menu will ap-
pear and displays the “PREVIEW” chan-
nel.

Press the
SIRIUS
soft key.
The Service information display will ap-
pear if the satellite radio function has
not yet been subscribed to.
The message
No Satellite Radio

will appear in a window.
1Phone number of the provider,
(SIRIUS) or “Call Service Provider”
2The Electronical Serial Number (ESN)
of your SAT tuner

Contact satellite radio service provider
at the telephone number displayed in
the screen.
After the connection is made:

Follow the instructions given by the
operator.
The activation process may take up to
10 minutes. If it is successful, you will
see the display with the message
“Acquiring Signal...” (
page 80) follo-
wed by the Satellite radio main menu
(
page 80).
Subscribing to satellite radio
iCredit card information may be re-
quired for your application.
The activation process takes up to ap-
proximately 10 minutes.

85 Satellite radio*
Satellite radio operation
You can call the provider service center for
questions or releases, whenever you need.
Press the
SIRIUS
soft key.
The Service information display will ap-
pear.
1Phone number of the provider,
(SIRIUS) or “Call Service Provider”
2The Electronical Serial Number (ESN)
of your SAT tuner

Press the
Back
soft key to switch back
to the Satellite radio main menu.
Refer to chapter “At a glance” on how to
adjust sound settings.
You can set

the sound Bass/Treble individually

the sound-center (Fader and Balance)

select predefined sound optimization
Displaying service information
Sound settings

87
Important notes
Telephone operation
Telephone*

88 Telephone*Important notesIn chapter “Telephone”, you will find de-
tailed information regarding the telepho-
ne*, including emergency call.
1 Observe all legal requirementsWarning
G
Some jurisdictions prohibit the driver from
using a cellular telephone while driving a ve-
hicle. Whether or not prohibited by law, for
safety reasons, the driver should not use the
cellular telephone while the vehicle is in mo-
tion. Stop the vehicle in a safe location be-
fore answering or placing a call.
If you nonetheless choose to use the cellular
phone while driving, please use the hands-
free device and be sure to pay attention to
the traffic situation at all times. Use the cel-
lular phone
1 only when road, weather and
traffic conditions permit.
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e.
without being connected to an external an-
tenna) from inside the vehicle while the en-
gine is running. Doing so could lead to
malfunction of the vehicle’s electronic sys-
tems, possibly resulting in an accident and
personal injury.
!Radio transmitters, such as a portable
telephone or a citizens band unit
should only be used inside the vehicle
if they are connected to a separate ex-
terior antenna that has been approved
by Mercedes-Benz.

Important notes

89 Telephone*
Important notes
iIf you have a Mercedes-Benz specified
integrated mobile telephone (TDMA/
CDMA or GSM) and the telephone is
inserted in the cradle, the telephone
functions can be used as follows: 
at the COMAND

at the multifunction steering wheel

with the Voice control system*
This instruction manual describes the
operation at the COMAND. Unless
otherwise indicated, the descriptions
and illustrations refer to the COMAND.
Operation at the mobile phone and
operation with the Voice control
system* are described in separate
operating guides. Refer to the vehicle
Operator's Manual for operation of the
telephone using the multifunction
steering wheel.
iIn certain menus, the COMAND can
display date and time of the calls.
The COMAND can display phone
number and name of the other party
(e.g. if the COMAND detects an
incoming call, but also in other menus).
For the number to be displayed, the
number information must be
transmitted with the incoming call. The
same goes for the name display which
additionally requires that the caller’s
number and name are saved in the
phone book.

90 Telephone*Important notes
Please read the chapter “Telephone”
first before attempting to operate your
telephone.

Please also read the important notes in
the telephone and Voice control sys-
tem* operating manuals.

Always drive with extreme caution
when you operate the telephone
hands-free.

For safety reasons, you should not use
the mobile telephone handset to make
a call while driving the vehicle.
If the signal strength is very weak (dis-
play in the symbol bar of all menus):
Wait until reception improves before
making a call.

Close the windows and reduce all out-
side noise as much as possible when
you use hands-free operation.

Also make sure that the air vents are
not pointed in the direction of the
microphones located in the overhead
control panel near the rear view mirror.
Adjust air vents and/or reduce blower
speed if necessary.

A brief disconnection from the cellular
network is not a malfunction, as this
can occur when the network switches
areas. The phone will automatically try
to sign on to a network again.

If the message
Enter Lock Code
for Cell
appears, enter the unlock
code to enable all telephone functions
(
page 92). If you do not do so, only
the emergency call (911) is available.
GSM mobile phone

If the message
Enter PIN:
on the
mobile phone appears, enter the PIN-
code to enable the telephone functions
(
page 92). If you do not do so, only
the emergency (911) call is available on
the mobile phone.In the following situations, it is not possible
or not yet possible to use the telephone:

The telephone is already unlocked but
is not or not yet registered in the net-
work.
The message
no Serv.
appears in the
status bar. The telephone will try to re-
gister into an existing network. If the
network is available, the telephone will
be ready for use.
The above message also appears

if the network is no longer available
due to weak signals

if you try to make a call (message Service Unavailable
appears
for 8 seconds)

91 Telephone*
Important notes

The message
Activating Telepho-
ne. Please Wait.
appears.
COMAND prepares the telephone for
use. Select other system functions, e.g.
radio, by pressing the corresponding
button or wait until the telephone is ac-
tive.

One of the two messages
Telephone

Unavailable
or
Telephone
Not
Inserted
appears.
Please connect the mobile phone.

One of the two messages
Telephone

Error
or
Telephone
Not In-
stalled
appears.
Please contact an authorized
Mercedes-Benz Center.GSM mobile phone

If the message
Check SIM Card
(Emergency Call “911” Only
Possible With Tel.)
:

Insert the SIM card into the mobile
phone (Telephone Operating
Manual).