low beam MERCEDES-BENZ CLA 2014 User Guide

Active:
Rif you are driving at speeds below 25 mph
(40 km/h) and switch on the turnsignal or
turnthe steering wheel.
Rif you are driving at speeds between
25 mph(40 km/h) and 45 mph(70 km/h)
and turn the steering wheel.
Not active:if you are driving at speeds above
25 mph (40 km/h) or switch off the turn
signal or turn the steering wheel to the
straight-ahead position.
The cornering lamp may remain lit for a short
time, but is automatically switched off after
no more than three minutes.
Extended range fog lamps
The extended range fog lamps reduce the
glare experienced by the driverand improve
the illuminationofthe edge of the road.
Active:if you are driving at speeds below
40 mph (70 km/h) and you switch on the rear
fog lamp.
Not active:if, following activation, you are
driving at speeds above 60 mph (100 km/h)
or if you switch off the rear fog lamp.
Adaptive Highbeam Assist
Important safety notes
GWARNING
Adaptive Highbeam Assist does not recognize
road users:
Rwho have no lights, e.g. pedestrians
Rwho have poor lighting, e.g. cyclists
Rwhose lighting is blocked, e.g. by a barrier
In very rare cases, Adaptive Highbeam Assist
may fail to recognize other road users that
have lights, or may recognize them too late.
In this or similar situations, the automatic
high-beam headlamps will not be deactivated
or activated regardless. There is a risk of an
accident.
Always carefully observe the traffic conditions
and switch off the high-beam headlamps in
good time.
Adaptive Highbeam Assist cannot take into
account road, weather or traffic conditions.
Adaptive Highbeam Assist is only an aid. You
are responsible for adjusting the vehicle's
lighting to the prevailing light, visibility and
traffic conditions.
In particular, the detection of obstacles can
be restricted if there is:
Rpoor visibility, e.g. due to fog, heavy rain or
snow
Rdirt on the sensors or the sensors are
obscured
General notes
You can use this function to set the
headlamps to change between low beam and
high beam automatically.The system
recognizes vehicles with their lights on, either
approaching from the opposite direction or
traveling in front of your vehicle, and
consequently switches the headlamps from
high beam to low beam.
The system automatically adapts the low-
beam headlamp range depending on the
distance to the other vehicle. Once the
108Exterior lighting
Lights and windshield wipers

system no longer detects any other vehicles,
it reactivates the high-beam headlamps.
The system's optical sensor is located behind
the windshield near the overhead control
panel.
Switching Adaptive Highbeam Assist
on/off
XTo activate:activate the Adaptive
Highbeam Assist function using the on-
board computer (Ypage 207).
XTurn the light switch to.
XPress the combination switch beyond the
pressure point in the direction of arrow
(Ypage 106).
Theindicator lamp in the
multifunction display lights up if it is dark
and the light sensor activates the low-beam
headlamps.
If you are driving at speeds above
approximately 28 mph (45 km/h):
The headlamp range is set automatically
depending on the distance between the
vehicle and other road users.
If you are driving at speeds above
approximately 35 mph (55 km/h) and no
other road users have been detected:
The high-beam headlamps are switched on
automatically. Theindicator lamp in
the instrument cluster also lights up.
If you are driving at speeds below
approximately 30 mph (45 km/h) or other
road users have been detected or the roads
are adequately lit:
The high-beam headlamps are switched off
automatically. Theindicator lamp in
the instrument cluster goes out. The
indicator lamp in the multifunction display
remains lit.
XTo deactivate:move the combination
switch back to its normal position.
Theindicator lamp in the
multifunction display goes out.
Headlamps fogged up on the inside
The headlamps may fog up on the inside if
there is high atmospheric humidity.
XSwitch on the lights and drive off.
The level of moisture diminishes,
depending on the length of the journey and
the weather conditions (humidity and
temperature).
If the level of moisture does not diminish:
XHave the headlamps checked at a qualified
specialist workshop.
Exterior lighting109
Lights and windshield wipers
Z

Halogen headlamps
Turnsignal lamp: PY 21 W
Low-beam headlamp/daytime running
lamp/parking lamp/standing lamp:
H15 55 W/15 W
"Low-beam headlamp: H7 55 W
Vehicles with IntelligentLight System
Cornering lamp: H7 55 W
Tail lamp (halogen headlamps)
Rear fog lamp: P 21 W
Brake lamp: W 16 W
"Brake lamp: W 16 W
!Turn signal lamp: PY 21 W
Backup lamp: W 16 W
Changing the front bulbs
Removing and installing thecover in the
front wheel housing
You must remove the cover from the front
wheel housing before you can change the
frontbulbs.
XTo remove:switch off the lights.
XTurn the frontwheels inwards.
XTurn rotary knobthrough 90°.
Coveris released.
XPush coverdown.
XTo install:push coverup.
XTurn rotary knobthrough 90°.
Coveris locked.
Low-beam headlamps (halogen
headlamps)
112Replacing bulbs
Lights and windshield wipers

Permanentdisplay: outside temperature
or speed (Ypage 206)
Time
XTo show menu bar!:press the
orbutton on the steering wheel.
Menu bar!disappears after a few seconds.
Text field"shows the selected menu or
submenu as well as display messages.
iYou can set the time using the audio
system or COMAND; see the separate
operating instructions.
The following messages may appear in the
multifunction display:
 Active Parking Assist (Ypage 178)
CRUISECruise control (Ypage 162)
Adaptive Highbeam Assist
(Ypage 108)
HOLD function (Ypage 172)
Menus and submenus
Menu overview
Operating the on-board computer
(Ypage 195).
Depending on the equipmentinstalled in the
vehicle, you can call up the following menus:
RTripmenu (Ypage 197)
RNavimenu (navigation instructions)
(Ypage 199)
RAudiomenu (Ypage 200)
RTel(telephone) menu (Ypage 201)
RDriveAssist(Assistance) menu
(Ypage 202)
RServicemenu (Ypage 205)
RSettingsmenu (Ypage 205)
RAMGmenu in AMG vehicles (Ypage 209)
TheAudio,NaviandTelmenus differslightly
in vehicles with Audio 20 and in vehicles with
COMAND.The examples given in this
Operator's Manual apply to vehicles
equipped with COMAND.
Trip menu
Standard display
XPress and hold thebutton on the
steering wheel until theTripmenu with
trip odometerand odometeris
shown.
Trip computer "From Start" or "From
Reset"
Example: trip computer "From Start"
Distance
Time
"Average speed
!Average fuel consumption
XPress theorbutton on the
steering wheel to select theTripmenu.
XPress theorbutton to select
From StartorFrom Reset.
The values in theFrom Startsubmenu are
calculated from the start of a journey, while
the values in theFrom Resetsubmenu are
calculated from the last time the submenu
was reset (Ypage 198).
TheFrom Starttrip computer is
automatically reset when:
Rthe ignition has been switched off for more
than four hours.
R999 hours have been exceeded.
R9,999 miles have been exceeded.
Menus and submenus197
On-board computer and displays
Z

thesymbol in the multifunction
display are shown in orange.
XPress thebutton to save the setting.
Further information on daytime running
lamps (Ypage 105).
Switching Adaptive HighbeamAssist on/
off
This function is only available on vehicles with
the Intelligent Light System.
XPress theorbutton on the
steering wheel to select theSettings
menu.
XPress theorbutton to select the
Lightssubmenu.
XPressto confirm.
XPress theorbutton to select the
Adaptive Highbeamfunction.
If theAdaptive Highbeamfunction has
been switched on, the cone of light and the
symbol in the multifunction display
are shown in orange.
XPress thebutton to save the setting.
For further information about Adaptive
Highbeam Assist, see (Ypage 108).
Setting the brightness of the ambient
lighting
XPress theorbutton on the
steering wheel to select theSettings
menu.
XPress theorbutton to select the
Lightssubmenu.
XPressto confirm.
XPress theorbutton to select the
Amb. Light +/-function.
You will see the selected setting.
XPressto confirm.
XPress theorbutton to adjust the
brightness to any level fromDisabled
toLevel 5(bright).
XPress theorbutton to save the
setting.
Activating/deactivating surround
lighting and exterior lighting delayed
switch-off
If you have activated theSurround
Lightingfunction and the light switch is set
to, the following functions are activated
when it is dark:
Rsurround lighting:the exterior lighting
remains lit for 40 seconds after unlocking
with the key. If you start the engine, the
surround lighting is switched off and
automatic headlamp mode is activated
(Ypage 105).
Rexterior lighting delayed switch-off:the
exterior lighting remains lit for
60 seconds after the engine is switched off.
If you close all the doors and the trunklid,
the exterior lighting goes off after
15 seconds.
XPress theorbutton on the
steering wheel to selecttheSettings
menu.
XPress theorbutton to select the
Lightssubmenu.
XPressto confirm.
XPress theorbutton to select the
Surround Lightingfunction.
When theSurround Lightingfunction is
activated, the light cone and the area
around the vehicle are displayed in orange
in the multifunction display.
XPress thebutton to save the setting.
Deactivating delayed switch-off of the
exterior lighting temporarily:
XBefore leaving the vehicle, turn the
SmartKey to position0in the ignition lock.
XTurn the SmartKey to position2in the
ignition lock.
The exterior lighting delayed switch-off is
deactivated.
Delayed switch-off of the exterior lighting is
reactivated the next time you start the
engine.
Menus and submenus207
On-board computer and displays
Z

iDepending on your vehicle'sequipment,
when the surround lighting and delayed
switch-offexterior lighting are on, the
following light up:
RParking lamps
RFront fog lamps
RLow-beam headlamps
RDaytime running lamps
RSide marker lamps
RSurround lighting in the exterior mirrors
Activating/deactivating the interior
lighting delayedswitch-off
If you activate theInterior Lighting
Delayfunction, the interior lighting remains
on for 20 seconds after you remove the key
from the ignition lock.
XPress theorbutton on the
steering wheel to select theSettings
menu.
XPress theorbuttonto select the
Lightssubmenu.
XPressto confirm.
XPress theorbutton to select the
Interior Lighting Delayfunction.
If theInteriorLightingDelayfunction
has been switched on, the vehicle interior
is displayed in orange in the multifunction
display.
XPress thebutton to save the setting.
Vehicle
Activating/deactivating the automatic
door locking mechanism
XPress theorbutton on the
steering wheel to select theSettings
menu.
XPress theorbutton to select the
Vehiclesubmenu.
XPressto confirm.
XPress theorbutton to select the
Automatic Door Lockfunction.
When theAutomaticDoorLockfunction
is activated, the vehicle doors are displayed
in orange in the multifunction display.
XPress thebutton to save the setting.
If you activate theAutomatic Door Lock
function, the vehicle is centrally locked above
a speed of around 9 mph (15 km/h).
For further information on the automatic
locking feature, see (Ypage 79).
Activating/deactivating the acoustic
locking verification signal
If you switch on theAcousticLockfunction,
an acoustic signal sounds when you lock the
vehicle.
XPress theorbutton on the
steering wheel to select theSettings
menu.
XPress theorbutton to select the
Vehiclesubmenu.
XPressto confirm.
XPress theorbutton to select the
Acoustic Lockfunction.
If theAcousticLockfunction is activated,
the\nsymbol in the multifunction
display lights up orange.
XPress thebutton to save the setting.
Activating/deactivating the radar sensor
system
XPress theorbutton on the
steering wheel to select theSettmenu.
XPress theorbutton to select the
Vehiclesubmenu.
XPressto confirm.
XPress theorbutton to select
Radar Sensor (See Oper. Manual).
You will see the selected setting:Onor
Off.
XPress thebutton to save the setting.
208Menus and submenus
On-board computer and displays

Display messagesPossible causes/consequences and
Solutions
XWait foraperiod of at least 60 seconds until the necessary
system checks have been completed.
XMake sure that the display messages do not appear in the
multifunction display.
If these conditions are fulfilled, the front-passenger seat can be
occupied again. Whether the PASSENGER AIR BAG OFF indicator
lamp remains lit or goes out depends on how OCS classifies the
occupant.
If the conditions are not fulfilled, the system is not operating
correctly.
XVisit a qualified specialist workshop immediately.
For further information about the Occupant Classification System,
see (Ypage 45).
Lights
iDisplay messages about LEDs:
This display message will only appear if all LEDs have failed.
Display messagesPossible causes/consequences and
Solutions

Check Left
Cornering Lightor
Check Right
Cornering Light
The left or right-hand cornering light is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

Check Left Low
BeamorCheck
Right Low Beam
The left or right-hand low-beam headlamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

Check Rear Left
Turn Signalor
Check Rear Right
Turn Signal
The rear left-hand or rear right-hand turn signal is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.
Display messages223
On-board computer and displays
Z