bonnet MERCEDES-BENZ E-CLASS CABRIOLET 2010 Owner's Manual

as when con
necting the do norb atter yin
the jump-starting procedure
(Y page 289). Reconnecting th
ebattery
! Always connect the battery in the order
described below. Never swap the terminal
clamps. Yo umay otherwise damage the
vehicle elect ronics.
X Switch off all ele ctrical consumers, e.g.
radio, blower, etc.
X Connect the positiv eterminal clamp and
secur ethe cov er.
X Connect th enegative termina lclamp.
X Put th efilter box back in place, then clip in
and close th eretaining clamps.
X Close th ebonnet.
i If th epower supply has been interrupted,
e.g .ift he battery has been reconnected,
you must carry out the followin gtasks:
R set the clock (Y page 205)
R reset the function for folding the exterior
mirrors in/out automatically by folding
the mirrors out once (Y page 102)288
BatteryBreakdown assistance
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa
Version:3.0.2.11
2010-01-26T13:03:22+01:00
-Seite 288

Jum
p-starting G
Risk of injury
There is arisk of acid burns when jump-starting avehicle due to the gases which escape from
the battery. Do not lean over the batter ywhile the engin eisbeing jump-started. G
Risk of explosion
Gases escapin gfrom th ebattery during jump-starting may cause minor explosions. Avoid cre-
ating sparks. Keep naked flames away from the battery, and do not smoke.
Comply with safety precautions when handling batteries. You will find these under "Battery" in
the index.
! Avoid repeated and lengthy startin gattempts. Otherwise, non-combuste dfuel may dam-
age the catalytic converter 41
and create arisk of fire.
Do not use arapid-charging device to start the engine.
Make sure the jump leads are not damaged.
Make sure the jump leads are not touching any other metal objects when they are connected
to the battery.
If your vehicle's battery is discharged ,the engin ecan be jump-started from another vehicle
or from asecond batter yusing jum pleads.
Observ ethe followin gpoints:
X The battery is not accessible in all vehicles. If the other vehicle' sbattery is not accessible,
jump-start the vehicle using asecond batter yorajump-star ting device.
X Only jump-start the vehicl ewhen th eengineisc old an dthe catalytic converter system has
cooled down 42
.
X Do no tstart the engine if the battery is frozen. Let the battery thaw first.
X Jump-starting may only be performed from batterie swithanominal voltage of 12 V.
X Only use jum pleads which have asufficient cross-section and insulated terminal clamps.
X Make sure that the jump leads cannot come into contact with parts, such as the pulley or
the fan. Thes eparts move when the engine is started and while it is running.
X If the battery is fully discharged ,leave the batter ythat is being used to jump-star tconnected
for afew minutes befor eattempting to start. This charges the battery alittle.
i Jump leads and further information about jump-startin gcan be obtained from any
Mercedes-Ben zService Centre.
X Make sure that the two vehicles do not touch.
X Apply the parking brak efirmly.
X Manual transmission: engage neutral.
X Automatic transmission: move the selector lever toP.
X Switch off all electrical consumer s(e.g. radio, blower, etc.).
X Open the bonnet (Y page 259).
41 Only vehicles with apetrol engine.
42 Only vehicles with apetrol engine. Jump-starting
289Breakdown assistance
BA 207ECE ÄJ 2010 /1a;1;2,e n-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00-Seite 289 Z

X
To open: pull outcover :slightly at the
bottom in the direction of arrow =.
X Pull cover :outwards in the direction of
arrow ;and remove it.
X To close: clip in cover :on the front of
the dashboard.
X Fold cover :inwards until it engages. Fuse box in th
eengine compartment
X Make sure that the windscreen wiper sare
turne doff. G
Ris
kofi njury
Make sure that the windscreen wipers are
turned off and the key is pulled out of the igni-
tion lock befor eyou open the cover of the fuse
box. Otherwise, the windscreen wiper sand
the wipe rrods abov ethe cover coul dbeset
in motion .This coul dlead to you or others
being injured by the wiper rods.
X Open the bonnet (Y page 259). X
Remov eany existing moisture from the
fuse box using adry cloth.
X Take lines ;from th eguides.
X Move aside lines ;.Route the lines behind
con nection =to do this.
X To open: open clamps :.
X Remove the fuse bo xcover forwards.
X To close: checkwhether the rubber seal is
lyin gcorrectly in the cover.
X Insert the cover at the rea rofthe fuse box
int ot he retainer.
X Fold down the cover and close clamps :.
X Secur elines ;in the guides.
! The cover must be fitted properly, other-
wise moisture or dirt could impair the func-
tion of the fuses.
X Close the bonnet (Y page 260). Fuse box in the boot
X Open the boot lid. Coupé
X
To open: turn rotarycatch :clockwise.
X Open cover ;downwards. 294
FusesBreakdown assistance
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa
Version:3.0.2.11
2010-01-26T13:03:22+01:00
-Seite 294